PubMed Health⌕ Search

Biomedical subjects

A Yu Rubina

Publications and source records attributed to A Yu Rubina.

8 recordsLinked to original sources
PubMed2006

Design of carbohydrate multiarrays.

Recently, microarray technology has increasingly been widely applied in glycobiology. This technology has rather evident potential advantages: unlimited number of carbohydrate ligands coated onto one small sized chip, enormously low consumption of both carbohydrate ligands and carbohydrate-binding proteins to be tested, etc. Literature data demonstrate that three approaches are used for glycoarray design. The first one is based on the physical adsorption of glycomolecules on a surface (as in a common ELISA), the second one-on covalent immobilization, and the third one-on a streptavidin-biotin system. In all of the described methods, carbohydrate ligands were placed on chips as a 2D monolayer and high sensitivity was achieved due to fluorescent detection. Notably, a tendency of stepping from model chips toward real multiarrays, where the number of carbohydrate ligands can be up to two hundred, has been observed the last 2 years, this already producing a number of interesting findings when studying carbohydrate-binding proteins. In 2005 new construction, 3D glycochip was described, where 150 mum diameter polyacrylamide gel elements serve as microreactors instead of 2D dots. As a result of the 3D placement of a ligand, two orders of magnitude increase of its density is possible, this providing principal signal improvement during fluorescent detection and increasing method sensitivity. At the same time, carbohydrate consumption is low, i.e., approximately 1 pmol per gel element. Copolymerization chemistry enables the immobilization of several glycomolecule classes to the gel, in particular, aminospacered oligosaccharides, polyacrylamide conjugates, and even 2-aminopyridine derivatives of oligosaccharides, which are widely used in the structural analysis of glycoprotein N-chains.

Carbohydrates↗
PubMed2005

Hydrogel glycan microarrays.

The technology of hydrogel microchips manufacturing, which was developed previously for covalent immobilization of DNA and proteins, was applied for the preparation of glycochips and combined glyco/protein chips. Microchips consist of hydrogel drops separated with hydrophobic surface. Spacered amino-saccharides and polyacrylamide glycoconjugates were used for immobilization. Gel elements were approximately 1 nl in volume (150 microm in diameter and 25 microm in height), and the amount of covalently immobilized saccharide in the glycoarray was 0.4-1.7 pmol per gel element. Hydrogel glycan microchips were used for quantitative assay of antibodies against blood group antigens and assay of lectins with fluorescent detection. In all cases, only specific interaction with chip-immobilized saccharides was observed, whereas the background signal was very low. The detection limit of on-chip assays was comparable to that of the standard 96-well plate assays. Mixing of reaction solution allowed us to decrease the duration of the assays significantly: 2-3 h for incubation and development steps and 10 min for washing. A method for determination of association constants for binding of compounds with chip-immobilized ligands from the kinetics of their binding is proposed. Combined microchips containing different types of biomolecules can be designed and used for simultaneous detection of different compounds.

ABO Blood-Group System↗
PubMed2005

Effect of mixing on reaction-diffusion kinetics for protein hydrogel-based microchips.

Protein hydrogel-based microchips are being developed for high-throughput evaluation of the concentrations and activities of various proteins. To shorten the time of analysis, the reaction-diffusion kinetics on gel microchips should be accelerated. Here we present the results of the experimental and theoretical analysis of the reaction-diffusion kinetics enforced by mixing with peristaltic pump. The experiments were carried out on gel-based protein microchips with immobilized antibodies under the conditions utilized for on-chip immunoassay. The dependence of fluorescence signals at saturation and corresponding saturation times on the concentrations of immobilized antibodies and antigen in solution proved to be in good agreement with theoretical predictions. It is shown that the enhancement of transport with peristaltic pump results in more than five-fold acceleration of binding kinetics. Our results suggest useful criteria for the optimal conditions for assays on gel microchips to balance high sensitivity and rapid fluorescence saturation kinetics.

