PubMed Health⌕ Search

Biomedical subjects

Alexis T Bell

Publications and source records attributed to Alexis T Bell.

34 records · Page 2Linked to original sources
PubMed2005

Quantitative analysis of hydrogen peroxide by 1H NMR spectroscopy.

A technique utilizing 1H NMR spectroscopy has been developed to measure the concentration of hydrogen peroxide from 10(-3) to 10 M. Hydrogen peroxide produces a peak at around 10-11 ppm, depending upon the interaction between solvent molecules and hydrogen peroxide molecules. The intensity of this peak can be monitored once every 30 s, enabling the measurement of changes in hydrogen peroxide concentration as a function of time. 1H NMR has several advantages over other techniques: (1) applicability to a broad range of solvents, (2) ability to quantify hydrogen peroxide rapidly, and (3) ability to follow reactions forming and/or consuming hydrogen peroxide as a function of time. As an example, this analytical technique has been used to measure the concentration of hydrogen peroxide as a function of time in a study of hydrogen peroxide decomposition catalyzed by iron(III) tetrakispentafluorophenyl porphyrin.

Journal Article↗
PubMed2005

In situ UV-visible spectroscopic measurements of kinetic parameters and active sites for catalytic oxidation of alkanes on vanadium oxides.

In situ diffuse reflectance UV-visible spectroscopy was used to measure the dynamics of catalyst reduction and oxidation during propane oxidative dehydrogenation (ODH) on VOx/gamma-Al2O3. Transients in UV-visible intensity in the near-edge region were analyzed using a mechanistic model of ODH reactions. Rate constants per site for the kinetically relevant reduction step (C-H bond activation) measured using this analysis are slightly larger than those obtained from steady-state ODH rates normalized by surface V. The ratio of these values provides a measure of the fraction of the V surface sites that are active for ODH (0.6-0.7, for V surface densities of 2.3-34 V nm(-2)). This suggests that some of the V atoms are either inaccessible or inactive. Reoxidation rate constants, which cannot be obtained from steady-state analysis, are 10(3)-10(5) times larger than those for the C-H bond activation reduction step.

Journal Article↗
PubMed2005

Comprehensive DFT study of nitrous oxide decomposition over Fe-ZSM-5.

The reaction mechanism for nitrous oxide decomposition has been studied on hydrated and dehydrated mononuclear iron sites in Fe-ZSM-5 using density functional theory. In total, 46 different surface species with different spin states (spin multiplicity M(S) = 4 or 6) and 63 elementary reactions were considered. Heats of adsorption, activation barriers, reaction rates, and minimum energy pathways were determined. The approximate minimum energy pathways and transition states were calculated using the "growing string method" and a modified "dimer method". Spin surface crossing (e.g., O(2) desorption) was considered. The minimum potential energy structure on the seam of two potential energy surfaces was determined with a multiplier penalty function algorithm by Powell and approximate rates of spin surface crossings were calculated. It was found that nitrous oxide decomposition is first order with respect to nitrous oxide concentration and zero order with respect to oxygen concentration. Water impurities in the gas stream have a strong inhibiting effect. In the concentration range of 1-100 ppb, the presence of water vapor influences the surface composition and the apparent rate coefficient. This is especially relevant in the temperature range of 600-700 K where most experimental kinetic studies are performed. Apparent activation barriers determined over this temperature range vary from 28.4 (1 ppb H(2)O) to 54.8 kcal/mol (100 ppb H(2)O). These results give an explanation why different research groups and different catalyst pretreatments often result in very different activation barriers and preexponential factors. Altogether perfect agreement with experimental results could be achieved.

Journal Article↗
PubMed2004

Atomic level control over surface species via a molecular precursor approach: isolated Cu(I) sites and Cu nanoparticles supported on mesoporous silica.

