Biomedical subjects

A A Dantas Neto

Publications and source records attributed to A A Dantas Neto.

3 recordsLinked to original sources

PubMed2004

Evaluation and optimization of chromium removal from tannery effluent by microemulsion in the Morris extractor.

In this research a surfactant derived from a vegetable oil (coconut oil) was used to remove chromium from a tannery effluent. In the extraction process, a Morris extractor was used. Important variables used in assessing the optimization of the process included agitation speed, solvent rate and total flow rate. The experiments were conducted using a 2(3) factorial design. According to the response from the experimental design, the effects of each variable were calculated and the interactions between them determined. Response surface methodology was employed to study the effects of the studied variables. The optimum operational conditions were: agitation speed, 428 rpm; solvent rate, 0.37; total flow rate, 2.0 l h(-1). After extraction process, a re-extraction study was accomplished and the obtained results showed that chromium could be removed from the microemulsion phase by hydrochloric and sulphuric acidic solutions, what allows its reuse in the leather manufacturing process.

Algorithms↗

PubMed2003

Heavy metals extraction by microemulsions.

The objective of this study is the heavy metal extraction by microemulsion, using regional vegetable oils as surfactants. Firstly, the main parameters, which have influence in the microemulsion region, such as: nature of cosurfactant, influence of cosurfactant (C)/surfactant (S) ratio and salinity were studied, with the objective of choosing the best extraction system. The extraction/reextraction process by microemulsion consists of two stages. In the first one, the heavy metal ion present in the aqueous phase is extracted by the microemulsion. In a second step, the reextraction process occurs: the microemulsion phase, rich in metal, is acidified and the metal is recovered in a new aqueous phase, with higher concentration. The used system had the following parameters: surfactant-saponified coconut oil; cosurfactant-n-butanol; oil phase-kerosene; C/S ratio=4; salinity-2% (NaCl); temperature of 27+/-1 degrees C; water phase-aqueous solution that varied according to the heavy metal in study (Cr, Cu, Fe, Mn, Ni and Pb). A methodology of experimental planning was used (Scheffé Net) to study the behavior of the extraction in a chosen domain. The extraction was accomplished in one step and yielded extraction percentage higher than 98% for all metals. In the reextraction HCl-8M was used as reextraction agent and the influence of the pH and time were verified. This work showed the great efficiency of the microemulsion, indicating that it is possible to extract selectively the heavy metals from the aqueous phase.

Emulsions↗

PubMed2001

Removal of chromium from aqueous solutions by diatomite treated with microemulsion.

In order to evaluate the sorption of heavy metals, a crude diatomite was impregnated with a microemulsion which showed remarkable increase in chromium sorption capacity as compared to untreated diatomite. Samples with two different granulometries were investigated, both yielding practically complete adsorption. The adsorption process is pH dependent and the best results for the initial Cr (III) concentration of 1.5 g/L were obtained at pH 2.95. The effect of the concentration of the chromium synthetic solution was also investigated. The adsorption isotherms were obtained (30. 40 and 50 degrees C) and the Freundlich and Langmuir models were used to determine the adsorption capacity of the adsorbent. Following the adsorption step, a desorption process was carried out using several eluant solutions. The best results were obtained using hydrochloric acid (100%) as eluant.

Adsorption↗