PubMed Health⌕ Search

Biomedical subjects

André Laschewsky

Publications and source records attributed to André Laschewsky.

12 recordsLinked to original sources
PubMed2007

Design, synthesis, and aqueous aggregation behavior of nonionic single and multiple thermoresponsive polymers.

Nonionic water-soluble poly(acrylamide)s and poly(acrylate)s were synthesized by RAFT and ATRP methods. Similar to the synthesized poly(N-isopropylacrylamide) and poly(N-acryloylpyrrolidine), aqueous solutions of statistical acrylate copolymers bearing two different oligo(ethylene oxide) side chains showed a sharp clouding transition upon heating beyond characteristic temperatures. The temperature of the cloud point can be easily fine tuned by the copolymer composition. As for poly(N-isopropylacrylamide) and poly(N-acryloylpyrrolidine), the cloud-point temperatures of these statistical copolymers are rather insensitive to changes in the molar mass or the NaCl content of the solutions. Also, ternary triblock copolymers containing one permanently hydrophilic block and two different thermoresponsive blocks were synthesized, varying the block sequence systematically. Their aggregation in aqueous solution was followed by turbidimetry and dynamic light scattering. Depending on the heating process and the triblock sequence, micellar aggregates of 40 to 600 nm size were found. The thermally induced aggregation behavior depends sensitively on the block sequence but is also subject to major kinetic effects. For certain block sequences, a thermally induced two-step association is observed when heating beyond the first and second cloud points of the thermoresponsive blocks. However, the thermal-transition temperatures of the block polymers can differ from the thermal-transition temperatures of the individual homopolymers. This may be caused by end-group effects but also by mutual interactions of the different blocks in solution, as physical mixtures of the homopolymers exhibit deviations from a purely additive thermal behavior.

Journal Article↗
PubMed2006

ESR spin probes in ionic liquids.

The spin probes 2,2,6,6-tetramethylpiperidine-1-oxyl (TEMPO), 4-hydroxy-2,2,6,6-tetramethylpiperidine-1-oxyl (TEMPOL), and 2,2,6,6-tetramethyl-4-trimethylammoniumpiperidine-1-oxylIodide (CAT-1) are examined in a number of ionic liquids based on substituted imidazolium cations and tetrafluoroborate and hexafluorophosphate anions, respectively. The reorientation correlation times tau(R) of the spin probes in these systems have been determined by complete spectra simulation and, for rapid reortientation, by analysis of the intensities of the hyperfine lines of the electron spin resonance (ESR) spectra. A comparison of the results with those from the model system glycerol/water and selected organic solvents is made. Additions of diamagnetic and paramagnetic ions allow the conclusion that salt effects and spin exchange are present, and that both are superimposed by motional effects. Specific interactions in the ionic liquids, as well as between the spin-probe molecules and the constituents of the ionic liquids are reflected in the spectra of the spin probes, depending on their molecular structure.

Anions↗
PubMed2006

New amphiphilic diblock copolymers: surfactant properties and solubilization in their micelles.

Several series of amphiphilic diblock copolymers are investigated as macrosurfactants in comparison to reference low-molar-mass and polymeric surfactants. The various copolymers share poly(butyl acrylate) as a common hydrophobic block but are distinguished by six different hydrophilic blocks (one anionic, one cationic, and four nonionic hydrophilic blocks) with various compositions. Dynamic light scattering experiments indicate the presence of micelles over the whole concentration range from 10(-4) to 10 g x L(-1). Accordingly, the critical micellization concentrations are very low. Still, the surface tension of aqueous solutions of block copolymers decreases slowly but continuously with increasing concentration, without exhibiting a plateau. The longer the hydrophobic block, the shorter the hydrophilic block, and the less hydrophilic the monomer of the hydrophilic block is, the lower the surface tension is. However, the effects are small, and the copolymers reduce the surface tension much less than standard low-molar-mass surfactants. Also, the copolymers foam much less and even act as anti-foaming agents in classical foaming systems composed of standard surfactants. The copolymers stabilize O/W emulsions made of methyl palmitate as equally well as standard surfactants but are less efficient for O/W emulsions made of tributyrine. However, the copolymer micelles exhibit a high solubilization power for hydrophobic dyes, probably at their core-corona interface, in dependence on the initial geometry of the micelles and the composition of the block copolymers. Whereas micelles of copolymers with strongly hydrophilic blocks are stable upon solubilization, solubilization-induced micellar growth is observed for copolymers with moderately hydrophilic blocks.

