Andrew P Dooris | PubMed Health

PubMed2006

In vitro wear assessment of the Charité Artificial Disc according to ASTM recommendations.

STUDY DESIGN: Biomechanical laboratory research. OBJECTIVE: To evaluate the potential for Ultra High Molecular Weight Polyethylene (UHMWPE) wear debris from the Charité Artificial Disc. SUMMARY OF BACKGROUND DATA: Cases of osteolysis from artificial discs are extremely rare, but hip and knee studies demonstrate the osteolytic potential and clinical concern of UHMWPE wear debris. Standards for testing artificial discs continue to evolve, and there are few detailed reports of artificial disc wear characterizations. METHODS: Implant assemblies were tested to 10 million cycles of +/- 7.5 degrees flexion-extension or +/- 7.5 degrees left/right lateral bending, both with +/- 2 degrees axial rotation and 900 N to 1,850 N cyclic compression. Cores were weighed, measured, and photographed. Soak and loaded soak controls were used. Wear debris was analyzed via scanning electron microscopy and particle counters. RESULTS: The average total wear of the implants was 0.11 and 0.13 mg per million cycles, before and after accounting for serum absorption, respectively. Total height loss was approximately 0.2 mm. Wear debris ranged from submicron to > 10 microm in size. CONCLUSIONS: Under these test conditions, the Charité Artificial Disc produced minimal wear debris. Debris size and morphology tended to be similar to other CoCr-UHMWPE joints. More testing is necessary to evaluate the implants under a spectrum of loading conditions.

Equipment Design↗

PubMed2006

Test protocols for evaluation of spinal implants.

Prior to implantation, medical devices are subjected to rigorous testing to ensure safety and efficacy. A full battery of testing protocols for implantable spinal devices may include many steps. Testing for biocompatibility is a necessary first step. On selection of the material, evaluation protocols should address both the biomechanical and clinical performance of the device. Before and during mechanical testing, finite element modeling can be used to optimize the design, predict performance, and, to some extent, predict durability and efficacy of the device. Following bench-type evaluations, the biomechanical characteristics of the device (e.g., motion, load-sharing, and intradiscal pressure) can be evaluated with use of fresh human cadaveric spines. The information gained from cadaveric testing may be supplemented by the finite element model-based analyses. Upon the successful completion of these tests, studies that make use of an animal model are performed to assess the structure, function, histology, and biomechanics of the device in situ and as a final step before clinical investigations are initiated. The protocols that are presently being used for the testing of spinal devices reflect the basic and applied research experience of the last three decades in the field of orthopaedic biomechanics in general and the spine in particular. The innovation within the spinal implant industry (e.g., fusion devices in the past versus motion-preservation devices at present) suggests that test protocols represent a dynamic process that must keep pace with changing expectations. Apart from randomized clinical trials, no single test can fully evaluate all of the characteristics of a device. Due to the inherent limitations of each test, data must be viewed in a proper context. Finally, a case is made for the medical community to converge toward standardized test protocols that will enable us to compare the vast number of currently available devices, whether on the market or still under development, in a systematic, laboratory-independent manner.

Animals↗