Biomedical subjects

B R Constantz

Publications and source records attributed to B R Constantz.

5 recordsLinked to original sources

PubMed1999

Biomechanical evaluation of fixation of intra-articular fractures of the distal part of the radius in cadavera: Kirschner wires compared with calcium-phosphate bone cement.

BACKGROUND: The purpose of this study was to compare the biomechanical efficacy of an injectable calcium-phosphate bone cement (Skeletal Repair System [SRS]) with that of Kirschner wires for the fixation of intraarticular fractures of the distal part of the radius. METHODS: Colles fractures (AO pattern, C2.1) were produced in ten pairs of fresh-frozen human cadaveric radii. One radius from each pair was randomly chosen for stabilization with SRS bone cement. These ten radii were treated with open incision, impaction of loose cancellous bone with use of a Freer elevator, and placement of the SRS bone cement by injection. In the ten control specimens, the fracture was stabilized with use of two horizontal and two oblique Kirschner wires. The specimens were cyclically loaded to a peak load of 200 newtons for 2000 cycles to evaluate the amount of settling, or radial shortening, under conditions simulating postoperative loading with the limb in a cast. Each specimen then was loaded to failure to determine its ultimate strength. RESULTS: The amount of radial shortening was highly variable among the specimens, but it was consistently higher in the Kirschner-wire constructs than in the bone fixed with SRS bone cement within each pair of radii. The range of shortening for all twenty specimens was 0.18 to 4.51 millimeters. The average amount of shortening in the SRS constructs was 50 percent of that in the Kirschner-wire constructs (0.51+/-0.34 compared with 1.01+/-1.23 millimeters; p = 0.015). With the numbers available, no significant difference in ultimate strength was detected between the two fixation groups. CONCLUSIONS: This study showed that fixation of an intra-articular fracture of the distal part of a cadaveric radius with biocompatible calcium-phosphate bone cement produced results that were biomechanically comparable with those produced by fixation with Kirschner wires. However, the constructs that were fixed with calcium-phosphate bone cement demonstrated less shortening under simulated cyclic load-bearing.

Biomechanical Phenomena↗

PubMed1998

Histological, chemical, and crystallographic analysis of four calcium phosphate cements in different rabbit osseous sites.

Four calcium phosphate cement formulations were implanted in the rabbit distal femoral metaphysis and middiaphysis. Chemical, crystallographic, and histological analyses were made at 2, 4, and 8 weeks after implantation. When implanted into the metaphysis, part of the brushite cement was converted into carbonated apatite by 2 weeks. Some of the brushite cement was removed by mononuclear macrophages prior to its conversion into apatite. Osteoclastlike cell mediated remodeling was predominant at 8 weeks after brushite had converted to apatite. The same histological results were seen for brushite plus calcite aggregate cement, except with calcite aggregates still present at 8 weeks. However, when implanted in the diaphysis, brushite and brushite plus calcite aggregate did not convert to another calcium phosphate phase by 4 weeks. Carbonated apatite cement implanted in the metaphysis did not transform to another calcium phosphate phase. There was no evidence of adverse foreign body reaction. Osteoclastlike cell mediated remodeling was predominant at 8 weeks. The apatite plus calcite aggregate cement implanted in the metaphysis that was not remodeled remained as poorly crystalline apatite. Calcite aggregates were still present at 8 weeks. There was no evidence of foreign body reaction. Osteoclastlike cell remodeling was predominant at 8 weeks. Response to brushite cements prior to conversion to apatite was macrophage dominated, and response to apatite cements was osteoclast dominated. Mineralogy, chemical composition, and osseous implantation site of these calcium phosphates significantly affected their in vivo host response.

Animals↗

PubMed1997

Determining mineral content variations in bone using backscattered electron imaging.

The mechanical properties of bones are greatly influenced by the ratio of organic constituents to mineral. Determination of bone mineral content on a macroscopic scale is straightforward, but microscopic variations, which can yield new insights into remodelling activities, mechanical strength, and integrity, are profoundly more difficult to measure. Measurement of microscopic mineral content variations in bone material has traditionally been performed using microradiography. Backscattered electron (BSE) imaging is a technique with significantly better resolution than microradiography with demonstrated consistency, and it does not suffer from projection-effect errors. We report results demonstrating the applicability of quantitative BSE imaging as a tool for measuring microscopic mineral content variations in bones representing a broad range of mineralization. Bones from ten species were analyzed with Fourier-transformed infrared spectroscopy, X-ray diffraction, energy dispersive X-ray spectrometry, ash measurements, and BSE imaging. BSE image intensity (graylevel) had a very strong positive correlation to mineral (ash) content. Compositional and crystallographic variations among bones had negligible influence on backscattered electron graylevels. The present study confirms the use of BSE imaging as a tool to measure the microscopic mineral variability in a broad range of mineralized tissues.

Animals↗

PubMed1995

Skeletal repair by in situ formation of the mineral phase of bone.

A process has been developed for the in situ formation of the mineral phase of bone. Inorganic calcium and phosphate sources are combined to form a paste that is surgically implanted by injection. Under physiological conditions, the material hardens in minutes concurrent with the formation of dahllite. After 12 hours, dahllite formation was nearly complete, and an ultimate compressive strength of 55 megapascals was achieved. The composition and crystal morphology of the dahllite formed are similar to those of bone. Animal studies provide evidence that the material is remodeled in vivo. A novel approach to skeletal repair is being tested in human trials for various applications; in one of the trials the new biomaterial is being percutaneously placed into acute fractures. After hardening, it serves as internal fixation to maintain proper alignment while healing occurs.

Animals↗

PubMed1991

Solid-state phosphorus-31 nuclear magnetic resonance differentiation of bone mineral and synthetic apatite used to fill bone defects.

Bioabsorption of synthetic apatite compounds used to promote bone healing and remodeling has been difficult to evaluate. In this study, solid-state phosphorus-31 nuclear magnetic resonance (NMR) has been used to characterize and quantitate bone mineral and a synthetic apatite in order to establish a model for bioabsorption studies. Pulverized solid samples of cortical rabbit bone and a synthetic fluoridated apatite were examined in vitro at variable degrees of hydration. A 9.4 T superconducting spectrometer was used to obtain 31P magic angle spinning NMR spectra and T1 relaxation times. Quantitation was attempted in mixed samples using T1 recovery data. Bone mineral and synthetic apatite could be distinguished by chemical shift and T1 relaxation time in variable hydration states, and were readily differentiated in mixtures by their T1 relaxation time. NMR estimates of relative proportions of components in mixed samples were accurate within 2% of evaluations based on weight. Solid-state 31P NMR therefore provides a suitable method for monitoring the bioabsorption of synthetic apatites.

Animals↗