Biomedical subjects
Publications and source records attributed to B Luckow.
Reporter plasmids utilizing the cat gene for the analysis of promoter and enhancer sequences in vertebrate cells, were constructed. These plasmids minimize the background of transcription derived from cryptic promoters or cryptic regulatory elements within the vector.
Cyclic AMP treatment of hepatoma cells leads to increased protein binding at the cyclic AMP response element (CRE) of the tyrosine aminotransferase (TAT) gene in vivo, as revealed by genomic footprinting, whereas no increase is observed at the CRE of the phosphoenolpyruvate carboxykinase (PEPCK) gene. Several criteria establish that the 43 kDa CREB protein is interacting with both of these sites. Two classes of CRE with different affinity for CREB are described. One class, including the TATCRE, is characterized by asymmetric and weak binding sites (CGTCA), whereas the second class containing symmetrical TGACGTCA sites shows a much higher binding affinity for CREB. Both classes show an increase in binding after phosphorylation of CREB by protein kinase A (PKA). An in vivo phosphorylation-dependent change in binding of CREB increases the occupancy of weak binding sites used for transactivation, such as the TATCRE, while high affinity sites may have constitutive binding of transcriptionally active and inactive CREB dimers, as demonstrated by in vivo footprinting at the PEPCK CRE. Thus, lower basal level and higher relative stimulation of transcription by cyclic AMP through low affinity CREs should result, allowing finely tuned control of gene activation.
The chicken lysozyme gene is constitutively expressed in macrophages, in oviduct cells its expression is controlled by steroid hormones, and in fibroblasts the gene is not expressed. A fusion gene consisting of promoter sequences of the lysozyme gene from -208 to +15 in front of the chloramphenicol acetyltransferase (CAT) coding region was more than 50 times less active in non-expressing cells as compared to expressing cells. In order to identify the element(s) responsible for this cell-type specificity 31 different linker scanning mutations were generated within this promoter fragment and analyzed by transient transfections in the three types of chicken cells mentioned above. Three mutation sensitive regions located around position -25, -100 and between -158 and -208 were detected in each cell type, however, several LS mutations displayed clear cell-type specific differences in their phenotypic effects. Interestingly, a few LS mutations led to an increase in promoter activity in fibroblasts suggesting that the corresponding wildtype sequences represent binding sites for negatively acting transcription factors.
Explore the source record for details and available documents.
A new procedure for the construction of linker scanning mutants is described. A plasmid containing the target DNA is randomly linearized and slightly shortened by a novel combination of established methods. After partial apurination with formic acid a specific nick or small gap is introduced at the apurinic site by exonuclease III, followed by nuclease S1 cleavage of the strand opposite the nick/gap. Synthetic linkers are ligated to the ends and plasmids having the linker inserted in the target DNA are enriched. Putative linker scanning mutants are identified by their topoisomer patterns after relaxation with topoisomerase I. This technique allows the distinction of plasmids differing in length by a single basepair. We have used this rapid and efficient strategy to generate a set of 32 linker scanning mutants covering the chicken lysozyme promoter from -208 to +15.