Biomedical subjects

C R Mendonça

Publications and source records attributed to C R Mendonça.

5 recordsLinked to original sources

PubMed2004

In situ UV-vis absorbance measurements for Langmuir films of poly[4'-[[2-(methacryloyloxy)-ethyl]ethylamino]-2-chloro-4-nitroazobenzene] (HPDR13) azopolymer.

In situ UV-vis absorbance measurements are used to investigate aggregation in Langmuir films from the azopolymer poly[4'-[[2-(methacryloyloxy)-ethyl]ethylamino]-2-chloro-4-nitroazobenzene] (HPDR13), a methacrylate derivative of DR13. The level of aggregation in a Langmuir film is intermediate between that of HPDR13 in chloroform solution and in a deposited LB film, as expected. Absorption is negligible at large areas per monomer, and starts to increase at a critical area that is the same as the one obtained in surface potential isotherms, being close to twice the area per monomer for a condensed film. This indicates that the onset for light absorption coincides with a critical packing density where monolayer structuring occurs and there is a sharp change in the effective dielectric constant of the film/water interface. Consistent with a featureless pressure-area isotherm for HPDR13, denoting no significant molecular rearrangement upon film compression, the UV-vis spectra did not vary with the surface pressure. The intensity of absorbed light increased, though, as the film was compressed owing to a higher density of chromophores. At higher subphase temperatures, larger flexibility of HPDR13 chains led to a more compact arrangement, causing the area per monomer to decrease and the absorbed light to increase-with approximately opposite trends.

Journal Article↗

PubMed2003

High-efficiency multipass optical limiter.

We report experimental results on a highly efficient optical limiter that uses a three-mirror, multipass ring configuration. The optical limiter's enhanced performance is based on the accumulative effect that is achieved when the laser beam passes through the sample several consecutive times. Its feasibility was demonstrated for media with different limiting action processes, namely, reverse saturable absorption, nonlinear scattering, and thermal lensing. We employed a frequency-doubled, Q-switched, 10-ns Nd:YAG laser operating at a 5-Hz repetition rate.

Journal Article↗

PubMed2001

Surface enhanced fluorescence and Raman imaging of Langmuir-Blodgett azopolymer films.

The spectroscopic properties and surface-enhanced spectra of Langmuir-Blodgett (LB) films of methacrylic homopolymer (HPDR13) are presented. It is shown that LB film displays strong fluorescence attributed to the spatial restrictions imposed by its structure. The emission is observed in conjunction with photoisomerization, a process clearly demonstrated by the formation of surface-relief gratings in the LB film [C.R. Mendonça et al., Macromolecules 32 (1999) 1493]. Surface-enhanced Raman scattering (SERS), Surface-enhanced resonance Raman scattering (SERRS) and surface-enhanced fluorescence (SEF) were observed for LB films of HPDR13 deposited onto silver island films. SERS measurements were also carried out on a sample fabricated with one monolayer LB film deposited onto silver islands followed by one overlayer of silver (LB sandwiched between two layers of silver islands). The polymer interacts very weakly with the metal surface (physisorption), and the enhancement effect is determined by the local electric field enhancement. The strong SERS and SERRS signals were suitable for micro-Raman imaging. Line, area mapping and global images of the LB monolayer on silver island are reported. The transfer ratio in the fabrication of the LB suggests a homogeneous coating of the silver islands, thereby the chemical images show the variation of the SERS intensity due to surface enhancement.

Azo Compounds↗

PubMedDate not supplied

Light-induced storage in layer-by-layer films of chitosan and an azo dye.

The buildup of layer-by-layer (LBL) films from chitosan and the azodye Ponceau-S (PS) was investigated under various experimental conditions, and the resulting films were used in optical storage experiments. The kinetics for the writing process in optical storage was faster for LBL films prepared at low pHs, probably because the films had a larger free volume for isomerization of the chromophores. The nanostructured nature of the LBL films also affected the crystallinity of chitosan, which was considerably decreased in this type of film as chitosan became protonated because of the electrostatic interactions between adjacent layers.

Azo Compounds↗

PubMedDate not supplied

Surface-relief gratings and photoinduced birefringence in layer-by-layer films of chitosan and an azopolymer.

Layer-by-layer (LBL) films of chitosan alternated with an azopolymer, PS119, have been used for optical storage and fabrication of surface-relief gratings. The optical properties stem from the trans-cis-trans isomerization cycles undergone by the azochromophore, with a kinetics for writing the birefringence pattern that is much slower than in the spin-coated or cast films of azopolymers. The long writing times, of the order of 100 s, are due to the electrostatic interactions between adjacent chitosan and PS119 layers. Such interactions are also responsible for other features in the LBL films, namely the increase in the amount of adsorbed material when the pH of the preparation solution is decreased and the large residual birefringence after the writing laser is switched off. Gratings could be inscribed with s-polarized but not with p-polarized light, indicating a mass transport process associated with photodegradation.

Azo Compounds↗