Biomedical subjects
Publications and source records attributed to Christiane Ziegler.
This review provides a general introduction into the theory of cantilever sensors, including practical design concepts, examples for liquid-phase sensing with particular emphasis on biological applications, and a discussion of future prospects.
Two kinds of nanocrystalline alumina powders, boehmite (gamma-AlOOH, particle size d approximately 10 nm, BET surface area A(BET) = 180-200 m(2) g(-1)) and corundum (alpha-Al(2)O(3), d approximately 400 nm, A(BET) = 7 m(2) g(-1)) were used for comparative investigation by thermogravimetry (TG). The remarkable difference in the dehydration profiles between the two samples gives evidence for a distinct difference in their structures. In the following pyridine adsorption/desorption experiment, gamma-alumina was found to possess much more (20 times) and much stronger acidic sites than corundum. The activation energy of pyridine desorption was obtained from the respective minima in the first derivative of the TG-curves (DTG) at various heating rates (1-20 K min(-1)); the activation energy for pyridine desorption is smaller for gamma-alumina (61.5 kJ mol(-1)) than for corundum (78.8 kJ mol(-1)). Furthermore, the adsorption of water, carbon tetrachloride, and hexane on those alumina specimens provides evidence for the highly hydrophilic nature of their surfaces. The shift of T(max) to higher temperatures upon desorption of water was ascribed to the different adsorption coverage and the different energy required for removal of adsorbed water molecules.
Nanoporous thin films were deposited onto glass substrates by painting with a solution of nanocrystalline anatase TiO(2) particles (with a size of either 6 nm or 16 nm) suspended in an organic solvent. Upon drying in air for about 1 day, the films were tempered at 450 degrees C in air for 1 h. This procedure results in stoichiometric TiO(2) films with a thickness of several micro m and a milky whitish appearance. Scanning force microscopy of the surface revealed that the nanoparticles of the films agglomerated into structures with lateral dimensions of some 100 nm. Transmission electron microscopy was utilized to investigate the structural arrangement of the crystallites in the films. High-resolution electron diffraction and X-ray diffraction analyses demonstrated, furthermore, that the material consists exclusively of a single TiO(2) phase, namely anatase, and that the films do not exhibit any preferential texture. The elemental stoichiometry and the possible presence of impurities were monitored throughout the films by means of secondary-ion mass spectrometry depth profiling. Electrical measurements have been carried out as a function of both the sample temperature T and the ambient oxygen partial pressure p(O(2)). From these data the electrical conductivity sigma of the porous films was determined in dependence of those parameters.
The reaction of two equiv of the monomeric ether-phosphine O,P ligand (MeO)(3)Si(CH(2))(3)(Ph)PCH(2)-Do [1a(T(0)()), 1b(T(0)())] {Do = CH(2)OCH(3) [1a(T(0)())], CHCH(2)CH(2)CH(2)O [1b(T(0)())]} with PdCl(2)(COD) yields the monomeric palladium(II) complexes Cl(2)Pd(P approximately O)(2) [2a(T(0)())(2)(), 2b(T(0)())(2)()]. The compounds 2a(T(0)())(2)() and 2b(T(0)())(2)() are sol-gel processed with variable amounts (y) of Si(OEt)(4) (Q(0)()) to give the polysiloxane-bound complexes 2a(T(n)())(2)()(Q(k)())(y)(), 2b(T(n)())(2)()(Q(k)())(y)() (Table 