Biomedical subjects

Ayelet Vilan

Publications and source records attributed to Ayelet Vilan.

4 recordsLinked to original sources

PubMed2006

Energy level and band alignment for GaAs-alkylthiol monolayer-Hg junctions from electrical transport and photoemission experiments.

A series of p- and n-GaAs-S-C(n)H(2n+1) || Hg junctions are prepared, and the electronic transport through them is measured. From current-voltage measurements, we find that, for n-GaAs, transport occurs by both thermionic emission and tunneling, with the former dominating at low forward bias and the latter dominating at higher forward bias. For p-GaAs, tunneling dominates at all bias voltages. By combining the analysis of the transport data with results from direct and inverse photoemission spectroscopy, we deduce an energy band diagram of the system, including the tunnel barrier and, with this barrier and within the Simmons tunneling model, extract an effective mass value of 1.5-1.6m(e) for the electronic carriers that cross the junctions. We find that transport is well-described by lowest unoccupied and highest occupied states at 1.3-1.4 eV above and 2.0-2.2 eV below the Fermi level. At the same time, the photoemission data indicate that there are continua of states from the conduction band minimum and the valence band maximum, the density of which varies with energy. On the basis of our results, it appears likely that, for both types of junctions, electrons are the main carrier type, although holes may contribute significantly to the transport in the p-GaAs system.

Journal Article↗

PubMed2005

Effect of molecular binding to a semiconductor on metal/molecule/semiconductor junction behavior.

Diodes made by (indirectly) evaporating Au on a monolayer of molecules that are adsorbed chemically onto GaAs, via either disulfide or dicarboxylate groups, show roughly linear but opposite dependence of their effective barrier height on the dipole moment of the molecules. We explain this by Au-molecule (electrical) interactions not only with the exposed end groups of the molecule but also with its binding groups. We arrive at this conclusion by characterizing the interface by in situ UPS-XPS, ex situ XPS, TOF-SIMS, and Kelvin probe measurements, by scanning microscopy of the surfaces, and by current-voltage measurements of the devices. While there is a very limited interaction of Au with the dicarboxylic binding groups, there is a much stronger interaction with the disulfide groups. We suggest that these very different interactions lead to different (growth) morphologies of the evaporated gold layer, resulting in opposite effects of the molecular dipole on the junction barrier height.

Journal Article↗

PubMed2002

How organic molecules can control electronic devices.

This article examines a somewhat counter-intuitive approach to molecular-based electronic devices. Control over the electronic energy levels at the surfaces of conventional semiconductors and metals is achieved by assembling on the solid surfaces, poorly organized, partial monolayers (MLs) of molecules instead of the more commonly used ideal ones. Once those surfaces become interfaces, these layers exert electrostatic rather than electrodynamic control over the resulting devices, based on both electrical monopole and dipole effects of the molecules. Thus electronic transport devices, incorporating molecules, can be constructed without current flow through the molecules. This is illustrated for a gallium arsenide (GaAs) sensor as well as for gold-silicon (Au-Si) and Au-GaAs diodes. Incorporating molecules into solid interfaces becomes possible, using a 'soft' electrical contacting procedure, so as not to damage the molecules. Because there are only a few molecular restrictions, this approach opens up possibilities for the use of more complex (including biologically active) molecules as it circumvents requirements for ideal MLs and for molecules that can tolerate actual electron transport through them.

Biosensing Techniques↗

PubMed2002

Molecular engineering of semiconductor surfaces and devices.

Grafting organic molecules onto solid surfaces can transfer molecular properties to the solid. We describe how modifications of semiconductor or metal surfaces by molecules with systematically varying properties can lead to corresponding trends in the (electronic) properties of the resulting hybrid (molecule + solid) materials and devices made with them. Examples include molecule-controlled diodes and sensors, where the electrons need not to go through the molecules (action at a distance), suggesting a new approach to molecule-based electronics.

Journal Article↗