PubMed Health⌕ Search

Biomedical subjects

C R Loomis

Publications and source records attributed to C R Loomis.

25 records · Page 2Linked to original sources
PubMed1985

Activation of protein kinase C by Triton X-100 mixed micelles containing diacylglycerol and phosphatidylserine.

A mixed micellar assay for protein kinase C was developed to investigate the specificity and stoichiometry of activation by phospholipids and diacylglycerols. Triton X-100 mixed micelles containing 8 mol % phosphatidylserine (PS) and 2.5 mol % sn-1,2-dioleoylglycerol (diC18:1) activated rat brain protein kinase C in the presence of Ca2+ to the same degree as sonicated PS/diC18:1 did in the standard assay. However, protein kinase C activity was more responsive to diC18:1 in the mixed micellar assay than the standard assay. At 8 mol % PS and 100 microM Ca2+, diC18:1 stimulated maximally at 1 mol %. At 2.5 mol % diC18:1 and 100 microM Ca2+, PS did not activate until 3 mol % and then did so cooperatively with maximal stimulation occurring at 6-8 mol %. Direct evidence for a Ca2+-, PS-, and diC18:1-dependent interaction of protein kinase C with mixed micelles was obtained by molecular sieve chromatography on Sephacryl S-200. These data permit inferences pertaining to the number of diC18:1 and PS molecules/micelle which are required for activation. For diC18:1, a single molecule may be sufficient but no more than 2 molecules are required. For PS, greater than 4 but less than 10 molecules are required. These data establish that a phospholipid bilayer is not required for protein kinase C activation and that activation of monomeric protein kinase C occurs.

Animals↗
PubMed1985

sn-1,2-Diacylglycerol kinase of Escherichia coli. Purification, reconstitution, and partial amino- and carboxyl-terminal analysis.

The sn-1,2-diacylglycerol kinase structural gene from Escherichia coli was demonstrated to be the dgkA locus previously sequenced (Lightner, V. A., Bell, R. M., and Modrich, P. (1983) J. Biol. Chem. 258, 10856-10861). The dgkA gene product was shown by maxicell analysis to be an Mr = 14,000 membrane-bound protein. When dgkA was placed on a hybrid plasmid under control of the lambda pL promoter, a 100-fold overproduction of diacylglycerol kinase activity was obtained. Diacylglycerol kinase was solubilized from membranes with 2-propanol/heptane/trifluoroacetic acid and purified to near homogeneity by high performance liquid chromatography. Activity was reconstituted in a mixed micellar assay containing beta-octylglucoside, cardiolipin, and sn-1,2-dioleoylglycerol. Amino acid analysis, partial NH2-terminal analysis and COOH-terminal analysis permitted alignment of the polypeptide on the sequenced gene. The data establish that dgkA is the structural gene for the diacylglycerol kinase and establish the primary structure of the enzyme of 122 residues, 13,245 daltons. Secondary structure analysis predicted a protein conformation consisting of three transmembrane alpha-helical segments, an amphipathic helix, and an alpha-helix. Taken together, the predicted helical segments comprise more than 75% of the polypeptide.

Amino Acid Sequence↗
PubMed1982

Phosphorylation of calcium adenosinetriphosphatase by inorganic phosphate: reversible inhibition at high magnesium ion concentrations.

Magnesium stimulates phosphorylation of the calcium pump protein of the sarcoplasmic reticulum by inorganic phosphate, but the effect is reversed by high [Mg2+]. This reversal is readily explained in terms of the generally accepted existence of two conformational states of the enzyme, E1 and E2. E2 is the form of the enzyme that can be phosphorylated by Pi, and it has one binding site for Mg2+. E1 is the form of the enzyme that has two high-affinity Ca2+ binding sites, and it is phosphorylated by ATP when Ca2+ is bound. Mg2+ can bind weakly to the two Ca2+ sites and to a third site known to be present on E1; this stabilizes E1 at the expense of E2 when [Mg2+] is large. Stabilization of E1 at pH 6.2 and 25 degrees C was found to be a highly cooperative function of [Mg2+] and was not prevented by increasing [Pi]. The latter result requires the existence of a binding site for Pi on E1, with an affinity for Pi comparable to that of E2. Cooperativity with respect to [Mg2+] requires that E2 is the stable state of the enzyme in the absence of ligands, with an equilibrium constant [E2]/[E1] on the order of 10(3) or higher at pH 6.2 and 25 degrees C.

