Biomedical subjects

C E Krewson

Publications and source records attributed to C E Krewson.

5 recordsLinked to original sources

PubMed1996

Transport and elimination of recombinant human NGF during long-term delivery to the brain.

The gene for human nerve growth factor (NGF) has been cloned into a mammalian cell line and large quantities of recombinant human NGF (rhNGF) can now be produced for clinical use, but little is known about the fate of rhNGF following delivery to the brain. In this study, we implanted polymer matrices containing 125I-labeled rhNGF into the brains of adult rats and measured spatial distributions of the released protein for 8 weeks after implantation. NGF content in the tissue was determined by counting gamma radiation in thick (1 mm) sections and by autoradiography of thin (20 microns) sections. For the first several days, the rate of NGF release from the polymer matrix was high (approximately 100 ng/day); maximal NGF concentrations, measured at the polymer-tissue interface, were correspondingly high (> 20 micrograms/ml) though day 4. At later times, the release rate decreased (2-10 ng/day) and lower maximal concentrations were observed (1-10 micrograms/ml). NGF levels were always highest in the tissue sections closest to the polymer; during the 8 weeks of the experiment, NGF levels measured in thick sections decreased 100-fold, from 30 ng/section at day 2 to 0.3 ng/section at day 54. The first 10-fold decrease occurred during the first 10 days of the study; a further 6 weeks was required to achieve the second 10-fold decrease. Throughout the experiment, the majority of NGF remained within a restricted zone around the polymer at all times; the mass of NGF decreased to 10% of the maximal level within 2-3 mm of the polymer matrix. At early times (< 1 week), radiolabel corresponding to > 20 pg of NGF was also detected in regions of the brain further removed from the polymer. Comparison of local rhNGF concentration profiles with a simple mathematical model indicated that rhNGF diffuses through the brain interstitial space and is eliminated with a half-life of approximately 45 min, although elimination appears to be substantially slower in white matter regions. This limited ability of NGF to penetrate and be retained within the brain tissue indicates that NGF will need to be delivered almost directly to the target tissue for efficacy.

Animals↗

PubMed1996

PC12 cell aggregation and neurite growth in gels of collagen, laminin and fibronectin.

PC12 cells form aggregates when suspended within three-dimensional, self-assembled, type I collagen gels; these aggregates increase in size over time. In addition, when the cells are cultured in the presence of nerve growth factor, they express neurites, which extend through the three-dimensional matrix. In this report, the roles of fibronectin, laminin and nerve growth factor in PC12 cell aggregation and neurite growth following suspension in collagen matrices were evaluated. Single cells and small clusters of cells were suspended in collagen gels; the kinetics of aggregation were determined by measurement of the projected area of each aggregate, and neurite lengths were determined by measurement of end-to-end distance. Fibronectin and laminin inhibited the aggregation of PC12 cells at 50 micrograms/ml, and fibronectin, but not laminin, inhibited the growth of neurites at 100 micrograms/ml. In the absence of serum, the aggregation of cells cultured with nerve growth factor was almost completely inhibited, but the average neurite length was unaffected. In the presence of nerve growth factor, the extent of cell aggregation could not be explained simply by an increase in cell number, suggesting the presence of two separate mechanisms for aggregate growth: one dependent on cell motility and another dependent on cell proliferation.

Animals↗

PubMed1996

Stabilization of nerve growth factor in controlled release polymers and in tissue.