A nonaqueous molecular precursor grafting approach was employed for the generation of well-defined surface structures featuring Cu on a mesoporous silica support. X-ray absorption measurements (XANES and EXAFS) were used to determine that [CuOSi(OtBu)3]4 provided 100% isolated Cu(I) sites upon grafting (without thermal treatment), whereas [CuOtBu]4 gave isolated species with most of the original Cu-O-Cu linkages intact, but in a more relaxed straight chain form. Upon heating under inert conditions, the vast majority of Cu in the materials from [CuOSi(OtBu)3]4 remained as isolated Cu(I) sites (up to 88% isolation), with significant stabilization provided from the -OSi(OtBu)3 ligands. In stark contrast, approximately 100% of the Cu in the materials generated from [CuOtBu]4 was readily reduced upon heating, forming isolated Cu metal particles with an average diameter of 0.7 nm.

Journal Article↗
PubMed2004

Rate constants from the reaction path Hamiltonian. I. Reactive flux simulations for dynamically correct rates.

As ab initio electronic structure calculations become more accurate, inherent sources of error in classical transition state theory such as barrier recrossing and tunneling may become major sources of error in calculating rate constants. This paper introduces a general method for diabatically constructing the transverse eigensystem of a reaction path Hamiltonian in systems with many degenerate transverse frequencies. The diabatically constructed reaction path Hamiltonian yields smoothly varying coupling constants that, in turn, facilitate reactive flux calculations. As an example we compute the dynamically corrected rate constant for the chair to boat interconversion of cyclohexane, a system with 48 degrees of freedom and a number of degenerate frequencies. The transmission coefficients obtained from the reactive flux simulations agree with previous results that have been calculated using an empirical potential. Furthermore, the calculated rate constants agree with experimental values. Comparison to variational transition state theory shows that, despite finding the true bottleneck along the reaction pathway, variational transition state theory only accounts for half of the rate constant reduction due to recrossing trajectories.

Journal Article↗
PubMed2004

Rate constants from the reaction path Hamiltonian. II. Nonseparable semiclassical transition state theory.

For proton transfer reactions, the tunneling contributions to the rates are often much larger than thermally activated rates at temperatures of interest. A number of separable tunneling corrections have been proposed that capture the dependence of tunneling rates on barrier height and imaginary frequency size. However, the effects of reaction pathway curvature and barrier anharmonicity are more difficult to quantify. The nonseparable semiclassical transition state theory (TST) of Hernandez and Miller [Chem. Phys. Lett. 214, 129 (1993)] accounts for curvature and barrier anharmonicity, but it requires prohibitively expensive cubic and quartic derivatives of the potential energy surface at the transition state. This paper shows how the reaction path Hamiltonian can be used to approximate the cubic and quartic derivatives used in nonseparable semiclassical transition state theory. This enables tunneling corrections that include curvature and barrier anharmonicity effects with just three frequency calculations as required by a conventional harmonic transition state theory calculation. The tunneling correction developed here is nonseparable, but can be expressed as a thermal average to enable efficient Monte Carlo calculations. For the proton exchange reaction NH2 + CH4 <==> NH3 + CH3, the nonseparable rates are very accurate at temperatures from 300 K up to about 1000 K where the TST rate itself begins to diverge from the experimental results.

Journal Article↗
PubMed2004

A growing string method for determining transition states: comparison to the nudged elastic band and string methods.

Interpolation methods such as the nudged elastic band and string methods are widely used for calculating minimum energy pathways and transition states for chemical reactions. Both methods require an initial guess for the reaction pathway. A poorly chosen initial guess can cause slow convergence, convergence to an incorrect pathway, or even failed electronic structure force calculations along the guessed pathway. This paper presents a growing string method that can find minimum energy pathways and transition states without the requirement of an initial guess for the pathway. The growing string begins as two string fragments, one associated with the reactants and the other with the products. Each string fragment is grown separately until the fragments converge. Once the two fragments join, the full string moves toward the minimum energy pathway according to the algorithm for the string method. This paper compares the growing string method to the string method and to the nudged elastic band method using the alanine dipeptide rearrangement as an example. In this example, for which the linearly interpolated guess is far from the minimum energy pathway, the growing string method finds the saddle point with significantly fewer electronic structure force calculations than the string method or the nudged elastic band method.

