Biomedical subjects

Aldo Brugnera Junior

Publications and source records attributed to Aldo Brugnera Junior.

5 recordsLinked to original sources

PubMed2006

Molecular analysis of Er:YAG laser irradiation on dentin.

The aim of this study was to evaluate by dispersive Raman spectroscopy the mineral and organic components of human dentin before and after laser irradiation and acid etching. The occlusal enamel of six non-carious human third molars was removed providing 6 dentin discs, which were divided in four quadrants each of them receiving a different surface treatment: etching with a 37% phosphoric acid gel (control); irradiation by Er:YAG laser (KaVo Key Laser II) with 80 mJ, 3 Hz, 30 s (group I); 120 mJ, 3 Hz, 30 s (group II); and 180 mJ, 3 Hz, 30 s (group III). The Raman spectra of normal (untreated) and treated dentin were analyzed and the mineral and the organic component were evaluated. Results were submitted to statistical analysis by ANOVA and Tukey's test at 5% significance level. The minerals and organic content were less affected in the control group and group I (p>0.05). Group II presented more reduction in mineral content (p<0.01) whereas in group III the inorganic (p<0.05) and organic (p<0.01) content were more affected. Dispersive Raman spectroscopy provided valid information of dentin chemical constituents with non-chemical sampling preparation.

Acid Etching, Dental↗

PubMed2005

Susceptibility of Streptococcus mutans biofilms to photodynamic therapy: an in vitro study.

OBJECTIVES: The purpose of this study was to evaluate the antimicrobial effect of toluidine blue O (TBO), in combination with either a helium/neon (HeNe) laser or a light-emitting diode (LED), on the viability and architecture of Streptococcus mutans biofilms. METHODS: Biofilms were grown on hydroxyapatite discs in a constant depth film fermentor fed with artificial saliva that was supplemented with 2% sucrose four times a day, thus producing a typical 'Stephan pH curve'. Photodynamic therapy was subsequently carried out on biofilms of various ages with light from either the HeNe laser or LED using energy densities of between 49 and 294 J/cm(2). RESULTS: Significant decreases in the viability of S. mutans biofilms were only observed when biofilms were exposed to both TBO and light, when reductions in viability of up to 99.99% were observed with both light sources. Overall, the results showed that the bactericidal effect was light dose-dependent and that older biofilms were less susceptible to photodynamic therapy. Confocal laser scanning microscopy images suggested that lethal photosensitization occurred predominantly in the outermost layers of the biofilms. CONCLUSIONS: Photodynamic therapy may be a useful approach in the treatment of dental plaque-related diseases.

Biofilms↗

PubMed2005

Evaluation of hollow fiberoptic tips for the conduction of Er:YAG laser.

OBJECTIVE: The use of Er:YAG laser operating in the 3 microm range with adjustable power and pulses has become popular for dental and medical practice due to its high photoablative capacity, surgical precision and antimicrobial action. BACKGROUND DATA: The existing fiberoptic tips irradiate lasers parallel to the long axes of the tooth limiting its efficiency in the root canal. METHODS: We evaluated hollow fiberoptic tips obtained from silicate glass as a means of Er:YAG laser conduction in dental procedures. The fiber tips were molded from capillary tubes with different profiles so that their ends would have cylindric, conical or spherical shapes. The performance of the three fibers as a means of propagation of Er:YAG (lambda = 2.94 microm) laser radiation was compared to that of a solid sapphire fiber at 10 Hz and 200 mJ and of 20 Hz and 500 mJ. The profiles of frontal and lateral burning were visualized on thermal paper. RESULTS: Analysis of these profiles demonstrated that the sapphire tip and the hollow fiber of cylindric section did not differ significantly in the profiles of frontal burning, and no lateral burning was detected. The fibers of the conical and spherical sections, although presenting attenuation in the frontal output power, showed a larger burning area in the frontal profile, in addition to producing lateral burning. CONCLUSIONS: The results indicate that commercial hollow fiberoptics have advantages such as easy manufacture of the different tip shapes, great adaptability, low cost, and a low loss of transmission.

Aluminum Oxide↗

PubMed2004

Diode laser-activated bleaching.

This study describes a preclinical investigation with laser-activated bleaching agent for discolored teeth. Bleaching techniques involve a broad-spectrum approach utilizing hydrogen peroxide (3-38%) with or without heat or laser, carbamide peroxide (10-30%), or a mixture of sodium perborate and hydrogen peroxide. Extracted human maxillary central incisors were selected. In the bleaching experiment, 38% hydrogen peroxide was used. Two different laser systems and light emission diodes for activation of the bleaching agent were used: diode laser, wavelength 970 nm, and infra-red diode laser, wavelength 790 nm, with eight blue light emission diodes, wavelength 467 nm. The enamel surface was evaluated with the scanning electron microscope. The method of chemical oxidation resulted in a 2-3 shade change in one treatment (15 min). Shorter time (5 min) was not effective. The diode laser, wavelength 970 nm, and the bleaching agent produced the same effect but with a shorter time of bleaching process (5 min - 1 W, 2.5 min - 2 W). Infra-red diode laser, wavelength 790 nm with eight blue light emission diodes, wavelength 467 nm, and the bleaching agent reached the desired color shade also after a shorter time (5 min - 40 mW). Slight surface modification after the bleaching process was detected with scanning electron microscopy. Currently, the laser has been proven the most valuable energy source for power bleaching with simple and short application in the dental office.

Hydrogen Peroxide↗

PubMed2002

Effect of Er:YAG laser on adhesion of root canal sealers.

This in vitro study evaluated the effect of Er:YAG laser on adhesion to human dentin of Grossman, Endomethasone, N-Rickert, and Sealer 26 root canal sealers. The crowns of 40 human molars were cut on the occlusal side until a flat dentin surface was obtained. The teeth were divided into two groups: group 1, no laser application; and group 2, irradiation with Er:YAG laser (KaVo Key Laser 2; 11 mm focal distance, perpendicular to the dentin surface, 4 Hz frequency, 200 mJ energy, 62 J total energy and 313 pulses, 1-min application time, and 2.25 W power). Five samples were tested for each sealer and each group. An Instron universal testing machine was used for the adhesion test. Sealer 26 showed the best adhesion both with and without laser application (p < 0.01). Grossman and N-Rickert sealers had intermediate values, and Endomethasone had the worst adhesion. Application of Er:YAG laser did not alter the adhesion of Grossman, N-Rickert, or Endomethasone sealers. However, laser application increased the adhesion of Sealer 26. The epoxy resin-based root canal sealer (Sealer 26) adhered better to dentin prepared with and without Er:YAG laser than the zinc oxide/eugenol-based sealers (Endomethasone, N-Rickert, and Grossman).

Adhesiveness↗