Biomedical subjects

Christian Apel

Publications and source records attributed to Christian Apel.

3 recordsLinked to original sources

PubMed2004

Multireflection pumping concept for miniaturized diode-pumped solid-state lasers.

An innovative pump concept for diode-pumped, solid-state lasers is introduced as an example for an Er:YSGG laser, permitting its miniaturization. Embedded in a multireflective pump cavity, the laser crystal is simultaneously side and end pumped. Specially calculated and shaped deflecting optics distribute the coaxially input pumping light homogeneously over the lateral surface of the crystal, therefore reducing the size of the laser head, including the optical resonator, to a length of 27.5 mm and an outside diameter of 12.5 mm. The differential efficiency achieved is between 8.7% and 24%. The laser emits energy of 15.7 mJ at an absolute efficiency of 9.1% and a repetition rate of 4 Hz.

Equipment Design↗

PubMed2004

Influence of the spatial beam profile on hard tissue ablation, part II: pulse energy and energy density distribution in simple beams.

When calculating applied flux densities in practice, the beam profile of a laser is often erroneously assumed to be homogeneous. In addition, there is usually no consistency in the choice of a suitable measuring method for determining the beam diameter. This failure to observe the inhomogeneous intensity distribution within the beam cross-section, combined with the imprecise knowledge of the beam diameter, leads to flux densities being stated that represent mean values at best. The present paper gives definitions for the flux densities of simple, radially symmetrical beam cross-sections, taking the top-hat and Gaussian profiles as examples. In connection with the inhomogeneous energy distribution in the Gaussian beam, a concept of integral and local energy density is discussed, which differs from the customary definition of the energy density as a constant. Also presented are the consequences of the mathematical concepts in terms of measurement, giving particular consideration to the case where the energy density as the measured variable matches the integral energy density. The significance of the integral and local energy density for hard-tissue ablation is described, based on the practical example of the ablation of dental hard substance. The central result is that the integral flux density is directly accessible as a measured variable, while the effect on the tissue is determined by the local flux density. If the form of the beam is known, the integral flux density can be converted into the local flux density.

Dental Enamel↗

PubMedDate not supplied

Influence of the water content in dental enamel and dentin on ablation with erbium YAG and erbium YSGG lasers.

The theory of the ablation of dental hard tissue with erbium lasers is based on a process of thermomechanical interaction, which is explained by the absorption of the radiation in the water component of the tissue. The abrupt evaporation of the water is the cause of tissue fragments being blasted out of the tooth structure. The aim of this study is to examine the effect of the water contained in dental hard tissues on the efficiency of ablation. 192 specimens of both bovine dental enamel and bovine dentin are irradiated with an Er:YAG and an Er,Cr:YSGG laser. Half of the specimens are dehydrated beforehand. Irradiation is carried out in subgroups: without water spray and with water spray at flow rates of 0.8 and 3 mls. The ablated volume is determined following histological preparation. Only in dentin, and then only with irradiation with the Er:YAG laser, is the water contained in the tissue found to have a significant influence (p < 0.0001) on the ablated volume. The water content has no effect on the efficiency of laser ablation in any of the other test groups. In contrast, the externally supplied water always has a significant influence on the effectiveness of the ablation process.

Dental Cavity Preparation↗