Biomedical subjects

B Renger

Publications and source records attributed to B Renger.

At least 19 recordsLinked to original sources

PubMed2001

[MRI study of left ventricular function in patients with coronary disease and myocardial dysfunction before and after coronary revascularization].

PURPOSE: To evaluate left ventricular (LV) myocardial function in ten patients with coronary artery disease (CAD) preoperatively and 6 months after coronary bypass grafting (CABG) by cardiac MRI. MATERIAL AND METHODS: Ten patients (mean 65.2 +/- 5.9 years) with angiographically proven CAD and an indication for elective CABG underwent prospective evaluation of global LV function and regional wall motion by Cine-MRI at rest using a multiphase FLASH-2D sequence following regions of interest (ROI)-defined diagnostics of regional myocardial wall motion by means of levocardiography. Within the ROIs a total of 613 LV myocardial segments were analyzed preceding and following surgical revascularization. Results were compared with the data of 10 healthy volunteers. RESULTS: Preoperatively, patients showed reduced stroke volume and ejection fraction compared with volunteers (p < 0.01). Enddiastolic wall thickness (EDWT) and systolic wall thickening (SWT) were significantly lower in the patients (p < 0.01). Based on preoperative levocardiography ROI-defined myocardial segments showed a significantly lower preoperative EDWT in areas with wall motion abnormalities (7.4 +/- 2.5 mm; p < 0.01) than in normal myocardium (9.2 +/- 2.1 mm). Ejection fraction (p < 0.05), endsystolic wall thickness, and SWT (p < 0.01) improved significantly after bypass surgery. On ROI-defined analysis myocardial segments with impaired preoperative wall motion (n = 243) showed a significant increase of EDWT, ESWT and SWT (p < 0.01). CONCLUSION: In patients with CAD, cardiac MRI enables the non-invasive determination of postinfarctional LV remodeling with an increased EDWT of myocardial segments with normal regional wall motion and of the improvement in global and regional myocardial function following coronary bypass surgery.

Aged↗

PubMed2000

System performance and variability of chromatographic techniques used in pharmaceutical quality control.

Data representing the routine performance of different chromatographic equipment systems used in pharmaceutical quality control are presented. These performance data allow one to predict long-term relative uncertainties and confidence intervals for different chromatographic procedures and techniques. From the variability that is to be expected, it is apparent that many chromatographic procedures run as routine applications in the pharmaceutical industry are unlikely to be capable of controlling the tight specification limits like those usually demanded for bulk drug substances (active pharmaceutical ingredients), the European 95-105% expectation for finished drugs, or to be used in stability studies.

Chromatography, High Pressure Liquid↗

PubMed2000

Selenium-based digital radiography in the detection of bone lesions: preliminary experience with experimentally created defects.

PURPOSE: To compare the diagnostic performance of selenium-based digital radiography with that of conventional screen-film radiography and storage phosphor radiography for the detection of bone lesions simulating osteolyses. MATERIALS AND METHODS: Artificial osseous lesions 1.0-3.0 mm in diameter were created in 80 of 160 predefined regions in 16 porcine femoral specimens. Specimens were enclosed in containers filled with paraffin to ensure accurate repositioning and to obtain an absorption condition comparable to that of a human extremity. Imaging was performed with a selenium-based digital radiography system, a conventional screen-film system, and a storage phosphor radiography system with an exposure identical to that used during clinical imaging. The presence of a lesion was assessed with a five-point confidence scale. Receiver operating characteristic (ROC) analysis was performed for a total of 1,440 observations (480 per modality), and diagnostic performance was estimated with the area under the ROC curve (A(z)). Differences in diagnostic performance were assessed with the paired Student t test. RESULTS: ROC analysis results showed A(z) values of 0.656 for selenium-based digital radiography, 0.679 for storage phosphor radiography, and 0.680 for conventional screen-film radiography. Differences between the three modalities were not significant (P =.60-.93). CONCLUSION: Image quality with selenium-based digital radiography was comparable to that with conventional screen-film radiography and storage phosphor radiography.

Animals↗

PubMed2000

Optimized activation of the primary sensorimotor cortex for clinical functional MR imaging.

