PubMed Health⌕ Search

Biomedical subjects

Aaron W Sanders

Publications and source records attributed to Aaron W Sanders.

3 recordsLinked to original sources

Interconversion of contact and separated ion pairs in silyl- and arylthio-substituted alkyllithium reagents.

Ether-solvated contact and separated ion pairs (CIP and SIP) for two lithium reagents, tris(trimethylsilyl)methyllithium (1) and bis(3,5-bistrifluoromethylphenylthio)methyllithium (2), have been characterized and observed for the first time under conditions of slow exchange by NMR spectroscopy, and barriers to interconversion have been measured. A Saunders isotope perturbation experiment was used to support identification of the CIP and SIP species for 2.

Journal Article↗

Amine- and ether-chelated aryllithium reagents-structure and dynamics.

Chelation and aggregation in phenyllithium reagents with potential 6- and 7-ring chelating amine (2, 3) and 5-, 6-, and 7-ring chelating ether (4, 5, 6) ortho substituents have been examined utilizing variable temperature (6)Li and (13)C NMR spectroscopy, (6)Li and (15)N isotope labeling, and the effects of solvent additives. The 5- and 6-ring ether chelates (4, 5) compete well with THF, but the 6-ring amine chelate (2) barely does, and 7-ring amine chelate (3) does not. Compared to model compounds (e.g., 2-ethylphenyllithium 7), which are largely monomeric in THF, the chelated compounds all show enhanced dimerization (as measured by K = [D]/[M](2)) by factors ranging from 40 (for 6) to more than 200 000 (for 4 and 5). Chelation isomers are seen for the dimers of 5 and 6, but a chelate structure could be assigned only for 2-(2-dimethylaminoethyl)phenyllithium (2), which has an A-type structure (both amino groups chelated to the same lithium in the dimer) based on NMR coupling in the (15)N, (6)Li labeled compound. Unlike the dimer, the monomer of 2 is not detectably chelated. With the exception of 2-(methoxymethyl)phenyllithium (4), which forms an open dimer (12) and a pentacoordinate monomer (13), the lithium reagents all form monomeric nonchelated adducts with PMDTA.

Journal Article↗

The effect of HMPA on the reactivity of epoxides, aziridines, and alkyl halides with organolithium reagents.

A kinetic study of the effect of added HMPA cosolvent on the reaction of 2-lithio-1,3-dithiane (1), bis(phenylthio)methyllithium (2), and bis(3,5-bistrifluoromethylphenylthio)methyllithium (3) with methyloxirane (propylene oxide), N-tosyl-2-methylaziridine, and the several alkyl halides (BuCl, BuBr, BuI, allyl chloride) was carried out. Widely varied rate effects of HMPA on these SN2 substitutions were observed, ranging from >108 rate increases for 1 and butyl chloride to >103 rate decreases for 3 and methyloxirane. These reactions appear to go through separated ion pair intermediates, so a key effect is the ease of ion pair separation of the lithium reagent (3 > 2 > 1). Because 3 is already almost fully separated in THF, HMPA has no effect on the rate of halide substitution, but a large reduction is observed with the epoxide as substrate, a consequence of strong lithium assistance to the ring opening which is suppressed when excess HMPA is present. When ion pair separation is difficult (1), modest rate increases (104) are seen for epoxide opening, but very large increases are seen for aziridine (106) and alkyl halide reactions (108), for which lithium assistance is much less important. Reagent 2 shows more complicated behavior in reaction with the epoxide: 1-2 equiv of HMPA causes a small rate increase, while larger amounts cause a large rate decrease. Here the rate-accelerating effects of SIP formation are more nearly balanced with the rate-retarding effects of suppression of lithium catalysis.

Journal Article↗