1) {P approximately O = eta(1)-P-coordinated ether-phosphine ligand; for T(n)() and Q(k)(), y = number of condensed T type (three oxygen neighbors), Q type (four oxygen neighbors) silicon atoms; n and k = number of Si-O-Si bonds; n = 0-3; k = 0-4; 2a(T(n)())(2)()(Q(k)())(y)(), 2b(T(n)())(2)()(Q(k)())(y)() = {[M]-SiO(n)()(/2)(OX)(3)(-)(n)()}(2)[SiO(k)()(/2)(OX)(4)(-)(k)()](y)(), [M] = (Cl(2)Pd)(1/2)(Ph)P(CH(2)Do)(CH(2))(3)-, X = H, Me, Et}. The complexes 2b(T(n)())(2)()(Q(k)())(y)() (y = 4, 12, 36) show high activity and selectivity in the hydrogenation of 1-hexyne and tolan. The dicationic complexes [Pd(P&arcraise;O)(2)][SbF(6)](2) [3a(T(0)())(2)(), 3b(T(0)())(2)()] are formed by reacting Cl(2)Pd(P approximately O)(2) with 2 equiv of a silver salt {P&arcraise;O = eta(2)-O&arcraise;P-coordinated ether-phosphine ligand; 3a(T(0)())(2)(), 3b(T(0)())(2)() = [M]-SiOMe(3); [M] = {[Pd(2+)](1/)(2)P(Ph)(CH(2)CH(2)OCH(3))(CH(2))(3)-}{SbF(6)} (a), {[Pd(2+)](1/)(2)P(Ph)(CH(2)CHCH(2)CH(2)CH(2)O)(CH(2))(3)-}{SbF(6)} (b)}. Their polysiloxane-bound congeners 3a(T(n)())(2)(), 3b(T(n)())(2)() {[M]-SiO(n)()(/2)(OX)(3)(-)(n)} are obtained if a volatile, reversible bound ligand like acetonitrile is employed during the sol-gel process. The bis(chelate)palladium(II) complexes 3a(T(n)())(2)(), 3b(T(n)())(2)() are catalytic active in the solvent-free CO-ethene copolymerization, producing polyketones with chain lengths comparable to those obtained with chelating diphosphine ligands. The polysiloxane-bound palladium(0) complexes 5a(T(n)())(2)()(Q(k)())(4)(), 5b(T(n)())(2)()(Q(k)())(4)() {[M]-SiO(n)()(/)(2)(OX)(3)(-)(n)}(2)[SiO(k)()(/2)(OX)(4)(-)(k)](4), [M] = [(dba)Pd](1/)(2)P(Ph)(CH(2)Do)(CH(2))(3)-} undergo an oxidative addition reaction with iodobenzene in an interphase with formation of the complexes PhPd(I)(P approximately O)(2).4SiO(2) [6a(T(n)())(2)()(Q(k)())(4)(), 6b(T(n)())(2)()(Q(k)())(4)()] {[M]-SiO(n)()(/)(2)(OX)(3)(-)(n)](2)[SiO(k)()(/2)(OX)(4)(-)(k)](4), [M] = [PhPd(I)](1/2)P(Ph)(CH(2)Do)(CH(2))(3)-}, which insert carbon monoxide into the palladium-aryl bond even in the solid state.
PURPOSE: The purpose of this investigation was to examine the changes in wettability of dental impression materials during setting. This study compared the properties of the initial water contact of two different dental impression materials and their subsequent development during polymerization. MATERIALS AND METHODS: Two dental impression materials (Impregum Penta Soft and Aquasil) with different chemical compositions (polyether and polyvinyl siloxane, respectively) were investigated with respect to their changing wetting properties by time-resolved static contact angle measurements. Ten sets of measurements each were taken over a period of 400 seconds with 150 points of data each; the first pictures were used for further characterization of the initial interaction. RESULTS: With 73 degrees, Impregum Penta Soft exhibited a significantly lower contact angle, which stayed lower during the process of setting, compared to the silicone-based material. The initial interaction of the droplet showed a repulsive interaction of Aquasil with the water droplet. CONCLUSION: Impregum Penta Soft showed a more hydrophilic behavior during the process of setting compared to Aquasil and can therefore be expected to exhibit better flow properties. The method of time-resolved static contact angle measurements is a well-suited analytic instrument to monitor temporally changing wetting phenomena.