Binding Sites↗
PubMed1979

The phase behavior of hydrated cholesterol.

The thermotropic phase behavior of cholesterol monohydrate in water was investigated by differential scanning calorimetry, polarizing light microscopy, and x-ray diffraction. In contrast to anhydrous cholesterol which undergoes a polymorphic crystalline transition at 39 degrees C and a crystalline to liquid transition at 151 degrees C, the closed system of cholesterol monohydrate and water exhibited three reversible endothermic transitions at 86, 123, and 157 degrees C. At 86 degrees C, cholesterol monohydrate loses its water of hydration, forming the high temperature polymorph of anhydrous cholesterol. At least 24 hours were required for re-hydration of cholesterol and the rate of hydration was dependent on the polymorphic crystalline form of anhydrous cholesterol. At 123 degrees C, anhydrous crystalline cholesterol in the presence of excess water undergoes a sharp transition to a birefringent liquid crystalline phase of smectic texture. The x-ray diffraction pattern obtained from this phase contained two sharp low-angle reflections at 37.4 and 18.7 A and a diffuse wide-angle reflection centered at 5.7 A, indicating a layered smectic type of liquid crystalline structure with each layer being two cholesterol molecules thick. The liquid crystalline phase is stable over the temperature range of 123 to 157 degrees C before melting to a liquid dispersed in water. The observation of a smectic liquid crystalline phase for hydrated cholesterol correlates with its high surface activity and helps to explain its ability to exist in high concentrations in biological membranes.

Calorimetry, Differential Scanning↗
PubMedDate not supplied

Probing biomolecule recognition with electron transfer: electrochemical sensors for DNA hybridization.

Identifying infectious organisms, quantitating gene expression, and sequencing genomic DNA on chips all rely on the detection of nucleic acid hybridization. Described here is a novel assay for detection of the hybridization of products of the polymerase chain reaction using electron transfer from guanine to a transition-metal complex. The hybridization assay was modeled in solution by monitoring the cyclic voltammetry of Ru(bpy)3(2+) (bpy = 2,2'-bipyridine) in the presence of a probe strand containing only A, T, and C prior to and after hybridization to a complement that contained seven guanines, which led to high catalytic current due to the oxidation of guanine by Ru(bpy)3(3+). To allow recognition of all four bases in the target sequence, it was shown that inosine 5'-monophosphate was 3 orders of magnitude less reactive than guanosine 5'-monophosphate, suggesting that effective hybridization sensors could be realized by immobilization of probe strands in which inosine was substituted for guanosine; hybridization to guanosine-containing target strands would then provide high catalytic currents. A sensor design was tested in a model system for the detection of a synthetic 21-mer oligonucleotide patterned on the sequence of the ras oncogene, which gave an increase in charge collected of 35 +/- 5 microC after hybridization and of only 8 +/- 5 microC after exposure to noncomplementary DNA. Independent quantitation of probe and target by radiolabeling showed that the hybridized electrode contained 3.0 +/- 0.3 ng of target. New sensor electrodes were then prepared for the detection of PCR-amplified genomic DNA from herpes simplex virus type II, genomic DNA from Clostridium perfringens, and genomic RNA from human immunodeficiency virus and gave an additional charge of 35-65 microC for hybridization to complementary amplicon and of only 2-10 microC after exposure to noncomplementary DNA.

Biosensing Techniques↗