Biomedical subjects

Alan G Joly

Publications and source records attributed to Alan G Joly.

10 recordsLinked to original sources

PubMed2006

Probing electron transfer dynamics at MgO surfaces by Mg-atom desorption.

Ultraviolet excitation of high surface area MgO films using 4.7 eV femtosecond pulses results in neutral Mg-atom desorption with hyperthermal kinetic energies in the range 0.1-0.4 eV. The Mg-atom hyperthermal energies and power dependences are similar to those previously observed using nanosecond pulsed excitation. Femtosecond two-pulse correlation measurements reveal the existence of different dynamical paths for Mg-atom desorption. One mechanism displays a sub-150 fs time scale and involves the simultaneous or near-simultaneous transition of two electrons to a 3-coordinated Mg(2+) site. Other paths display picosecond time scales that we associate with dynamics following electron trapping at 3-coordinated Mg(2+) surface sites.

Adsorption↗

PubMed2006

Excited carrier dynamics of alpha-Cr2O3/alpha-Fe2O3 core-shell nanostructures.

In this work alpha-Cr(2)O(3)/alpha-Fe(2)O(3) core-shell polycrystalline nanostructures were synthesized by using alpha-Cr(2)O(3) nanoparticles as seed crystals during aqueous nucleation. The formation of alpha-Fe(2)O(3) polycrystallites on alpha-Cr(2)O(3) surfaces was confirmed by X-ray diffraction, transmission electron microscopy, and energy-dispersive X-ray analysis. The excited-state relaxation dynamics of as-grown core-shell structures and "pure" alpha-Fe(2)O(3) particles of the same size were measured with femtosecond transient absorption spectroscopy. The results show the carrier lifetimes decay within a few picoseconds regardless of sample. This is likely due to fast recombination/trapping of carriers to defects and iron d-states.

Journal Article↗

PubMed2006

Comparison of water-soluble CdTe nanoparticles synthesized in air and in nitrogen.

It is commonly believed that high-quality CdTe nanoparticles with strong luminescence can only be prepared under the protection of an inert gas such as nitrogen or argon. Here, we report the preparation of highly luminescent CdTe nanoparticles in air and compare their luminescence properties with CdTe nanoparticles made in nitrogen. We find that both water-soluble CdTe nanoparticles made in air and in nitrogen exhibit strong photoluminescence as well as upconversion luminescence at room temperature. However, differences do exist between the particles made in air and those made in nitrogen. In particular, the particles prepared in air display a faster growth rate, grow to larger sizes, and display stronger electron coupling relative to the particles prepared in nitrogen. X-ray photoelectron spectroscopy analysis indicates that the oxygen content in the nanoparticles synthesized in air is higher that that in particles synthesized in N(2), likely resulting in a higher availability of excess free cadmium. Cytotoxicity measurements reveal that the particles made in air appear slightly more toxic, possibly due to the excess of free cadmium.

Air↗

PubMed2005

Laser control of desorption through selective surface excitation.

We review recent developments in controlling photoinduced desorption processes of alkali halides. We focus primarily on hyperthermal desorption of halogen atoms and show that the yield, electronic state, and velocity distributions of desorbed atoms can be selected using tunable laser excitation. We demonstrate that the observed control is due to preferential excitation of surface excitons. This approach takes advantage of energetic differences between surface and bulk exciton states and probes the surface exciton directly. We demonstrate that desorption of these materials leads to controlled modification of their surface geometric and electronic structures. We then extend the exciton mechanism of desorption, developed for alkali halides, to metal oxide surfaces, in particular magnesium oxide. In addition, these results demonstrate that laser desorption can serve as a solid-state source of halogen and oxygen atoms, in well-defined electronic and velocity states, for studying chemical processes in the gas phase and at surfaces.

Journal Article↗

PubMed2005

Upconversion luminescence from CdSe nanoparticles.

Efficient upconversion luminescence has been observed from CdSe nanoparticles ranging in size from 2.5 to 6 nm. The upconversion luminescence exhibits a near-quadratic laser power dependence. Emissions from both excitons and trap states are observed in the upconversion and photoluminescence spectra, and in the upconversion luminescence the emission from the trap states is enhanced relative to the trap-state emission in the photoluminescence. The upconversion decay lifetimes are slightly longer than the photoluminescence decay lifetimes. Time-resolved spectral measurements indicate that this is due to the involvement of long decay components from surface or trap states. Both the photoluminescence and upconversion luminescence decrease in intensity with increasing temperature due mainly to thermal quenching. All the observations indicate that trap states work as emitters rather than as intermediate states for upconversion luminescence and that two-photon absorption is the likely excitation mechanism.

Cadmium Compounds↗

PubMed2005

Fabrication and luminescence of ZnS:Mn2+ nanoflowers.

