Biomedical subjects

Ali Zarbakhsh

Publications and source records attributed to Ali Zarbakhsh.

5 recordsLinked to original sources

PubMed2005

Neutron reflection from the liquid-liquid interface: adsorption of hexadecylphosphorylcholine to the hexadecane-aqueous solution interface.

Adsorption of water-soluble, zwitterionic n-hexadecylphosphorylcholine (C(16)PC) amphiphiles has been examined at the hexadecane-aqueous solution interface using neutron reflectivity (NR) and interfacial tension measurements. The results of both methods indicate that the limiting area per surfactant molecule at the interface at the critical micelle concentration (cmc) is 40 +/- 5 Angstroms(2). In the NR measurements, two isotopic contrasts have been employed to determine the adsorption isotherm and to explore the structure of the interfacial region. Single-layer model fitting to both isotopic contrasts was only possible for the single sub-cmc concentration studied, where a film thickness of 60 +/- 5 Angstroms was obtained; consistent single-layer model fits to both contrasts for concentrations greater than the cmc were not possible, leading to the requirement of a two-layer model with an overall film thickness close to 60 +/- 2 Angstroms. This film thickness is appreciably greater than the fully extended C(16)PC molecular length and cannot be explained purely in terms of thermal broadening. A further result is that the reflectivity data indicate that, as the C(16)PC concentration increases, the amount of water on the hexadecane side of the interfacial region increases, in contrast to intuitive expectation. These findings are interpreted by conjecturing a structural model in which a trilayer of C(16)PC molecules is formed at the interface with the water concentrated in the region occupied by the headgroups.

Journal Article↗

PubMed2005

Width of the hexadecane-water interface: a discrepancy resolved.

An existing discrepancy in the determined values of the width of the hexadecane-water interface as determined from X-ray reflection (XR) and recent neutron reflection (NR) measurements has been resolved. The NR-determined width reported here is 6.0 +/- 1.0 Angstroms, which compares extremely well with the XR-determined value of 6.0 +/- 0.2 Angstroms. The origin of the discrepancy has been attributed to the thermal history of the interface rather than sample purity or other technique-dependent reasons.

Neutrons↗

PubMed2005

Neutron reflectivity studies of critical adsorption: behavior of the surface scaling function.

Neutron reflectometry has been employed to examine the nature of the critical adsorption surface scaling function for a near-critical mixture of hexane-d14+perfluorohexane adsorbing to a solid substrate from the liquid one-phase region. The analysis method of Dietrich and Schack has been applied to examine the nature of the power-law part of the critical adsorption surface scaling function, which has been found to behave as m(z) approximately P0z(-mu) as the critical point is approached. Values of mu = 0.514+/-0.018 and P0 = 0.90+/-0.04 have been obtained. These values are consistent with theoretical expectations (mu(th) = 0.516+/-0.004; P0(th) = 0.94+/-0.05), the value determined from Monte Carlo simulations (P(MC)0 = 0.866, and other experimental determinations (P(ex)0 = 0.955=/-0.08).

Journal Article↗

PubMed2005

Structural studies of amphiphiles adsorbed at liquid-liquid interfaces using neutron reflectometry.

We report the application and refinement of a recently developed method for structural studies at a liquid liquid interface using neutron reflectometry. The technique involves the entrapment of a thin oil layer between a silicon substrate and an aqueous subphase. The thin oil film is prepared by spin-coating an oil film on to an oleophilically treated silicon substrate. During the reflectivity measurement the sample is maintained in a horizontal position, and the angle of incidence of the neutron beam is varied using a supermirror. Attenuation of neutron reflectivity at the lowest angle of incidence is used to determine the oil-layer thickness. We report information regarding the structure at the interface between hexadecane and a 0.1% w/v aqueous solution of the triblock copolymer Pluronic L64 with EO13PO30EO13 (EO = ethylene oxide; PO = propylene oxide) and the interface between hexadecane and a 3.7 mmol dm(-3) (approximately critical micelle concentration) aqueous solution of the cationic surfactant tetradecyltrimethylammonium bromide (C14TAB). For the C14TAB system, the reflectivity data unambiguously reveal the presence of a region highly concentrated in C14TAB on the oil side of the interface. For the Pluronic L64 system, the data suggest that the polymer adsorbs at the interface occupying both oil and water sides of the interface. Model scattering length density profiles that capture these features are presented and further models that better fit the data are discussed.

Journal Article↗

PubMed2004

Adsorption from alkane+perfluoroalkane mixtures at fluorophobic and fluorophilic surfaces. II. Crossover from critical adsorption to complete wetting.

Using neutron reflectometry, adsorption from an equimolar mixture of hexane + perfluorohexane to a fluorophobic, octadecyl-coated, silicon substrate has been investigated as a function of temperature in the one-phase region upon approach to liquid-liquid coexistence. The composition of the investigated mixture, x(F) = 0.50, is well removed from the critical composition of x(F) = 0.36, where x(F) is the perfluorohexane mole fraction. To aid the modeling, mixtures with three different neutron refractive index contrasts have been used: namely, mixtures of C(6)H(14) + C(6)F(14) (H-F), C(6)D(14) + C(6)F(14) (D-F), and a mixture of C(6)H(14) + C(6)D(14) + C(6)F(14) which has been adjusted to have the same refractive index as silicon (CMSi). For all three contrasts, the principal features of the composition profile normal to the interface follow similar trends as the temperature T is reduced towards T(0), the coexistence temperature. These features consist of: (i) a hexane-rich primary adsorption layer appended to the octadecyl coupled layer. This primary layer is 22 +/- 5 A thick and becomes increasingly enriched in hexane as T(0) is approached. (ii) A tail that decays exponentially towards the bulk composition with a characteristic decay length zeta. As T(0) is approached, zeta increases. The scattering length density profiles have been converted to volume fraction profiles and the surface excess of hexane Gamma has been determined as a function of temperature for all three contrasts. As T(0) is approached Gamma increases, and its behavior can be represented using the scaling law Gamma approximately |T - T(0)|(-m). The resulting values of m are 0.71 +/- 0.09, 0.68 +/- 0.04, and 0.68 +/- 0.06 for the D-F, H-F, and CMSi contrasts, respectively. The behavior of Gamma with temperature does not adhere to the Gamma approximately |T - T(0)|(-1/3) law expected for complete wetting in systems with van der Waals interactions nor does it correspond to Gamma approximately |T - T(c)|(-0.305) expected for critical adsorption. The magnitude of the exponent m indicates that the adsorption resides in the crossover region between critical adsorption and complete wetting.

Journal Article↗