PubMed Health⌕ Search

Biomedical subjects

C Nucci

Publications and source records attributed to C Nucci.

At least 37 records · Page 2Linked to original sources

The ophthalmologist's role in Chlamydia trachomatis infection.

Chlamydia Trachomatis (C.T.) most commonly causes cervicitis in women, often without overt symptoms; when untreated, it produces a clinically inapparent but persistent mild infection or an evident salpingitis. Either processes may lead to scarring of the falloppian tubes and fertility problems. A group of 30 women 20-35 years aged has undergone an ophthalmological routine examination; 7 of them presented a chronical follicular conjunctivitis and history of yellow-white cervical discharge, while the remaining 23 had a mild chronical follicular conjunctivitis but not genital symptoms. Each patient has undergone an immunofluorescent test with monoclonal antibody specific for C.T. on the samples collected by genital and conjunctival scraping and cytological evaluation of the above samples with Giemsa staining. 6 out of 7 patients with genital discharge were positive for C.T., one of which even for eye samples too; all eyes samples showed lymphomonocytes and neutrofilic cells in their eye samples. An additional 3 cases negative for C.T. showed this kind of cells in the eye scraping. The preliminary results of this study on mild follicular chronical conjunctivitis suggest that the Ophthalmologist could play an important role in order to make an early diagnosis in genital and eye infection by Chlamydial Trachomatis.

Adult↗

Shear bond strength and microleakage of dentin bonding systems.

This study evaluated the shear bond strength and microleakage of class V non-retentive restorations with 10 different dentin bonding systems. Some were tested with different composite resins. For the shear bond test, eight specimens were prepared for each product and tested in a universal testing machine. For the microleakage test, 158 V-shaped class V cavities extending to the cementoenamel junction were prepared, coated with a dentin bonding system, and restored with a composite resin. After 250 thermocycles, the teeth were immersed in a dye solution for 48 hours, longitudinally sectioned, and evaluated for microleakage. Both test procedures resulted in significant differences between the various materials. The bond strength failed to completely prevent microleakage at the dentinal wall. The new generation of dentin bonding systems offer a significant improvement over previous materials.

Acrylates↗

Oxalate solution and collagen-oxalate solution as protective liners for dentine.

The aim of the present study was to evaluate under scanning electron microscopy the ability of different chemically reactive solutions to form a protective layer on dentine. The materials selected were an oxalate solution, a collagen-oxalate solution, a collagen-oxalate solution plus glutaraldehyde and a saline control solution. Small dentine fragments, obtained from extracted human teeth, were treated with the various chemical solution for 60 seconds. All samples were then examined in a Jeol scanning electron microscope. The preliminary observations suggest that dentine may be covered by a mixture of oxalate crystals and collagen producing a homogeneous layer of reactive agents.

Collagen↗

[Hematoma of the adrenal gland in the newborn infant. Clinical course. Presentation of 20 cases].

The Authors stress the importance of a correct sonographic study in the follow-up of neonatal adrenal hemorrhage; the diagnostic conclusion are: the best criterion for differential diagnosis is the chronological variability. However the differential diagnosis is rather easy. The differential d. usually is against cystic-neuroblastoma, cortical renal cyst, adrenal abscess. They remark that laparatomy is unnecessary.

Adrenal Gland Diseases↗

[Dentinal bonding systems and the tensile bond strength test].

The aim of the present study was to evaluate the tensile bond strength of four dentinal bonding agents (DBAs) to the dentin surface. Tensile bond test procedure was made using a universal testing machine. Human extracted third molars were mounted with self-curing acrylic resin in cylindrical molds. The dentin occlusal surface was ground with 320-grit silicon carbide abrasive paper. The DBAs were prepared according to manufacturers' directions and applied on the dentin surface. Cylindrical teflon tubes were placed on the dentin surface and filled with a microfilled resin. The samples were then stored in a humidifier at 37 degrees C for 24 h. Six specimens were prepared for each group. A statistically significant difference was observed among the four groups. It has been observed that certain materials showed a dentin bond value superior to cohesive value of composite resin.