Diffusion↗
PubMed2005

Quantitative immunoassay of biotoxins on hydrogel-based protein microchips.

Three-dimensional gel-based microchips with immobilized proteins were used for quantitative immunoassay of a series of plant (ricin and viscumin) and bacterial (staphylococcal enterotoxin B, tetanus and diphtheria toxins, and lethal factor of anthrax) toxins. It was shown that different types of immunoassays (direct, competitive, and sandwich type) could be carried out on gel microchips. As shown by confocal microscope studies, antigen-antibody interactions involving the formation of tertiary antibody-antigen-antibody complex occur in the whole volume of microchip gel elements. Sandwich assay on microchips with immobilized antibodies provided the highest sensitivity of detection (0.1 ng/ml for ricin). Antibodies labeled with fluorescent dyes, horseradish peroxidase conjugates, or biotinylated antibodies with subsequent treatment with labeled avidin were used as developing antibodies. The results of immunoassays were recorded using fluorescence, chemiluminescence, or matrix-assisted laser desorption ionization mass spectrometry directly from microchip gel elements. Gel microchips with immobilized capture antibodies were used to analyze the sample simultaneously for the presence of all six biotoxins with the same sensitivity as that for any single toxin.

Animals↗
PubMed2004

Hydrogel drop microchips with immobilized DNA: properties and methods for large-scale production.

Although gel-based microchips offer significant advantages over two-dimensional arrays, their use has been impeded by the lack of an efficient manufacturing procedure. Here we describe two simple, fast, and reproducible methods of fabrication of DNA gel drop microchips. In the first, copolymerization method, unsaturated groups are chemically attached to immobilized molecules, which are then mixed with gel-forming monomers. In the second, simpler polymerization-mediated immobilization method, aminated DNA without prior modification is added to a polymerization mixture. Droplets of polymerization mixtures are spotted by a robot onto glass slides and the slides are illuminated with UV light to induce copolymerization of DNA with gel-forming monomers. This results in immobilization of DNA within the whole volume of semispherical gel drops. The first method can be better controlled while the second one is less expensive, faster, and better suited to large-scale production. The microchips manufactured by both methods are similar in properties. Gel elements of the chip are porous enough to allow penetration of DNA up to 500 nucleotides long and its hybridization with immobilized oligonucleotides. As shown with confocal microscope studies, DNA is hybridized uniformly in the whole volume of gel drops. The gels are mechanically and thermally stable and withstand 20 subsequent hybridizations or 30-40 PCR cycles without decrease in hybridization signal. A method for quality control of the chips by staining with fluorescence dye is proposed. Applications of hydrogel microchips in research and clinical diagnostics are summarized.

Acrylamides↗
PubMed2003

Hydrogel-based protein microchips: manufacturing, properties, and applications.

Here a simple, reproducible, and versatile method is described for manufacturing protein and ligand chips. The photo-induced copolymerization of acrylamide-based gel monomers with different probes (oligonucleotides, DNA, proteins, and low-molecular ligands) modified by the introduction of methacrylic groups takes place in drops on a glass or silicone surface. All probes are uniformly and chemically fixed with a high yield within the whole volume of hydrogel semispherical chip elements that are chemically attached to the surface. Purified enzymes, antibodies, antigens, and other proteins, as well as complex protein mixtures such as cell lysates, were immobilized on a chip. Avidin- and oligohistidine-tagged proteins can be immobilized within biotin- and Ni-nitrilotriacetic acid-modified gel elements. Most gel-immobilized proteins maintain their biological properties for at least six months. Fluorescence and chemiluminescence microscopy were used as efficient methods for the quantitative analysis of the microchips. Direct on-chip matrix-assisted laser desorption ionization-time of flight mass spectrometry was used for the qualitative identification of interacting molecules and to analyze tryptic peptides after the digestion of proteins in individual gel elements. We also demonstrate other useful properties of protein microchips and their application to proteomics and diagnostics.

Equipment Design↗