PubMed Health⌕ Search

Biomedical subjects

Abraham Ulman

Publications and source records attributed to Abraham Ulman.

15 recordsLinked to original sources

Structure of mercaptobiphenyl monolayers on mercury.

The molecular-scale structure and phase behavior of single-component Langmuir films of 4'-methyl-4-mercaptobiphenyl (MMB) and 4'-perfluoromethyl-4-mercaptobiphenyl (FMMB) on mercury were studied using surface tensiometry, grazing incidence X-ray diffraction, and X-ray reflectivity. At low coverages, a condensed but in-plane disordered single layer of surface-parallel molecules is found for both compounds. At high coverages, both compounds exhibit in-plane-ordered phases of standing-up molecules. For MMB, the biphenyl core dominates the structure, yielding a centered-rectangular unit cell with an area A(x) of 21.8 A(2)/molecule, with molecules tilted by approximately 14 degrees from the surface normal in the nearest-neighbor direction, and a coherence length xi of >1000 A for the crystalline domains. For FMMB, the perfluoromethyl group dominates the structure, yielding a hexagonal unit cell with untilted molecules, an area A(x) of 24.2 A(2)/molecule, and a much smaller xi of approximately 110 A. The structure is discussed in comparison with self-assembled monolayers of MMB on crystalline Au(111) and similar-length alkanethiolate SAMs on Au(111) and on mercury. The differences in the structure are discussed and traced to the differences in the substrate's surface structure, and in the molecular cross section and rigidity.

Journal Article↗

Combinatorial approach to study enzyme/surface interactions.

A fast combinatorial approach to access information about the immobilization behavior and kinetics of enzymes on a variation of surfaces is presented. As a test system, Candida Antarctica Lipase B was immobilized on a self-assembled monolayer bearing a gradient of surface energy. The respective immobilization behavior was monitored by Fourier transform infrared micro-spectroscopy. In addition, the activity of the immobilized enzyme was monitored over the entire film in real time with a specially developed fluorescence activity assay embedded into a siloxane gel. It was found that the highest amount of active protein was immobilized on the hydrophilic end of the gradient surface. This effect is associated with a higher surface roughness of this area resulting in hydrophobic micro-environments in which the enzyme gets immobilized.

Combinatorial Chemistry Techniques↗

One-step synthesis of core(Cr)/shell(gamma-Fe(2)O(3)) nanoparticles.

Core(Cr)/shell(gamma-Fe(2)O(3)) nanoparticles were synthesized by mixing Fe(CO)(5) and Cr(CO)(6) in the 9:1 ratio. These particles exhibit narrow size distribution with 13.5 nm as mean diameter and uniform spherical shape. The TEM image, which is in good agreement with the synchrotron powder XRD pattern, reveals the heterogeneous nature (core/shell structure). The analysis of the pattern reveals gamma-Fe(2)O(3) structure and a metal crystal structure. Mossbauer spectra, which support the superparamagnetic behavior determined by H-M measurement, do not show any traceable amount of Fe(0). This suggests that the metal component is Cr. EELS analysis and iron mapping suggest controlled stoichiometry and also confirm a core made of Cr and a shell made of gamma-Fe(2)O(3).

Journal Article↗

Hyaluronan conformations on surfaces: effect of surface charge and hydrophobicity.

Extended, relaxed, condensed, and interacting forms of the polysaccharide hyaluronan have been observed by atomic force microscopy (AFM). The types of images obtained depend on the properties of the surfaces used. We have investigated several different surface conditions for HA imaging, including unmodified mica, mica chemically modified with two different kinds of amino-terminated silanes (3-aminopropyltriethoxysilane and N-trimethoxysilylpropyl-N,N,N-trimethylammonium chloride), and highly oriented pyrolytic graphite. We found the degree of HA molecular extension or condensation to be variable, and the number of bound chains per unit area was low, for all of the mica-based surfaces. HA was more easily imaged on graphite, a hydrophobic surface. Chains were frequently observed in high degrees of extension, maintained by favorable interaction with the surface after molecular combing. This observation suggests that the HA macromolecule interacts with graphite through hydrophobic patches along its surface. AFM studies of HA behavior on differing surfaces under well-controlled environmental conditions provides useful insight into the variety of conformations and interactions likely to be found under differing physiological conditions.

Aluminum Silicates↗

Controlling the size of magnetic nanoparticles using pluronic block copolymer surfactants.

We have successfully controlled the size of magnetic nanoparticles by adjusting the surfactant/solvent ratio. Gamma-Fe(2)O(3) nanoparticles of 5.6 and 12.7, and Fe(0) nanoparticles of 22.3 nm in diameter were prepared, all having spherical shape and uniform size as confirmed by TEM. Mössbauer spectra confirmed Fe(3+) for the 5.6 and 12.7 nm particles and Fe(3+) and Fe(0) for 22.3 nm particles, in good agreement with synchrotron XRD patterns. Both room temperature and 5 K H-M measurements show that 22.3 nm particles have much higher magnetization than their oxide counterparts, in agreement with their being Fe(0). T-M measurements show superparamagnetism for 5.6 and 12.7 nm particles and ferromagnetism for 22.3 nm particles.

Ferric Compounds↗

Mixed self-assembled monolayers of alkanethiolates on ultrasmooth gold do not exhibit contact-angle hysteresis.

We present the first study of mixed alkanethiolate SAMs on ultrasmooth gold surfaces. By eliminating surface roughness, it became possible, for the first time, to investigate wetting properties as a function of surface chemical composition. In three different surface compositions, it was found that contact-angle hysteresis apparently vanished. This suggests that surface chemical heterogeneity does not contribute to contact-angle hysteresis in mixed SAMs on ultrasmooth gold surfaces.

