Biomedical subjects

Antonio M Rabasco

Publications and source records attributed to Antonio M Rabasco.

4 recordsLinked to original sources

PubMed2005

Release of indomethacin from ultrasound dry granules containing lactose-based excipients.

Physical mixtures were prepared containing indomethacin and beta-lactose and alpha-lactose-based excipients (Ludipress and Cellactose). The mixtures were compacted with the aid of ultrasound, obtaining tablets, which were milled and sieved. Granules thus obtained were examined by optical microscopy and differential scanning calorimetry. The intense yellow color of the granules and the absence of indomethacin peak in thermograms suggest important modifications of indomethacin physical state; the drug thus modified appears to be spread on the excipient particle surface as a thin film, giving a lustrous appearance. No influence of ultrasound was observed on phase transition concerning lactose; only loss of water was important under high energy ultrasound. Dissolution profiles suggest an increased release of the drug from the systems treated with ultrasound at high energy, with respect to a traditional compaction; while no difference could be evidenced among the three excipients that, however, appear all suitable for this ultrasound-aided direct compression process.

Drug Industry↗

PubMed2005

Diclofenac salts, II. Solid dispersions in PEG6000 and Gelucire 50/13.

A number of systems were prepared at five compositions (5, 10, 20, 30 and 40% w/w) of diclofenac/N-(2-hydroxyethyl) pyrrolidine salt and acidic diclofenac in PEG6000 and Gelucire 50/13, as physical mixtures and as solid dispersions. Powder X-ray diffractograms for the systems examined show shifted and normal peaks, suggesting that the drug is present inside the samples in different physical states. Differential scanning calorimetry does not offer important information, since drug solubility into the carriers increases with temperature and thermograms show only the melting point peak of the carriers. Hot-stage microscopy examination explains that, in high concentration samples, the drug is present either dissolved into the carriers, or precipitated as microcrystals, or undissolved crystals of larger size. Gelucire 50/13 allows the formation of larger crystals than PEG, using both the chemical forms of the drug. The release percentage of the drug from PEG6000/acidic diclofenac reaches 50% after few minutes in the most favourable case and appears to be dependent on the composition of the samples: the more diclofenac is present as dissolved in the pre-treated samples, the higher is the release. The optimum composition was found in the range of 5-10% w/w.

Anti-Inflammatory Agents, Non-Steroidal↗

PubMed2002

Didanosine extended-release matrix tablets: optimization of formulation variables using statistical experimental design.

Statistical experimental design was applied to evaluate the influence of some process and formulation variables and possible interactions among such variables, on didanosine release from directly-compressed matrix tablets based on blends of two insoluble polymers, Eudragit RS-PM and Ethocel 100, with the final goal of drug release behavior optimization. The considered responses were the percent of drug released at three determined times, the dissolution efficiency at 6 h and the time to dissolve 10% of drug. Four independent variables were considered: tablet compression force, ratio between the polymers and their particle size, and drug content. The preliminary screening step, carried out by means of a 12-run asymmetric screening matrix according to a D-optimal design strategy, allowed evaluation of the effects of different levels of each variable. The drug content and the polymers ratio had the most important effect on drug release, which, moreover, was favored by greater polymers particle size; on the contrary the compression force did not have a significant effect. The Doehlert design was then applied for a response-surface study, in order to study in depth the effects of the most important variables. The desirability function was used to simultaneously optimize the five considered responses, each having a different target. This procedure allowed selection, in the studied experimental domain, of the best formulation conditions to optimize drug release rate. The experimental values obtained from the optimized formulation highly agreed with the predicted values. The results demonstrated the reliability of the model in the preparation of extended-release matrix tablets with predictable drug release profiles.

Anti-HIV Agents↗

PubMed2002

Development of sustained release matrix tablets of didanosine containing methacrylic and ethylcellulose polymers.

Didanosine, a nucleoside analog used in the treatment of acquired immuno deficiency syndrome (AIDS), has been incorporated into directly compressed monolythic matrices whose excipients were mixtures at different ratios of a methacrylic resin (Eudragit RSPM) and an ethylcellulose (Ethocel 100), both water-insoluble and pH-independent polymers. Technological characterization (drug particle morphology, mean weight, diameter, thickness and hardness of tablets) was carried out and in vitro drug release behaviour was measured using the USP basket apparatus. The effect of varying the Eudragit-Ethocel ratio, as well as the drug-polymeric matrix ratio, was evaluated. The results showed the suitability of Eudragit-Ethocel mixtures as matrix-forming material for didanosine sustained release formulations. Combination of the moderate swelling properties of Eudragit RSPM with the plastic properties of the more hydrophobic Ethocel 100 allowed suitable modulation of didanosine release.

Anti-HIV Agents↗