PubMed Health⌕ Search

Biomedical subjects

Anders Bjarklev

Publications and source records attributed to Anders Bjarklev.

6 recordsLinked to original sources

Strained silicon as a new electro-optic material.

For decades, silicon has been the material of choice for mass fabrication of electronics. This is in contrast to photonics, where passive optical components in silicon have only recently been realized. The slow progress within silicon optoelectronics, where electronic and optical functionalities can be integrated into monolithic components based on the versatile silicon platform, is due to the limited active optical properties of silicon. Recently, however, a continuous-wave Raman silicon laser was demonstrated; if an effective modulator could also be realized in silicon, data processing and transmission could potentially be performed by all-silicon electronic and optical components. Here we have discovered that a significant linear electro-optic effect is induced in silicon by breaking the crystal symmetry. The symmetry is broken by depositing a straining layer on top of a silicon waveguide, and the induced nonlinear coefficient, chi(2) approximately 15 pm V(-1), makes it possible to realize a silicon electro-optic modulator. The strain-induced linear electro-optic effect may be used to remove a bottleneck in modern computers by replacing the electronic bus with a much faster optical alternative.

Journal Article↗

Highly tunable large-core single-mode liquid-crystal photonic bandgap fiber.

We demonstrate a highly tunable photonic bandgap fiber, which has a large-core diameter of 25 microm and an effective mode area of 440 microm2. The tunability is achieved by infiltrating the air holes of a photonic crystal fiber with an optimized liquid-crystal mixture having a large temperature gradient of the refractive indices at room temperature. A bandgap tuning sensitivity of 27 nm/degrees C is achieved at room temperature. The insertion loss is estimated to be less than 0.5 dB and caused mainly by coupling loss between the index-guided mode and the bandgap-guided mode.

Journal Article↗

Photonic crystal fiber design for broadband directional coupling.

A novel design for a broadband directional coupler based on a photonic crystal fiber is investigated numerically. It is shown that suitable index-depressing doping of the core regions in an index-guiding twin-core photonic crystal fiber can stabilize the coupling coefficient between the cores over an extremely broad (octave-spanning) frequency range.

Journal Article↗

Mode-field radius of photonic crystal fibers expressed by the V parameter.

We numerically calculate the equivalent mode-field radius of the fundamental mode in a photonic crystal fiber (PCF) and show that this is a function of the V parameter only and not the relative hole size. This dependence is similar to what is found for graded-index standard fibers, and we furthermore show that the relation for the PCF can be excellently approximated with the same general mathematical expression. This is to our knowledge the first semianalytical description of the mode-field radius of a PCF.

Journal Article↗

Doped photonic bandgap fibers for short-wavelength nonlinear devices.

Microstructured photonic bandgap fibers with a doped honeycomb cladding structure and the guiding defect defined by the absence of doping are proposed as nonlinear optical fibers for short wavelengths. It is shown that zero-dispersion wavelengths below 500 nm and corresponding effective areas of 1-2 microm2 can be obtained if structures with interhole distances near 600 nm can be fabricated. The cutoff wavelength for guidance of second-order modes can be controlled by variation of the radius and index contrast of the doped regions.

Journal Article↗

Investigation of microdeformation-induced attenuation spectra in a photonic crystal fiber.

We investigate both theoretically and experimentally the induced spectral attenuation in an all-silica photonic crystal fiber subjected to periodic axial microdeformations. The induced attenuation spectra show discrete attenuation peaks with a spectral position that is dependent on the period of the induced deformation. The peaks are assumed to be the result of mode coupling between the fundamental mode and a highly lossy higher-order mode. This assumption is verified through numerical calculation of the beat length between these two modes. Excellent agreement between experiment and numerical predictions of the spectral position of the attenuation peaks is obtained.

Journal Article↗