Journal Article↗
PubMed2003

Synthesis of mixed acid anhydrides from methane and carbon dioxide in acid solvents.

[reaction: see text] The reaction of CH(4) with CO(2) has been performed in anhydrous acids using VO(acac)(2) and K(2)S(2)O(8) as promoters. NMR analysis establishes that the primary product is a mixed anhydride of acetic acid and the acid solvent. In sulfuric acid, the overall reaction is CH(4) + CO(2) + SO(3) --> CH(3)C(O)-O-SO(3)H. Hydrolysis of the mixed anhydride produces acetic acid and the solvent acid. When trifluoroacetic acid is the solvent, acetic acid is primarily formed via the reaction CH(4) + CF(3)COOH --> CH(3)COOH + CHF(3).

Journal Article↗
PubMed2003

Direct sulfonation of methane to methanesulfonic acid with SO2 using Ca salts as promoters.

Direct liquid-phase sulfonation of methane to methanesulfonic acid (MSA) with SO2 has been achieved in triflic acid using K2S2O8 as the oxidant and a small amount of a Ca salt as the promoter. The effects of reaction conditions on the conversion of SO2 to MSA were examined. Included were the influence of solvent acidity, reaction duration, reaction temperature, amount of K2S2O8, and composition and amount of promoters.

Journal Article↗
PubMed2003

The impact of nanoscience on heterogeneous catalysis.

Most catalysts consist of nanometer-sized particles dispersed on a high-surface-area support. Advances in characterization methods have led to a molecular-level understanding of the relationships between nanoparticle properties and catalytic performance. Together with novel approaches to nanoparticle synthesis, this knowledge is contributing to the design and development of new catalysts.

Journal Article↗
PubMed2002

Synthesis, characterization, and catalytic performance of single-site iron(III) centers on the surface of SBA-15 silica.

A new molecular precursor strategy has been used to prepare a series of single-site catalysts that possess isolated iron centers supported on mesoporous SBA-15 silica. The iron centers were introduced via grafting reactions of the tris(tert-butoxy)siloxy iron(III) complex Fe[OSi(O(t)Bu)(3)](3)(THF) with SBA-15 in dry hexane. This complex reacts cleanly with the hydroxyl groups of SBA-15 to eliminate HOSi(O(t)Bu)(3) (as monitored by (1)H NMR spectroscopy) with formation of isolated surface species of the type identical with SiO-Fe-[OSi(O(t)Bu)(3)](2)(THF). In this way, up to 21% of the hydroxyl sites on SBA-15 were derivatized (0.23 Fe nm(-)(2)), and iron loadings in the range of 0.0-1.90% were achieved. The structure of the surface-bound iron species, as determined by spectroscopic methods (electron paramagnetic resonance (EPR), nuclear magnetic resonance (NMR), UV-vis, and in situ infrared measurements) and by elemental analyses, contains a pseudotetrahedral iron(III) center. The THF ligand of this surface-bound complex was quantitatively displaced by acetonitrile (by (1)H NMR spectroscopy). Calcination of these materials at 300 degrees C for 2 h under oxygen resulted in removal of all organic matter and site-isolated iron surface species that are stable to condensation to iron oxide clusters. Spectroscopic data (UV-vis and EPR) suggest that the iron centers retain a mononuclear, pseudotetrahedral iron(III) structure after calcination. The calcinated, iron-grafted SBA-15 materials exhibit high selectivities as catalysts for oxidations of alkanes, alkenes, and arenes, with hydrogen peroxide as the oxidant.

Journal Article↗