Biomedical subjects

Andy Sweetman

Publications and source records attributed to Andy Sweetman.

4 recordsLinked to original sources

PubMed2006

Passive sampler-derived air concentrations for polybrominated diphenyl ethers and polycyclic aromatic hydrocarbons in Kuwait.

The present study presents, to our knowledge, the first ambient air data for a range of polybrominated diphenyl ethers (PBDEs) and polycyclic aromatic hydrocarbons (PAHs) in Kuwait. This was achieved by concurrently deploying polyurethane foam-disk passive samplers at 14 sites over a six-week period. Calculated mean sigma5PBDE concentrations (sum of brominated diphenyl ethers [BDEs] 47, 99, 100, 153, and 154) ranged from 2.5 to 32 pg/m3 of air, with BDE 47 contributing between 39 and 65% of the sigmaPBDEs detected. Differences in relative concentrations were observed between sites, with higher concentrations measured close to suspected sources. Calculated sigmaPAH concentrations ranged from 5 to 13 ng/m3 (mean, 8.3 ng/m3). The compound distribution was dominated by three- and four-ring compounds, which constituted approximately 90% of the sigmaPAHs, with phenanthrene contributing approximately 35%. However, the proportion of five- and six-ring PAHs increased around the "oil lakes," which were formed by the torching of oil wells during the 1991 Gulf War. The oil lakes are a reservoir of PAHs that will continue feeding the atmosphere as long as they remain untreated.

Air Pollutants↗

PubMed2004

Occupational exposure to dioxins at UK worksites.

Following a request from a Governmental Interdepartmental Group, the Health and Safety Executive undertook a polychlorinated dibenzo-p-dioxin (PCDD) and polychorinated dibenzofuran (PCDF) sampling exercise at several work sites in the UK. An initial survey suggested potential PCDD/F production at metal recycling sites, during cement manufacture, at municipal waste incinerators and landfill sites and during the use of thermal oxygen lances. PCDD/F sampling, using static and personal air samplers, revealed that the highest PCDD/F exposures were found at metal recycling sites, particularly aluminium recycling sites. The reasons for these results and the possible consequential intakes are discussed.

Air Pollutants, Occupational↗

PubMed2002

Towards a global historical emission inventory for selected PCB congeners--a mass balance approach. 1. Global production and consumption.

Information on the historical global production and consumption of polychlorinated biphenyls (PCBs) is urgently needed for estimating PCB fluxes to the environment and for interpreting global contamination patterns by these pollutants. This study presents the methodology, principal uncertainties and selected results from an inventory, aiming to quantify the global production and consumption of total PCBs as well as 22 PCB congeners. The available data on the historical production of PCBs and the chemical composition of various technical mixtures have been compiled from the literature. For some producers with less detailed information, the production of individual PCB constituents has been estimated to derive a global estimate for individual homologues and selected congeners. Information on imports, exports and consumption, as well as restrictions on production and imports, has further been compiled for individual countries. These data, along with assumptions on the trade between countries and regions, have been utilised to derive an estimate of the global historical consumption pattern. Although there are substantial uncertainties involved in these estimates, important aspects governing the large scale temporal and spatial patterns are most likely captured in these estimates. In particular, the information on imports and exports for the principal users of PCBs around the time of peak production is considered to be fairly reliable. The estimates account for a reported historical global production of approximately 1.3 million t PCBs, more than 70% of which are tri-, tetra- and pentachlorinated biphenyls. The results further suggest that almost 97% of the global historical use of PCBs have occurred in the Northern Hemisphere.

Environmental Pollutants↗

PubMed2002

Towards a global historical emission inventory for selected PCB congeners--a mass balance approach. 2. Emissions.

Accurate and complete data on the global atmospheric releases (emissions) of individual PCB congeners are essential to study source-receptor relationships and contamination patterns in remote areas, such as the Arctic. Information on the anthropogenic emissions may also be useful for the interpretation of measured levels and patterns of atmospheric PCBs. This study builds upon an accompanying paper, presenting an estimate of the global historical production and consumption of 22 PCB congeners (Breivik K, Sweetman A, Pacyna JM, Jones KC. Towards a global historical emission inventory for selected PCB congeners--a mass balance approach. 1. Global production and consumption. Sci Total Environ, submitted). Here, a dynamic mass balance model is elaborated, parameterised and applied in an attempt to estimate the historical anthropogenic emissions as a direct result of the widespread usage of PCBs for a period of 70 years. This paper presents details of the mass balance approach, along with a discussion of the major uncertainties. It is shown that the diversity of historical usage, disposal and accidental release pathways makes it an extremely difficult task to bridge the gap between consumption and emissions, resulting in an equally complex and diverse true emission pattern. These results may therefore at best represent order-of-magnitude estimates only and the results in absolute terms should be treated with great caution. In spite of these uncertainties, useful information can still be gained. The results suggest that temperature is an extremely important factor controlling both emission amount as well as the emission pattern of PCBs. In particular, the emissions of the more chlorinated (and persistent) PCB congeners appear to be significantly influenced by (uncontrolled) high-temperature sources. As a consequence, it may prove warranted to undertake further measures to avoid that contaminated materials are subject to elevated temperatures and uncontrolled burning. It is furthermore suggested that efforts should be directed towards a better characterisation and quantification of these potentially important release pathways. In addition, alternative approaches to bridge the gap between consumption and emissions in quantitative terms should be considered in order to improve these estimates.

Arctic Regions↗