Journal Article↗
PubMed2006

Aggregation numbers of cationic oligomeric surfactants: a time-resolved fluorescence quenching study.

The micelle aggregation numbers (N(agg)) of several series of cationic oligomeric surfactants were determined by time-resolved fluorescence quenching (TRFQ) experiments, using advantageously 9,10-dimethylanthracene as fluorophore. The study comprises six dimeric ("gemini"), three trimeric, and two tetrameric surfactants, which are quaternary ammonium chlorides, with medium length spacer groups (C(3)-C(6)) separating the individual surfactant fragments. Two standard cationic surfactants served as references. The number of hydrophobic chains making up a micellar core is relatively low for the oligomeric surfactants, the spacer length playing an important role. For the dimers, the number decreases from 32 to 21 with increasing spacer length. These numbers decrease further with increasing degree of oligomerization down to values of about 15. As for many conventional ionic surfactants, the micelles of all oligomers studied grow only slightly with the concentration, and they remain in the regime of small micelles up to concentrations of at least 3 wt %.

Journal Article↗
PubMed2005

Cationic and perfluorinated polymeric pseudostationary phases for electrokinetic chromatography.

Separation selectivity in electrokinetic chromatography (EKC) is directly affected by the chemistry and solvent characteristics of the pseudostationary phase (PSP). The chemical selectivity of micellar PSPs has been previously demonstrated to vary significantly between anionic and cationic surfactants as well as between hydrocarbon and fluorocarbon surfactants. Polymeric PSPs have also been demonstrated to provide unique selectivity. In the current study, four cationic polymeric pseudo-stationary phases, two of which have perfluorinated pendant groups, are introduced and characterized as PSPs in EKC. Their performance and selectivity is compared to conventional micellar PSPs with similar structure. The solvation characteristics and selectivity of the four polymers most closely resemble those observed for cationic micelles. The polymers are all more cohesive and more polar than their hydrocarbon micellar counterparts. The fluorocarbon PSPs did show preferential interaction with fluorocarbon solutes, were somewhat more cohesive, and were stronger hydrogen bond donors. However, the presence of fluorocarbon moieties did not have as dramatic an effect on selectivity as was observed and published previously for fluorocarbon micelles. This may result from the selectivity being dominated by the presence of the cationic head groups or from the fluorocarbon character of the pendant groups being moderated by the presence of hydrocarbon functionality on the polymer backbones.

Cations↗
PubMed2005

Synthesis and properties of cationic oligomeric surfactants.

Three series of new oligomeric cationic surfactants were synthesized. These amphiphiles are trimeric and tetrameric oligomeric quaternary ammonium chlorides, with spacer groups of different lengths separating the individual surfactant fragments. The properties of the compounds, such as Krafft temperatures, surface activity, micellization, viscosifying effects, foaming and solubilizing capacity, are studied. The influence of the degree of oligomerization and of the spacer group on the surfactant properties is discussed, in comparison with the analogous standard monomeric and dimeric ("gemini") surfactants. Typically, the evolution of the properties observed from standard to dimeric surfactants progresses with the trimers and tetramers, resulting for instance in extremely low critical micellization concentrations.

Journal Article↗
PubMed2005

Interaction forces between cellulose microspheres and ultrathin cellulose films monitored by colloidal probe microscopy-effect of wet strength agents.

