Biomedical subjects

Baoli Yao

Publications and source records attributed to Baoli Yao.

6 recordsLinked to original sources

PubMed2006

Optical image processing using the photoinduced anisotropy of pyrrylfulgide.

A synthesized photochromic compound-pyrrylfulgide--is prepared as a thin film doped in a polymethylmethacrylate (PMMA) matrix. Under irradiation by UV light, the film converts from the bleached state into a colored state that has a maximum absorption at 635 nm and is thermally stable at room temperature. When the colored state is irradiated by a linearly polarized 650 nm laser, the film returns to the bleached state; photoinduced anisotropy is produced during this process. Application of optical image processing methods using the photoinduced anisotropy of the pyrrylfulgide/PMMA film is described. Examples in non-Fourier optical image processing, such as contrast reversal and image subtraction and summation, as well as in Fourier optical image processing, such as low-pass filtering and edge enhancement, are presented.

Anisotropy↗

PubMed2005

Polarization holographic high-density optical data storage in bacteriorhodopsin film.

Optical films containing the genetic variant bacteriorhodopsin BR-D96N were experimentally studied in view of their properties as media for holographic storage. Different polarization recording schemes were tested and compared. The influence of the polarization states of the recording and readout waves on the retrieved diffractive image's intensity and its signal-to-noise ratio were analyzed. The experimental results showed that, compared with the other tested polarization relations during holographic recording, the discrimination between the polarization states of diffracted and scattered light is optimized with orthogonal circular polarization of the recording beams, and thus a high signal-to-noise ratio and a high diffraction efficiency are obtained. Using a He-Ne laser (633 nm, 3 mW) for recording and readout, a spatial light modulator as a data input element, and a 2D-CCD sensor for data capture in a Fourier transform holographic setup, a storage density of 2 x 10(8) bits/cm2 was obtained on a 60 x 42 microm2 area in the BR-D96N film. The readout of encoded binary data was possible with a zero-error rate at the tested storage density.

Journal Article↗

PubMed2005

Polarization multiplexed write-once-read-many optical data storage in bacteriorhodopsin films.

In polymeric films of bacteriorhodopsin (BR) a photoconversion product, which was named the F620 state, was observed on excitation of the film with 532 nm nanosecond laser pulses. This photoproduct shows a strong nonlinear absorption. Such BR films can be used for write-once-read-many (WORM) optical data storage. We demonstrate that a photoproduct similar or even identical to that obtained with nanosecond pulses is generated on excitation with 532 nm femtosecond pulses. This photoproduct also shows strong anisotropic absorption, which facilitates polarization storage of data. The product is thermally stable and is irretrievable to the initial B state either by photochemical reaction or through a thermal pathway. The experimental results indicate that the product is formed by a two-photon absorption process. Optical WORM storage is demonstrated by use of two polarization states, but more polarization states may be used. The combination of polarization data multiplexing and extremely short recording time in the femtosecond range enables very high data volumes to be stored within a very short time.

Journal Article↗

PubMed2003

Characteristics and mechanisms of the two types of photoelectric differential response of bacteriorhodopsin-based photocell.

Bacteriorhodopsin (BR)-based photocells have been assigned possessing differential photoelectric response. But recently we found that the differential response described before, which occurred in milliseconds to seconds, outputting a positive pulse when light was on and a negative pulse when light was off, was not the intrinsic property of the BR molecule. It was partially caused by the measuring circuit. By measuring the photoelectric response signal of the BR film photocell to a short laser pulse, the impulse response function of the BR film photocell was obtained by data fitting with MATLAB software. A simulation system was accordingly developed. The output response signals of the BR film photocell under different stepping incident light were calculated. By simulation and analysis, it was concluded that the differential response caused by the intrinsic property of the BR molecule happened in microseconds time scale, and it produced a negative pulse when light was on and a positive pulse when light was off. It was much faster but much weaker than that described before.

Bacteriorhodopsins↗

PubMed2003

Kinetics of picosecond laser pulse induced charge separation and proton transfer in bacteriorhodopsin.

Bacteriorhodopsin (BR) films oriented by an electrophoretic method are deposited on a transparent conductive ITO glass. A counterelectrode of copper and gelose gel is used to compose a sandwich-type photodetector with the structure of ITO/BR film/gelose gel/Cu. A single 30-ps laser pulse and a mode-locked pulse train are respectively used to excite the BR photodetector. The ultrafast falling edge and the bipolar response signal are measured by the digital oscilloscope under seven different time ranges. Marquardt nonlinear least squares fitting is used to fit all the experimental data and a good fitting equation is found to describe the kinetic process of the photoelectric signal. Data fitting resolves six exponential components that can be assigned to a seven-step BR photocycle model: BR-->K-->KL-->L-->M-->N-->O-->BR. Comparing tests of the BR photodetector with a 100-ps Si PIN photodiode demonstrates that this type of BR photodetector has at least 100-ps response time and can also serve as a fast photoelectric switch.

Bacteriorhodopsins↗

PubMed2002

Mechanisms of pulse response and differential response of bacteriorhodopsin and their relations.

Bacteriorhodopsin (BR) films are oriented and deposited on indium tin oxide conductive glass by using electrophoretic sedimentation and Langmuir-Blodgett methods to construct sandwich-type photocells, respectively. The pulse response photoelectric signal of the BR photocell under pulsed laser and the differential response photoelectric signal under irradiation of interval light are measured. The origins of these two types of photoelectric responses and their correlations are analyzed. The pulse response signal initiates from the ultrafast charge separation of the retinal and the proton translocation followed by the deprotonation and reprotonation of the Schiff base and its surrounding amino acids. This is a quick response and is the preceding reaction of the differential response. The differential response signal is caused by the charging and discharging of the continuous proton current of the BR light-driven proton pump at light-on and light-off, which is a slow process. The differential response is related to not only the construction of the BR photocell but also the coupling mode of measurement. To observe the differential response signal, the BR photocell must have large enough B3 and B3' components in its pulse response as well as an alternative coupling mode to measure it.

Bacteriorhodopsins↗