PubMed Health⌕ Search

Biomedical subjects

Barbara Jachimska

Publications and source records attributed to Barbara Jachimska.

4 recordsLinked to original sources

Mechanism of actin polymerization by myosin subfragment-1 probed by dynamic light scattering.

Monomeric actin (G-actin) polymerizes spontaneously into helical filaments in the presence of inorganic salts. The slowest, rate-limiting step of the polymerization process is formation of actin trimers, the smallest oligomers that serve as nuclei for fast filament growth (filament elongation) by monomer addition at the filament ends. In low ionic-strength solutions, actin can be polymerized by myosin subfragment-1 (S1). In early works it has been suggested that G-actin-S1 1:1 complexes (GS) assemble into filaments according to the nucleation-filament elongation scheme. Subsequent studies indicated that one S1 molecule can bind two actin monomers, and that oligomerization of the initial complexes is a fast reaction. This has led to suggest an alternative mechanism, with a ternary G(2)S complex and its oligomers being predominant intermediates of S1-induced assembly of G-actin into filaments. We used dynamic light scattering to analyze the initial steps of S1-induced polymerization of actin. Our results suggest formation of GS complexes and their oligomers in the presence of S1 equimolar to or in excess over actin. We confirm formation of G(2)S complexes as intermediates of S1-induced polymerization in the presence of actin in excess over S1.

Actins↗

Pegylated tetraarylporphyrin entrapped in liposomal membranes. A possible novel drug-carrier system for photodynamic therapy.

A system of poly(ethylene glycol) bound tetraarylporphyrin entrapped in liposomal membranes was investigated. The interactions between the 5-(4-hydroxymethylphenyl)-10,15,20-tritolylporphyrin (Po) covalently attached to the poly(ethylene glycol) chain (PEG-Po), and phosphatidylcholine liposomes in the aqueous solution were studied. The adsorption of the investigated polymer to lipid vesicles was confirmed by measurements of dynamic light scattering and zeta potential. Experimental results demonstrate that the diameter of liposomes increased and the absolute value of the zeta potential decreased after addition of PEG-Po. The binding constants (K(b)) of Po chromophores to liposome in pH range from 5.2 to 9.0 were determined using fluorescence spectroscopy. The degree of binding was found to be pH-independent and the average value was 24.6 +/- 0.9 mg ml(-1). The acid-base properties of the porphyrin chromophores and their aggregation in an aqueous solution were also studied. pK values associated with imine-N protonation of the porphyrin core were found to be 2.59 and 0.68 at the ionic strength of 0.1 M. The equilibrium constant for dimerization, K(D), was found to be 5 x 10(3) M(-1).

Adsorption↗

Structure of colloid silica determined by viscosity measurements.

The viscosity of nanosized colloid silica suspensions, used as binders in the investment casting, was determined as a function of their weight fraction reaching 52%. A new capillary viscometer was used whose construction eliminated sedimentation effects. The experiments have been carried out at fixed pH 10.0 and controlled ionic strength. It was found that for a low silica concentration range (weight fraction below 5%) the suspension viscosity increased more rapidly than the Einstein theory predicts. This anomalous behavior could not be explained in terms of the primary electroviscous effect predicted to be a few orders of magnitude smaller as observed. This discrepancy was accounted for by postulating a fuzzy, gel-like structure of colloid silicas used in our experiments. Hence, the apparent hydrodynamic radius of silica particles in aqueous suspensions was found to be larger than the primary particle size in accordance with previous observations. Based on this postulate, an apparent density of the silica sols was found to be 1.32-1.37 g/cm(3) instead of 2.2-2.32 g/cm(3) as determined from the suspension dilution method. This behavior was interpreted in terms of the core/shell model with high shell porosity, reaching 85%. Similarly, for higher concentration ranges, silica viscosity increased more rapidly with increased sol concentration than predicted by the Batchelor model derived for hard particles. The deviation was attributed to the secondary electroviscous effect stemming from the electrostatic interactions among silica particles in sheared suspensions. This effect has quantitatively been interpreted in terms of Russel's theory. On the other hand, for the high concentration range the experimental results were well accounted for by the Dougherty-Krieger model. By exploiting our experimental findings a sensitive method of determining the structure and apparent density of silica sols in aqueous media was proposed.

Journal Article↗

Polystyrene latex adsorption at the gold/electrolyte interface.

Irreversible deposition of polystyrene latex particles (average diameter, 1.5 microm) on various solid/electrolyte interfaces was studied experimentally by using the direct microscope observation method. The substrate surfaces included bare mica (reference interface), gold covered mica (layer thickness of 50 nm), and solid gold plate. The morphology and thickness of the gold layer on mica was determined by atomic force microscopy. Well-defined transport conditions of particles were created by using the new impinging-jet cell. A characteristic feature of the cell was that the suspension stream was directed obliquely to the interface. This unique characteristic was advantageous allowing one for direct, in situ, observation of particle deposition at metals and other nontransparent interfaces. Experiments performed for various flow intensities indicated that the initial deposition kinetics at all interfaces was identical within the error bounds, in accordance with the model based on the convective-diffusion theory. It was concluded that the limiting flux was governed by the bulk transport rather than by the specific surface interactions.

Journal Article↗