Colloidal probe microscopy was employed to study forces between cellulose surfaces upon addition of a series of cationic copolymers in aqueous solution, as model compounds for wet strength agents. The content of quaternary ammonium groups and primary amines was systematically varied in the cationic polymers, to distinguish between the importance of electrostatical and H-bonding effects. Cellulose microspheres were glued at the apex of tipless microfabricated cantilevers and used as colloidal probes. Ultra thin cellulose films and cellulose fibres were employed as model surfaces. The cellulose films of a thickness of about 5 nm were spin-coated from cellulose solution onto silicon substrates. The root-mean-square-roughness (RMS) was 0.3-0.8 nm. The cationic model polymers were compared to Servamine, a polymer employed as standard wet strength resin in papermaking industries. Force versus separation measurements showed a detailed picture of adhesion and contact breaking. Relatively strong adhesion of the order of 0.3 mJ/m(2) was observed with Servamine within a range of approximately 10 nm. At larger distances weak bond breaking and elastic chain pulling were identified. When approaching the surface one to two small jump-in's possibly related to strong binding of Servamine and subsequent attraction could be found in the case of Servamine. In contrast, all the model copolymers showed only a weak adhesion of 8-30 micro/m(2), i.e., an order of magnitude less than that of Servamine and subsequent elastic rupture domains. The contour length, persistence length and characteristic rupture distances were calculated by means of applying the WLC model. Measurements against cellulose fibres obtained from the production process proved the relevance of the model systems.

Amines↗
PubMed2003

Ordered polyelectrolyte multilayers. Rules governing layering in organic binary multilayers.

We study the growth and internal structure of polyelectrolyte multilayers obtained by combining three polyanions with nine polycations of the ionene family, of systematically varied chemical architecture. We find that, contrary to a generally held belief, ordered organic multilayers are by no way exceptional, provided one of the polyelectrolytes bears groups which induce structure in water, such as long hydrophobic segments or mesogenic groups. However, this condition is not sufficient, as order will or will not emerge in the multilayer depending on the specific pairing of the polyelectrolytes. The results support the notion that layering in the multilayer results from some degree of prestructuring of a water-swollen layer adsorbed during each step of deposition. These findings pave the way to new possible uses of polyelectrolyte multilayers, for example, for applications requiring preferential alignment or strong confinement of specific functional groups.

Journal Article↗
PubMed2002

Synthesis and properties of water-soluble gold colloids covalently derivatized with neutral polymer monolayers.

Citrate-capped gold nanoparticles as well as planar gold surfaces can be efficiently grafted with a covalently attached polymer monolayer a few nanometers thick, by simple contact of the metal surface with dilute aqueous solutions of hydrophilic polymers that are end-capped with disulfide moieties, as shown by UV/vis absorption, dynamic light scattering, and surface plasmon resonance studies. The hydrophilic polymer-coated gold colloids can be freeze-dried and stored as powders that can be subsequently dissolved to yield stable aqueous dispersions, even at very large concentrations. They allow for applying filtrations, gel permeation chromatography, or centrifugation. They do not suffer from undesirable nonspecific adsorption of proteins while allowing the diffusion of small species within the hydrogel surface coating. In addition, specific properties of the original hydrophilic polymers are retained such as a lower critical solution temperature. The latter feature could be useful to enhance optical responses of functionalized gold surfaces toward interaction with various substrates.

Journal Article↗
PubMed2002

Switching the inside and the outside of aggregates of water-soluble block copolymers with double thermoresponsivity.

Water-soluble block copolymers were prepared from the nonionic monomer N-isopropylacrylamide (NIPA) and the zwitterionic monomer 3-[N-(3-methacrylamidopropyl)-N,N-dimethyl]ammoniopropane sulfonate (SPP) by sequential free radical polymerization via the RAFT process. Such block copolymers with two hydrophilic blocks exhibit double thermoresponsive behavior in water: the poly-NIPA block shows a lower critical solution temperature, whereas the poly-SPP block exhibits an upper critical solution temperature. Appropriate design of the block lengths leads to block copolymers which stay in solution in the full temperature range between 0 and 100 degrees C. Both blocks of these polymers dissolve in water at intermediate temperatures, whereas at high temperatures, the poly-NIPA block forms colloidal hydrophobic associates that are kept in solution by the poly-SPP block, and at low temperatures, the poly-SPP block forms colloidal polar aggregates that are kept in solution by the poly-NIPA block. In this way, colloidal aggregates which switch reversibly can be prepared in water, and without any additive, their "inside" to the "outside", and vice versa. The aggregates provide microdomains and surfaces of different character, which can be controlled by a simple thermal stimulus.

Journal Article↗