Dental Cements↗

Early marginal leakage and shear bond strength of adhesive restorative systems.

The aims of this study were to assess in vitro the early marginal seal effectiveness in Class V restorations at the cemento-enamel junction, and the early shear bond strength of several composite and dentin bonding system combinations. The seal effectiveness was studied by evaluating the dye penetrations: (a) along the superficial margin of restorations (width of surface microleakage); (b) along the dentin cavity walls (length of microleakage); and (c) toward the pulp (depth of microleakage). Good correlations were demonstrated among the seal evaluations, but no relationships were apparent between these and shear bond strength. Our study suggests that the marginal seal is influenced by composite properties more than by bonding agents. The shear bond analysis indicates only the adhesive potential of the materials without considering the composite shrinkage effects on marginal gap after the photocuring setting reactions.

Composite Resins↗

Effects of chemical pretreatments on dentin bonding.

The aim of this study was to evaluate several chemical pretreatments on the shear bond strength of three dentin bonding agents (DBAs) and to try to correlate dentin morphology with bond strength using scanning electron microscopy (SEM). The DBAs tested were: Gluma Primer in association with Scotchbond DC, Scotchbond DC alone and Clearfil New Bond. Bond strengths of Scotchbond DC and Clearfil New Bond were not significantly modified or reduced by acidic dentin pretreatments. Gluma/Scotchbond adhesion was increased by several treatments but only maleic acid treatment produced shear bond strengths significantly higher than EDTA treatment. SEM evaluation of dentin treatments revealed a wide variety of morphological changes in the dentin surface with partial and complete removal of smear layer by acidic solutions, and only minor modification by amino acid solutions. Only maleic acid was capable of the complete removal of the smear layer and smear plugs coupled with extensive exposure of dentin collagen fibrils.

Acid Etching, Dental↗

Shear bond strength and SEM evaluation of dentinal bonding systems.

Shear bond strength of seven dentin bonding systems (DBS) was evaluated. After shear bond testing, the specimens were analyzed under scanning electron microscope (SEM). Buccal dentin just below the dentin-enamel junction of erupted third molars of young subjects were used. A statistical difference was observed among the material bond values. SEM examination of both sides of the sheared bonds frequently showed an adhesive failure between dentin and bonding agents in the specimens where resin penetrated into the opened dentinal tubules. A complex cohesive fracture of both resin and dentin was observed for bonding agents that required the treatment of the smear layer, while a cohesive fracture in the smear layer thickness was noted when dentin was not altered by primer solutions. The study demonstrated that the DBS that require the removal of the smear layer showed a significantly higher shear bond strength and that the bond value reflects the mode of material fracture and the presence of smear layer.

Composite Resins↗

[Glass ionomer cements and dentinal pretreatments: the evaluation of their adhesion to the dentin].

The aim of the present study was to evaluate the shear bond strength test of two glass-ionomer cements (G C cement and Ketac Bond) after different chemical pretreatments of dentine surface. The following dentine pretreatments were used: sodium hypochlorite, polyacrylic acid, tannic acid, H3PO4, FeCl3, Fe ossalate, Tubulicid, H2O2 and aqueous solution as control. Flat dentine surface of human extracted teeth was treated with the chemical agents, washed and dried. Cylindrical specimens of glass-ionomer cement were applied on dentine surface. After 24 hours in humidifier the specimens were tested in a universal testing machine. A significant higher bond was obtained only from polyacrylic acid and sodium hypochlorite treatments. The present results suggest that dentine pretreatment represent an essential step in composite resin/glass-ionomer cement restorations.

Adhesiveness↗

[Dentin adhesives and the traction test. Comparative evaluation].

This study evaluated the shear bond strength of six dentinal bonding agents and one unfilled enamel bond in association with a microfilled composite resin. Eight specimens were prepared for each product. All the bonded samples were stored at 37 degrees C for 24 hours in a humidifier. Bond strength was measured with a universal testing machine. A statistically significant difference was found between the various products. The new dentinal bonding agents gave the highest bond value.

