PubMed Health⌕ Search

Biomedical subjects

Andreas Cederlund

Publications and source records attributed to Andreas Cederlund.

2 recordsLinked to original sources

Chimeric small subunits influence catalysis without causing global conformational changes in the crystal structure of ribulose-1,5-bisphosphate carboxylase/oxygenase.

Comparison of subunit sequences and X-ray crystal structures of ribulose-1,5-bisphosphate carboxylase/oxygenase indicates that the loop between beta-strands A and B of the small subunit is one of the most variable regions of the holoenzyme. In prokaryotes and nongreen algae, the loop contains 10 residues. In land plants and green algae, the loop is comprised of approximately 22 and 28 residues, respectively. Previous studies indicated that the longer betaA-betaB loop was required for the assembly of cyanobacterial small subunits with plant large subunits in isolated chloroplasts. In the present study, chimeric small subunits were constructed by replacing the loop of the green alga Chlamydomonas reinhardtii with the sequences of Synechococcus or spinach. When these engineered genes were transformed into a Chlamydomonas mutant that lacks small-subunit genes, photosynthesis-competent colonies were recovered, indicating that loop size is not essential for holoenzyme assembly. Whereas the Synechococcus loop causes decreases in carboxylation V(max), K(m)(O(2)), and CO(2)/O(2) specificity, the spinach loop causes complementary decreases in carboxylation V(max), K(m)(O(2)), and K(m)(CO(2)) without a change in specificity. X-ray crystal structures of the engineered proteins reveal remarkable similarity between the introduced betaA-betaB loops and the respective loops in the Synechococcus and spinach enzymes. The side chains of several large-subunit residues are altered in regions previously shown by directed mutagenesis to influence CO(2)/O(2) specificity. Differences in the catalytic properties of divergent Rubisco enzymes may arise from differences in the small-subunit betaA-betaB loop. This loop may be a worthwhile target for genetic engineering aimed at improving photosynthetic CO(2) fixation.

Animals↗

Do intact collagen fibers increase dentin bond strength?

The purpose of the present study was to evaluate surface morphology and shear bond strength of All Bond 2 bonded to dentin surfaces, that were treated progressively to remove collagen fibers. For the study of surface morphology, fifteen teeth were divided in to five groups. Dentin surfaces in groups 1-4 were etched either with 24% EDTA for 30 seconds or 32% phosphoric acid for 15 seconds with and without subsequent treatment with 10% NaOCl for 60 seconds. Group 5 received no treatment and served as control. Evaluation was performed using scanning electron microscopy. Thirty teeth were used for the shear bond strength test. Two experimental surfaces were prepared on each tooth and cylindrical copper matrixes were attached to the surfaces. Experimental surfaces were divided into four groups and treated in the same way as group 1-4 in the morphology part of the study. Dentin was bonded with All Bond 2, after which a flowable composite was inserted and light cured. Shear strength test was performed at a crosshead speed of 1 mm/minute until the composite debonded. Results showed that etching followed by treatment with NaOCl removed all collagen fibers from the dentin surfaces, while treatment with EDTA alone denuded the fiber structures. Shear strength was significantly decreased when surfaces were treated with NaOCl. The highest shear strength values were obtained in the EDTA etched group. The results from the present study indicate that exposed dentin associated collagen fibers increases adhesion of All Bond 2 to dentin.

Acid Etching, Dental↗