Biomedical subjects

C S Bediz

Publications and source records attributed to C S Bediz.

4 recordsLinked to original sources

PubMed1999

Basal metabolic rates of Turkish women during pregnancy.

The purpose of the present study was to investigate the basal metabolic rates (BMRs) of pregnant Turkish women and to compare them with values from other countries. Twenty-four pregnant women (aged 24.8+/-5.7 years) were studied longitudinally from early pregnancy through to the end of pregnancy. BMR values were measured in the 1st, 2nd and 3rd trimesters by indirect calorimetry. While the measured BMR significantly increased (279+/-212 kcal/day between the 1st and 3rd trimesters), no change was found when BMR was expressed per unit of body weight. BMR in the 2nd and 3rd trimesters showed a significant correlation with body weight. The BMR increase in pregnant Turkish women was close to that reported in developed countries, and higher than that reported in developing countries. Knowing the metabolic changes of the pregnant women may contribute to dietary recommendations for them.

Adipose Tissue↗

PubMed1999

A combined method for estimating ventilatory threshold.

BACKGROUND: The aims of this study were to compare two new methods (Dmax and CUSUM) for determination of the ventilatory threshold and to examine the consequences of estimation by application of these methods in combination. METHODS EXPERIMENTAL DESIGN: a comparative design was used. SETTING: the study was performed in the Exercise Physiology Laboratory in the Faculty of Medicine, Selçuk University. PARTICIPANTS: thirty-two untrained males (20.6 +/- 1.2 yrs) performed an incremental exercise test on a cycle ergometer. INTERVENTIONS: there is no intervention. MEASURES: ventilatory and gas exchange variables were measured breath-by-breath. The ventilatory thresholds were detected by conventional linear regression, CUSUM, Dmax and combined CUSUM-Dmax methods. RESULTS: The ventilatory thresholds determined by Dmax method gave the highest r-values compared to the criterion method. There was no statistical difference between thresholds determined by all methods or by the same method using different variables. Ventilatory thresholds could not be determined by the conventional linear regression method in three subjects but were determined in all subjects by the other three methods. CONCLUSIONS: Although all methods presented in this study can be used in the determination of ventilatory threshold, the Dmax method was found to be the most valid one. When using the CUSUM method, combining it with the Dmax method increases the validity of the measurement.

Adult↗

PubMed1998

Pulmonary function of workers in the aluminum industry.

The effects of aluminum on the pulmonary function of aluminum workers were investigated in this study. Serum aluminum levels and spirometry were measured in 55 male workers and 30 male controls. The mean serum aluminum level of workers (72.7 +/- 9.9 ng/ml) was significantly high compared to that of controls, indicating aluminum toxicity. Spirometric parameters were significantly lower in workers than in controls and correlated negatively with both exposure time and serum aluminum levels. The impairment in pulmonary function may be due to exposure time and insufficient protection.

Adult↗

PubMed1998

Comparison of the aerobic contributions to Wingate anaerobic tests performed with two different loads.

BACKGROUND: The purpose of the present study was to compare the aerobic contribution of the Wingate anaerobic test by increasing the test load and power output. METHODS SETTING: The study was performed in the Physiology Department of the Faculty of Medicine, Selçuk University. PARTICIPANTS: Thirty sedentary male university students volunteered to this study. EXPERIMENTS: The subjects performed two Wingate tests against resistance of 75 g.kg-1 and 95 g.kg-1 body weight on Monark 818E bicycle ergometer. Breath-by-breath oxygen consumption rates were measured using an automated metabolic measurement chart (Sensormedics 2900). Aerobic contribution was determined by dividing energy equivalence of net oxygen consumption to the total work. RESULTS: The mean total work values obtained from tests performed at 75 g.kg-1 and 95 g.kg-1 loads were 13.9 +/- 1.5 kjoules and 14.5 +/- 1.8 kjoules (t = 2.32, p = 0.03). Mean total oxygen consumptions were 765 +/- 105 ml and 770 +/- 110 ml, respectively (t = 0.24, p = 0.81). Assuming 20% mechanical efficiency for both tests, aerobic contributions were calculated as 19.5 +/- 3.7% and 18.9 +/- 3.7%, respectively (t = 1.01, p = 0.30). CONCLUSIONS: Although the power outputs of the two tests were different, the difference between aerobic contributions was not statistically significant. So, it was failed to say that the increase in the power outputs might be related to higher contribution of anaerobic processes. However, if different mechanical efficiencies could be used, relationship between aerobic contributions of two tests might have been different.

Adult↗