BACKGROUND AND PURPOSE: One application of functional MR imaging is to identify the primary sensorimotor cortex (M1 and S1) around the central sulcus before brain surgery. However, it has been shown that undesirable coactivation of nonprimary motor areas, such as the supplementary motor area and the premotor area, can interfere with the identification of the primary motor cortex, especially in patients with distorted anatomic landmarks. We therefore sought to design a simple functional MR imaging paradigm for selective activation of the primary sensorimotor cortex. METHODS: Different paradigms using finger tapping for motor activation were examined and compared with respect to the distribution of activated voxels in primary and nonprimary cortical areas. Studies were conducted in 14 healthy volunteers using a blood oxygen level-dependent multislice echo-planar imaging sequence. RESULTS: The most selective activation of the primary sensorimotor cortex was obtained with a paradigm combining right-sided finger tapping as the activation condition with left-sided finger tapping as the control condition. Analysis of the signal time course of primary and nonprimary areas revealed that the highly selective primary motor activation was due to it being restricted to contralateral finger movements, as opposed to the nonprimary motor areas, which were activated by ipsilateral, contralateral, and bilateral finger movements alike. CONCLUSION: When performing functional MR imaging to determine the location of the primary sensorimotor cortex, one should compare unilateral voluntary movements as the activation condition with contralateral movements as the control condition to accentuate activation of the primary motor area and to suppress undesirable coactivation of nonprimary motor areas.

Adult↗

PubMed1999

Clinical applications of functional MRI at 1.0 T: motor and language studies in healthy subjects and patients.

In this article we describe clinical applications of functional MRI (fMRI) at 1.0 T. All experiments were performed on a commercially available 1.0-T system (Magnetom Impact Expert, Siemens AG, Erlangen, Germany) using a blood oxygen level-dependent (BOLD)-sensitive multi-slice EPI technique (TE 66 ms, 4 mm slice thickness, 210 mm field of view, 64 x 64 acquisition matrix). Different paradigms for localization of the motor cortex and for language lateralization were tested in healthy subjects and patients. Methodological considerations concerning the development of the paradigms are also described. In all healthy subjects, motor activation elicited BOLD signal changes in the sensorimotor cortex, permitting identification of primary motor and sensory cortical areas. Furthermore, focal activation of different cortical areas by a language task was possible in 6 of 10 subjects. Nineteen motor studies were performed in 18 patients with supratentorial lesions, in most cases prior to neurosurgical procedures. In 14 studies, fMRI results demonstrated the localization of the motor hand areas relative to the lesion. The results proved valuable for preoperative planning and contributed to therapeutical decisions. We conclude that functional MRI for clinically relevant applications, such as localization of motor and language function, is feasible even at a field strength of 1.0 T without dedicated equipment.

Adult↗

PubMed1999

[The texture-analysis of high-resolution computed tomograms as an additional procedure in osteoporosis diagnosis: in-vitro studies on vertebral segments].

PURPOSE: The purpose of this study was to perform texture analysis of high-resolution CT images obtained from human vertebral specimens and to correlate these parameters with the biomechanical stability of the specimens. In addition, structure data were compared with bone mineral density (BMD) assessed by quantitative CT (QCT). MATERIAL AND METHODS: High-resolution CT images and standard QCT sections were obtained in 36 vertebral motion segments, each consisting of two vertebrae with intact ligaments and intervertebral disc. The trabecular structure in the CT images was assessed using three texture analysis techniques: Trabecular threshold area ratio (TTAR), fractal dimension without thresholding (OTS) and fractal dimension with thresholding (ITS). Finally, the maximum compressive strength (MCS) was determined using a biomechanical testing device. RESULTS: A correlation of r = 0.76 (p < 0.01) was obtained for TTAR versus MCS, of r = 0.83 (p < 0.01) for ITS versus MCS, and of r = 0.35 (p > 0.01) for OTS versus MCS, while r = 0.76 (p < 0.01) was found for BMD versus MCS. Best results were obtained by combining structure measures and BMD (r = 0.85, p < 0.01). CONCLUSIONS: This in vitro study showed a significant correlation between structure measures and biomechanical strength, which was comparable to BMD and strength. However, best correlations were obtained by combining both measures. Using both BMD and structure measures therefore may improve the prediction of biomechanically determined bone strength.

Aged↗

PubMed1987