Visually striking nanoflowers composed of ZnS:Mn2+ nanoparticles are prepared and characterized. The configurations of these fractal structures are very sensitive to both the pH values of the particle solutions from which they are precipitated and the substrates on which they are deposited. At pH 2.2, the fractal structures resemble trees without leaves; at pH 7.7, they are tree-like with four arms and at pH 11.0 they resemble trees with six arms. High resolution transmission microscopy reveals that the nanoflowers are composed of ZnS:Mn2+ nanoparticles of 2-5 nm in size. X-ray photoelectron spectral data indicate that the sample compositions of nitrogen, chlorine, and sulfur vary gradually with pH values of the solutions. These changes may have an impact on both the fractal configuration and the luminescence properties. The emission spectra of the particle solutions at pH values of 2.2 and 11.0 are similar with the emission maximum at 475 nm. As the pH value approaches 7.7, the emission spectral maximum shifts to longer wavelengths. At a pH value of 7.7, the emission peak wavelength is the reddest, 520 nm. The emission peak of the nanoflowers at a pH value of 9.3 is 510 nm, while the emission spectrum of the nanoflowers at 5.2 has two peaks at 500 nm and 440 nm, respectively. These blue-green emissions are attributed to defects and are the dominant luminescence from the nanoflowers. The emission from Mn2+ dopant is only observed in the delayed spectra of the fractal solid samples.

Crystallization↗

PubMed2005

Synthesis and luminescence of ZnMgS:Mn2+ nanoparticles.

Efficient green emission from ZnMgS:Mn2+ nanoparticles prepared by co-doping Mg2+ and Mn2+ ions into ZnS lattices has been observed. The synthesis is carried out in aqueous solution, followed by a post-annealing process, thus showing the features of less complexity, low cost, and easy incorporation of dopants. In comparison with the emission of ZnS:Mn2+ nanoparticles, which is located generally around 590 nm, the photoluminescence of ZnMgS:Mn2+ nanoparticles is blue-shifted by 14 nm in wavelength, leading to the enhanced green emission. The X-ray diffraction, electron spin resonance, and pressure dependent photoluminescence measurements suggest that the change of the crystal field caused by Mg2+ ionic doping and the lower symmetry in the nanoparticles may account for the blue-shift of the photoluminescence. The ZnMgS:Mn2+ nanoparticles with 1% Mn2+ doping exhibit the strongest luminescence, which could potentially meet the requirements for the construction of green light emitting diodes.

Crystallization↗

PubMed2004

Cryogenic laser induced fluorescence characterization of U(VI) in Hanford Vadose Zone pore waters.

Ambient and liquid helium temperature laser-induced time-resolved uranyl fluorescence spectroscopy was applied to study the speciation of aqueous uranyl solutions containing carbonate and phosphate and two porewater samples obtained by ultracentrifugation of U(VI)-contaminated sediments. The significantly enhanced fluorescence signal intensity and spectral resolution found at liquid helium temperature allowed, for the first time, direct fluorescence spectroscopic observation of the higher aqueous uranyl complexes with carbonate: UO2(CO3)2(2-), UO2(CO3)3(4-), and (UO2)2(OH)3CO3-. The porewater samples were nonfluorescent at room temperature. However, at liquid helium temperature, both porewater samples displayed strong, well-resolved fluorescence spectra. Comparisons of the spectroscopic characteristics of the porewaters with those of the standard uranyl-carbonate complexes confirmed that U(VI) in the porewaters existed primarily as UO2(CO3)3(4-) along with a small amount of other minor components, such as dicalcium-urano-tricarbonate complex, Ca2UO2(CO3)3, consistent with thermodynamic calculation. The U(VI)-carbonate complex is apparently the mobile species responsible for the subsurface migration of U(VI), even though the majority of the in-ground U(VI) inventory at the site from which the samples were obtained exists as intragrain U(VI)-silicate precipitates.

Carbonates↗

PubMed2004

Laser control of product electronic state: desorption from alkali halides.

We demonstrate laser control of the electronic product state distribution of photodesorbed halogen atoms from alkali halide crystals. Our general model of surface exciton desorption dynamics is developed into a simple method for laser control of the relative halogen atom spin-orbit laser desorption yield. By tuning the excitation laser photon energy in a narrow region of the absorption threshold, the yield of excited state chorine atoms, Cl(2P(1/2)), can be made to vary from near 0 to 80% for KCl and from near 0 to 50% for NaCl relative to the total yield of Cl atoms. We describe the physical properties necessary to obtain a high degree of product state control and the limitation induced when these requirements are not met. These results demonstrate that laser control can be applied to solid state surface reactions and provide strong support for surface exciton-based desorption models.

Journal Article↗

PubMed2004

Optical properties and potential applications of doped semiconductor nanoparticles.

Recent studies on the optical properties, in particular, luminescence, of a variety of doped semiconductor nanoparticles are reviewed. The effects of quantum confinement, temperature and pressure on luminescent properties are discussed. In addition, electroluminescence, cathodoluminescence, magnetoluminescence and related applications involving doped semiconductor nanoparticles are presented. A new phenomenon, upconversion luminescence of doped nanoparticles, is reviewed and its potential applications are discussed. While more research efforts are necessary in order to fully understand the fundamentals and explore the great technological potential behind doped nanoparticles, recent results already show that this is a new and exciting field with applications in many areas. In particular, the emerging field of "spintronics", where spin states are exploited in analogy to conventional electronic states, is discussed and the advantages of using doped semiconductor nanoparticles are elucidated.

Electrochemistry↗