PubMedDate not supplied
The purpose of the study was to characterize flow properties within a clinical pusher plate type artificial heart. Dual camera video tape and synchronized still photographs were used to study flow patterns. Diffused light and a planar laser source provided illumination. The laser light was turned into a plane of light with a thickness varying from 0.1 to 10 mm, and magnesium oxide and Amberlite particles were used as tracers. Qualitative and quantitative analyses were performed by the examination and digitization of flow patterns. Inflow, outflow, pneumatic drive and after-load pressure, diaphragm motion, cardiac output, and heart rate were measured and recorded. An electrical circuit was developed to synchronize pump diaphragm motion with captured images of flow trajectories. Trajectories were then digitized, and velocities, turbulence, and shear stresses were calculated. As the result of these experiments, disturbed, recirculating, and stagnation zones were identified and global and local turbulence values were determined. Simultaneous turbulence, stasis, recirculation, and laminar flow patterns were observed during most phases of the pumping cycle. Velocities obtained varied from 2 cm/sec to 145 cm/sec; total local shear stresses of 12 to 897 dynes/cm2 were seen.