PubMed Health⌕ Search

Biomedical subjects

A H Ripps

Publications and source records attributed to A H Ripps.

3 recordsLinked to original sources

Stereoscopic vision and psychomotor learning in dental students.

A testing mechanism is needed for reliably predicting students' problems in acquiring dental psychomotor skills. Students and dental educators could then be made aware of potential problems well in advance of required manual course work. Because testing for stereoscopic vision has long been a part of perceptual-motor ability screening for the U.S. Air Force, a similar stereopsis test was used to examine the role of stereopsis in dental psychomotor learning and its potential as a predictor of student performance. The Lameris TNO Test for stereoscopic vision was given as an adjunct to the Perceptual Ability (PAT/3D) portion of the Dental Admission Test. Both test results were then compared to freshman students' performance in preclinical operative dentistry. Multiple regression analyses indicated that a high degree of stereopsis was not a prerequisite for success in acquiring dental psychomotor skills.

Aptitude Tests↗

An evaluation of four light-curing units comparing soft and hard curing.

Composite resin shrinks during polymerization producing marginal gaps around composite restorations. While incremental placement of composite resin has been used to control shrinkage, this technique is time consuming. Curing lights have been developed with varying outputs and curing cycles to speed curing and reduce marginal gaps in composite restorations. This investigation measured the marginal openings of Class V resin restorations cured with four different light-curing units. High-intensity curing units provided rapid curing to composite resin increments, but the two-phase curing cycle afforded significantly better marginal integrity than the other units.

Dental Equipment↗

Explorer sharpness as related to margin evaluations.

Nine experienced operative dentistry faculty each used six different explorers of varying degrees of sharpness ranging from new to well-used to evaluate marginal acceptability on a device used to simulate gradations of vertical opening. In this study, the standard for the sharpest explorer point was determined to be 68 microns in diameter measured 40 microns from the tip. There was a positive correlation between the diameter of the explorer tip at 40 microns and the mean amount of opening that could be detected until the margin was declared unacceptable. Increased explorer dullness significantly handicapped even experienced graders when the explorer alone was used to evaluate visually inaccessible margins.

Dental Instruments↗