Composite Resins↗

[Early marginal infiltration and Class II cavities].

The purpose of the present study was to evaluate the early marginal microleakage in 20 Class II MOD restorations made in association with conventional and sandwich technique. Human extracted third molars were used in the study. Multi-incremental technique was used in all restorations. After finishing, the teeth were stored in dye solution for 12 hours, transversally sectioned at three levels and evaluated under optical stereomicroscope. Cervical sections showed the highest marginal leakage. Sandwich technique in association with glass-ionomer cements have showed a significant lower early microleakage with respect to the conventional technique.

Composite Resins↗

Effects of acid and cleansing agents on shear bond strength and marginal microleakage of glass-ionomer cements.

The aims of the present study were to evaluate the effects of various dentin chemical pretreatments (a) on the shear bond strength of five glass-ionomer cements (GICs) and (b) on marginal microleakage of the five GICs used in association with resin composites in Class V restorations. The dentin treatments were: three acid agents (polyacrylic acid, tannic acid, orthophosphoric acid), three cleansing agents (Tubulicid blue solution, hydrogen peroxide, and sodium hypochlorite), and an aqueous solution as control. After dentin treatment, the test specimens were stored in water at 37 degrees C for 24 hr. Shear bond strength was determined with a universal testing machine at a cross-head speed of 0.5 cm/min. Sodium hypochlorite and polyacrylic acid significantly improved the adhesion of GICs to a different degree in the various materials. Regarding microleakage tests, 320 non-retentive cavities were prepared at the cementum-enamel junction in freshly extracted human teeth. The teeth were thermocycled, immersed in dye solution, and serial-sectioned longitudinally at three sites. Treatment with sodium hypochlorite was the most effective in reducing marginal leakage. The present results suggest that dentin treatment is an important step in all resin composite/GIC restorations.

Acid Etching, Dental↗

Microleakage of mixed Class-V restorations placed with GIC-bases or dentin bonding agents.

The aim of this study was to compare the microleakage of a new generation of light-cured glass-ionomer cement bases and multistep dentin bonding agents with materials of the previous generation. Mixed class-V non-retentive cavities were prepared in freshly extracted third molars and filled with the test materials. After 250 thermocycles, the teeth were immersed in a dye solution for 48 h, sectioned longitudinally and evaluated under a stereomicroscope. The new bonding systems (i.e. Clearfil New Bond, Gluma Bond, Scotchbond 2 and Vitrabond) showed statistically significant lower microleakage values than the previous materials (i.e. Scotchbond DC, Ketac Bond, GC lining cement and 3M GIC). This in-vitro study emphasized the efficacy of the new generation of glass-ionomer cement bases and multi-step bonding agents.

Adhesives↗

[Echographic identification of symptomatic gastric carcinoma and its lymph node metastases].

The diagnostic capability of ultrasound in symptomatic gastric cancer is stressed, on the basis of a prospective study of 64 neoplastic and 19 non-neoplastic patients. Aspecific signs are described which suggest the presence of five layers within the gastric wall as an index of absence of disease. The prospective importance of ultrasound investigation in 5 neoplastic patients with aspecific symptoms is emphasized.

Esophageal Neoplasms↗

Retinal involvement in pigment dispersion syndrome.

Retinal involvement has been documented in a number of patients with pigment dispersion syndrome, which also appears to be associated with a higher than normal risk of retinal detachment. We studied 24 patients with this syndrome to determine the prevalence of lattice degeneration and other retinal disorders associated with a predisposition to detachment. Lattice degeneration was found in 8 of 24 patients examined, with a prevalence that is significantly higher than that reported for normal subjects. Four eyes presented areas of retinoschisis and only one displayed a rhegmatogenous detachment. A father and son (both myopes) were found to have similar lattice lesions in the same retinal quadrants. These findings suggest that pigment dispersion syndrome may be associated with developmental anomalies that are not restricted to the anterior chamber but involve other portions of the bulb as well.

Adolescent↗