Biomedical subjects

A Poot

Publications and source records attributed to A Poot.

7 recordsLinked to original sources

PubMed1995

Effects of Tween 20 on the desorption of proteins from polymer surfaces.

The effects of Tween 20 on the desorption of proteins from polyethylene and polyurethane were studied, using single protein solutions of the human proteins fibrinogen (Fb), immunoglobulin G (IgG), serum albumin (HSA), high density lipoproteins (HDL), and plasma. The surfactant may partly or even completely desorb the proteins, depending on the type of polymer and protein. About 40% of adsorbed HSA and 80% of adsorbed HDL from the corresponding single protein solutions were desorbed by Tween 20 from polyethylene, whereas Tween 20 had a small effect on the desorption of adsorbed Fb and IgG under the same conditions. However, the desorption of Fb and IgG by Tween 20 was much higher in the case of a diluted plasma solution compared to a pure protein solution. These findings may be explained by the differences of the interaction strengths between polymers and the adsorbed proteins. The displacement of HSA from polyethylene by Tween 20 occurred in the first few minutes and did not increase in time. It was also observed that preadsorbed Tween 20 was able to prevent in a large extent the adsorption of HSA onto polyethylene. Thus, the effect of Tween 20 on the desorption of protein is due to either the displacement of protein or prevention of protein adsorption onto the surfaces.

Adsorption↗

PubMed1990

Detection of surface-adsorbed (lipo)proteins by means of a two-step enzyme-immunoassay: a study on the Vroman effect.

In view of reports on the involvement of high-molecular-weight (HMW) kininogen and high-density lipoprotein (HDL) in the Vroman effect, we studied the adsorption of fibrinogen, HMW kininogen, HDL and several other proteins from pooled human plasma and congenitally HMW kininogen-deficient plasma onto glass and low-density polyethylene, both as a function of the plasma concentration and the contact time. Mixtures of purified (lipo)proteins were also included in the study. Protein adsorption was determined by means of a two-step enzyme-immunoassay. Our results support the hypothesis that HMW kininogen is involved in the displacement of fibrinogen, which is almost instantly adsorbed from normal plasma onto glass. On hydrophobic polymers like polyethylene, the low amounts of adsorbed fibrinogen and HMW kininogen from plasma and concentrated plasma solutions may be due to a preferential adsorption of HDL.

Adsorption↗

PubMed1990

Platelet deposition studies on copolyether urethanes modified with poly(ethylene oxide).

Pellethane 2363 80A films and tubings were chemically modified and the effect of these modifications on platelet deposition was studied. Grafting of high molecular weight poly(ethylene oxide) and graft polymerization of methoxy poly(ethylene glycol) 400 methacrylate resulted in surfaces with a good water wettability. The increased hydrophilicity of these modified surfaces could be demonstrated by contact angle measurements. The platelet deposition was investigated with tubings in a capillary flow system, using different types of perfusates. Platelet deposition from a buffer-containing perfusate on surfaces modified with either high molecular weight poly(ethylene oxide) or methoxy poly(ethylene glycol) 400 methacrylate was almost absent and less than on Pellethane 2363 80A. Using a citrated plasma-containing perfusate the amount of deposited platelets on Pellethane 2363 80A modified with high molecular weight poly(ethylene oxide) was low and about the same as on unmodified surfaces. However, a marked reduced platelet deposition compared to unmodified Pellethane 2363 80A was found when the platelets were activated by Ca2+ ionophore. The improved blood compatibility of the modified Pellethane 2363 80A tubings obviously indicates the favourable effect of the presence of grafted PEO on the surface.

Biocompatible Materials↗

PubMed1989

The effect of vascular cell seeding on platelet deposition in an in vitro capillary perfusion model.

In view of the reported beneficial effects of cell seeding on the performance of synthetic vascular grafts, we determined the deposition of 111Indium-labelled human platelets in polyethylene capillary tubes covered with human endothelial cells (HEC) or smooth muscle cells (SMC) using an in vitro perfusion model. Platelet deposition decreased with increasing vascular cell coverage and was virtually absent when the number of adherent vascular cells of both types exceeded 50,000/cm2. Platelet deposition increased with increasing shear rate (300-900 s-1) only when surface coverage was less than 50,000 vascular cells/cm2. Deposition of Ca2+-ionophore A 23187-activated platelets in capillary tubes completely covered with SMC was significantly higher compared to capillaries covered with a similar number of HEC. When HEC-lined capillaries were treated with aspirin, only the deposition of activated platelets increased slightly, but significantly. This platelet reactivity was more evident when the endothelial lining was not confluent. These results demonstrate that, although seeding of HEC and SMC may both prevent the deposition of non-activated platelets to surfaces, non-aspirin-treated confluent HEC linings offer the best protection against deposition of activated platelets.

Aspirin↗

PubMed1989

Surface modification of copolyether-urethane catheters with poly(ethylene oxide).

Pellethane 2363 80A catheters were modified with poly(ethylene oxide) in order to improve their blood compatibility. Contact angle measurements showed that Pellethane 2363 80A surfaces had increased wettability after this modification. The results of in vitro blood compatibility tests showed that surface modification with poly(ethylene oxide) resulted in a five-fold reduction of platelet deposition. Activation of coagulation was not affected.

Biocompatible Materials↗

PubMed1988

Platelet deposition in a capillary perfusion model: quantitative and morphological aspects.

The capillary perfusion model according to Cazenave and co-workers was characterized by investigating the effects of protein precoating, perfusion time and shear rate on platelet deposition using 111Indium labelling of human platelets and scanning electron microscopy (SEM). Compared with uncoated polyethylene, platelet deposition was increased after precoating with purified human von Willebrand factor, fibrinogen or fibronectin, and decreased by preadsorbed immunoglobulin G, albumin or whole plasma. Platelet aggregates were observed on immunoglobulin G-coated polyethylene, whereas all other surfaces showed single adherent platelets. Complete platelet spreading was only observed after precoating with fibronectin. The quantitative data concerning platelet deposition were evaluated by using the convective-diffusion theory. Our results indicate the applicability of this perfusion model for the in vitro testing of biomaterials.

Adsorption↗

PubMed1980

Effect of caffeine on rat offspring from treated dams.

Pregnant Sprague-Dawley rats were given caffeine at 1.0, 0.5 and 0.25 g/kg diet during gestation and lactation. At birth, half of the pups from control and treated rats at each dose level were exchanged and cross fostered. Two litters were produced by each animal from each of the experimental groups. Caffeine at dietary concentrations of 0.5 and 0.25 g/kg throughout gestation and lactation had no significant effect on birth weight, litter size or development. There was also no effect at these doses following treatment during either gestation alone, or lactation alone. At 1.0 g/kg there was a slight reduction of birth weight, as well as a trend towards lower weight gain in litters from dams fed the test diet throughout gestation and lactation.

Animals↗