We have studied the release of nerve growth factor (NGF), a protein under consideration for treatment of Alzheimer's Disease, from polymer matrices and microspheres to characterize the stability of NGF, the dynamics of NGF release, and the distribution of NGF within the brain interstitium. Poly(ethylene-co-vinyl acetate) (EVAc) disks and poly(L-lactic acid) (PLA) microspheres were formed by codispersing NGF with one of a variety of molecules. The mass of mouse NGF (mNGF) detected following release from EVAc disks into buffered saline varied five-fold over the range of codispersants studied, with carboxymethyldextran providing optimal release, while the mass of recombinant human NGF (rhNGF) released varied four-fold from both EVAc disks and PLA microspheres, with albumin and carboxymethyldextran providing optimal release. Variation of the codispersant species significantly affected NGF release into buffered saline; it also had a noticeable, but small, effect of the amount of NGF found in the brain tissue following implantation of a polymer device. To improve NGF retention in tissue, NGF was conjugated to 70,000 molecular weight dextran and incorporated into a polymeric device. The distribution of NGF was enhanced by conjugation; comparison of NGF concentrations in the brain to a mathematical model of diffusion and elimination suggested that the elimination rate of NGF-dextran conjugate in the tissue was over seven times slower than the elimination rate of NGF. These results indicate that variation of the properties of the controlled release system may be useful in regulating the time course of NGF delivery to tissue, and that modification of the NGF itself can improve penetration and retention in the brain.

Animals↗

PubMed1995

Distribution of nerve growth factor following direct delivery to brain interstitium.

Several studies suggest the potential of nerve growth factor (NGF) in the treatment of patients with Alzheimer's disease. To characterize NGF transport within the brain interstitium, we implanted controlled release polymers containing NGF and [125I]NGF into the brains of adult male rats and measured spatial distributions of NGF for up to one week. NGF concentration in the brain was quantified using ELISA, radiation counting, and autoradiography. At 2 days post-implantation, quantities of NGF in excess of 50 pg per section were detected within thick (1 mm) coronal slices of the hemisphere ipsilateral to the site of implantation up to 3 mm rostral and caudal to the edge of the polymer. Lower levels of radioactivity (> 5 pg but < 50 pg NGF per section) could be detected throughout the rest of the brain. Levels were highest in the tissue sections containing the polymer, reaching 9.5 ng per section. Autoradiography of thin (20 microns) coronal sections indicated that local NGF concentrations immediately adjacent to the polymer approached 40 micrograms/ml. Analysis of sequential sections on the autoradiograph confirmed that NGF was transported only 2-3 mm from the polymer in any direction. At one week post-implantation, the pattern of NGF distribution was similar to that seen at 2 days, and concentrations remained high near the site of the implant. Comparison of local NGF concentration profiles to simple models of diffusion with first-order elimination suggests that the NGF moved through the tissue by diffusion through the interstitial space with a half-life on the order of 0.5 h. The limited range of NGF transport in brain tissue indicates that: (i) protein drug agents such as NGF will probably need to be delivered almost directly to the site of action for efficacy; and (ii) toxicities associated with delivery of NGF and other protein agents to non-target cells, as often occurs with systemic delivery of drugs, may be reduced by local, interstitial delivery since therapy can be restricted to a small volume of the brain.

Animals↗

PubMed1994

Mathematical model of temperature-sensitive plasmid replication.

The copy number of a series of plasmids constructed at Odense University is regulated by the lambda PR/PRM promoters and the temperature-sensitive cI857 repressor. At low temperatures, these plasmids exhibit the low copy number of the parent plasmid R1 (5-6 per cell). At high temperatures, the plasmids exhibit runaway replication, reaching copy numbers of greater than 1,000 per cell. A detailed mathematical model of the temperature-sensitive replication of these plasmids has been developed incorporating three features: replication of the parent plasmid, regulation of the lambda PR/PRM promoters by the cI repressor, and thermal denaturation of the cI857 repressor. Models of the first two of these features have been described by others. We revised and extended those models, described the thermal denaturation of the cI857 repressor, and integrated these features to give a comprehensive model of temperature-sensitive plasmid replication. Model predictions were compared to experimental measurements of both steady-state copy numbers as a function of temperature and the change in copy number following temperature shifts up and down. The model accurately describes the qualitative behavior of the system and gives reasonable quantitative results. This is particularly significant since all the parameter values used in this model were determined independently: that is, there was no adjustment of parameter values to match our experimental data. The regulatory system that gives rise to the temperature-sensitive replication of these plasmids is widely used in biotechnology applications, so the elements of the model related to this regulation should be applicable to a wide variety of systems.

Bacterial Outer Membrane Proteins↗