Biomedical subjects
Publications and source records attributed to Alison Crossley.
We demonstrate with transmission electron microscopy and X-ray photoelectron spectroscopy that single-walled carbon nanotubes contain significant amounts of iron in the form of Fe(3)O(4), which even after acid washing, is not removed.
Gold nanoparticles (approximately 30-60 nm in diameter) were deposited onto the surface of glassy carbon microspheres (10-20 microm) through electroless plating to produce bulk (i.e., gram) quantities of nanoparticle surface-modified microspheres. The gold nanoparticle-modified powder was then characterized by means of scanning electron microscopy and cyclic voltammetry. The voltammetric response of a macroelectrode consisting of a film of gold nanoparticle-modified glassy carbon microspheres, bound together and "wired-up" using multiwalled carbon nanotubes (MWCNTs), was investigated. We demonstrate that by intelligently exploiting both nano- and microchemical architectures and wiring up the electroactive centers using MWCNTs in this way, we can obtain macroelectrode voltammetric behavior while only using approximately 1% by mass of the expensive gold material that would be required to construct the equivalent gold film macrodisk electrode. The potential utility of electrodes constructed using chemical architectures such as this was demonstrated by applying them to the analytical determination of arsenic(III) concentration. An optimized limit of detection of 2.5 ppb was obtained.
The electron transfer kinetics of ferrocyanide, potassium hexachloroiridate(III), hexaammineruthenium(III) chloride, and N,N,N',N'-tetramethyl-p-phenylenediamine (TMPD) have been examined at basal plane and edge plane pyrolytic graphite electrodes which have been allowed to oxidise in air for various periods of time. It is demonstrated via voltammetric and X-ray photoelectron spectroscopy (XPS) analysis that oxygenated species formed at edge plane sites/defects decrease the electron transfer kinetics of ferrocyanide but that the rates for potassium hexachloroiridate(III), hexaammineruthenium(III) chloride and TMPD are insensitive to the oxygenated species. The behaviour of the ferro-/ferricyanide couple contrasts with that seen on single-walled carbon nanotubes where oxygenation of the tube ends is known to speed up the electron transfer kinetics (A. Chou, T. Bocking, N. K. Singh, J. J. Gooding, Chem. Commun. 2005, 842); the possible reasons for this contrasting behaviour are discussed.
Explore the source record for details and available documents.
We report electrochemical composites of multi-walled carbon nanotubes (MWCNTs) with poly(vinylferrocene) (PVF). The polymeric architecture is prepared by first immobilising the MWCNTs onto a glassy carbon substrate, which acts to introduce electrical current into the composite, with the MWCNTs acting as 'molecular wires'. PVF films of varying surface coverages can be obtained by simply controlling the time a constant potential of +0.7 V (vs. Ag) wire is applied; with the characteristics of the derivatised MWCNTs examined by cyclic voltammetry and scanning electron microscopy. The application of the composite for glucose determination in aqueous solutions was investigated using linear sweep voltammetry, where it was found that the composites supported on glassy carbon substrates are superior to bare glassy carbon electrodes polymerised with PVF, likely due to the comparatively higher number of electrocatalytic centres in the former. This protocol was successfully transferred to prepare a PVF-MWCNT-paste electrode which was applied to glucose detection in diluted laked horse blood. The obtained results show potential and promising practical application for the polymer-derivatised MWCNT-modified electrodes in amperometric sensors for glucose determination.
Explore the source record for details and available documents.
Electrochemical processes, which underlie the use of conductive diamond electrodes for the simultaneous detection of two or more metal ions in solution by anodic stripping voltammetry (ASV), have been investigated. The model analyte system studied contains the two metal species, Ag+(aq) and Pb2+(aq), and the experimental techniques employed include cyclic and square wave voltammetries, along with X-ray photoelectron spectroscopy and secondary electron microscopy. Although the bulk metallic forms of Ag and Pb are immiscible, several interactions in the system between the two metal species present are observed, which significantly influence the electrodeposition and electrodissolution processes which underlie ASV. The subsequent nucleation and growth of a given metal on the electrode surface is enhanced by the presence of the second metal on the surface. The encapsulation of one metal by the other, within the metal particulates that form on the electrode surface, significantly reduces the stripping yield at the potentials characteristic of the individual metals. The stripping potentials are also influenced by bonding interactions between deposited Ag and Pb, which broaden the characteristic stripping peaks in cyclic voltammetry, as well as producing underpotential deposition and stripping. Given these interactions, the extent to which ASV at diamond electrodes can be used to determine the solution concentrations of Ag+(aq) and Pb2+(aq) is considered.