Journal Article↗

X-ray photoelectron spectroscopy and near-edge X-ray absorption fine structure study of water adsorption on pyridine-terminated thiolate self-assembled monolayers.

Adsorption of water on self-assembled monolayers (SAMs) of 4-(4-mercaptophenyl)pyridine on gold at low temperatures under ultrahigh vacuum conditions is studied by synchrotron radiation X-ray photoelectron and absorption spectroscopy. Water adsorption induces a strong modification of the chemical state of the pyridine N atoms at the SAM/ice interface, indicative for strong H bonding and partial proton transfer between water molecules and pyridine moieties. Additionally, the initial molecular orientation within the SAM is changed upon formation of an adsorbed water multilayer.

Absorption↗

Structure of carbohydrate-bound polynuclear iron oxyhydroxide nanoparticles in parenteral formulations.

Intravenous iron therapy is used to treat anemia associated with chronic kidney disease. The chemical structures of parenteral iron agents have not been characterized in detail, and correlations between structure, efficiency of iron delivery, and toxicity via catalysis of oxygen-derived free radical creation remain to be established. In this study, two formulations of parenteral iron have been characterized by absorption spectroscopy, X-ray diffraction analysis (XRD), transmission electron microscopy (TEM), atomic force microscopy (AFM), and elemental analysis. The samples studied were Venofer (Iron Sucrose Injection, USP) and Ferrlecit (Sodium Ferric Gluconate in Sucrose Injection). The 250-800-nm absorption spectra and the XRD patterns showed that both formulations contain a mineral core composed of iron oxyhydroxide in the beta-FeOOH mineral polymorph known as akaganeite. This was further confirmed for each formulation by imaging using TEM and AFM. The average core size for the nanoparticles, after dialysis to remove unbound or loosely bound carbohydrate, was approximately 3+/-2 nm for the iron-sucrose, and approximately 2+/-1 nm for the iron-gluconate. Each of the nanoparticles consists of a mineral core, surrounded by a layer of bound carbohydrate. The overall diameter of the average bead in the dialyzed preparations was approximately 7+/-4 nm for the iron-sucrose, and 3+/-1 nm for the iron-gluconate. Undialyzed preparations have particles with larger average sizes, depending on the extent of dilution of unbound and loosely bound carbohydrate. At a dilution corresponding to a final Fe concentration of 5 mg/mL, the average particle diameter in the iron-sucrose formulation was approximately 22+/-9 nm, whereas that of the iron-gluconate formulation was approximately 12+/-5 nm.

Journal Article↗

Doping gamma-Fe(2)O(3) nanoparticles with Mn(III) suppresses the transition to the alpha-Fe(2)O(3) structure.

Here we report on a mixed oxide system, gamma-Fe2O3 nanoparticles doped with Mn(III), where the transition from the cubic to the more stable hexagonal alpha-Fe2O3 structure is suppressed. When amorphous Fe2O3 is heated at 300 degrees C for 3 h, ferrimagnetic gamma-Fe2O3 is observed as the sole product. On the other hand, when the temperature is raised to 500 degrees C, one observes only antiferromagnetic alpha-Fe2O3 as the product. However, upon doping with 8.5 wt % Mn(III), the amorphous nanoparticles crystallized to mainly the gamma-Fe2O3 matrix after heating at 500 degrees C for 3 h, and need to be heated to >650 degrees C for the complete transition to the alpha-Fe2O3 structure to take place.

Journal Article↗

Imaging structured water and bound polysaccharide on mica surface at ambient temperature.

The presence of a water layer on the surface of muscovite mica under ambient conditions is well established. The water molecules are well ordered and seem to be oriented, leading to an icelike monolayer (probably ferroelectric) in epitaxial relation with the mica surface. We have imaged and characterized the height and contact angle of ordered water layer(s) formed by wetting and de-wetting processes on mica surfaces at different states of hydration by tapping mode atomic force microscopy. Implications that the presence of such an ordered water layer may have for imaging of biological samples are also discussed, with consideration of data for the polysaccharide hyaluronan.

Aluminum Silicates↗

A new route to alumoxane gel: a versatile precursor to gamma-alumina and alumina-based ceramic oxides.

We present a new route for the preparation of gamma-alumina and YAG nanoparticles. Metal salts of ethylhexanoic acids provide good solubility in hydrocarbon solvents and allow efficient ultrasonication. The sonication product is an alumioxane gel, which can reversibly collapse and reform, depending on the solvent used. The dried gel nanoparticles are calcined at temperatures significantly lower than those used in conventional syntheses, resulting in gamma-alumina nanoparticles. This is due to the complete mixing of elements at the atomic level and the small size of the formed nanoparticles.

Journal Article↗

Activity of Candida rugosa lipase immobilized on gamma-Fe2O3 magnetic nanoparticles.

We report the stability and enzymatic activity of Candida rugosa Lipase (E.C.3.1.1.3) immobilized on gamma-Fe2O3 magnetic nanoparticles. The immobilization strategies were either reacting the enzyme amine group with a nanoparticle surface acetyl, or amine groups. In the former, the enzyme was attached through a C=N bond, while in the latter it was connected using glutaraldehyde. AFM images show an average particle size of 20 +/- 10 nm after deconvolution. The enzymatic activity of the immobilized lipase was determined by following the ester cleavage of p-nitrophenol butyrate. The covalently immobilized enzyme was stabile and reactive over 30 days.

Candida↗