Biomedical subjects

Christofer Leygraf

Publications and source records attributed to Christofer Leygraf.

7 recordsLinked to original sources

PubMed2006

In vitro studies of copper release from powder particles in synthetic biological media.

The aim of this paper is to provide quantitative data on copper release from powder particles of different copper materials, including artificial copper patina, Cu(2)O and metallic Cu, when exposed to different synthetic biological media to simulate an inhalation scenario and/or skin contact. Generated data may contribute in risk assessment of potential health effects following exposure to and handling of various copper materials. All tests were performed in vitro to determine total copper concentrations, release rates of total copper, and to elucidate its time-dependence. The copper release process was interpreted in terms of specific surface area, surface morphology-, and composition. All powder materials show a time-dependent release process with total copper release rates less than 3 microg/cm(2) per hour at steady state conditions, for all media investigated. The importance of using relevant test media when simulating different interstitial lung conditions and difficulties encountered when comparing powder particles of essentially different properties are thoroughly discussed.

Air Pollutants↗

PubMed2006

Occurrence and fate of corrosion-induced zinc in runoff water from external structures.

This paper comprises data from an extensive cross-disciplinary research project aiming to elucidate the environmental fate of corrosion-induced zinc release from external structures. It includes an exposure assessment that provide long-term runoff rates, concentrations and chemical speciation of zinc, from 14 zinc-based materials exposed during 5 years in Stockholm, Sweden, and an effect assessment including bioavailability and ecotoxicity measurements, both at the immediate release situation and after soil interaction. Runoff rates of total zinc ranged from 0.07 to 2.5 g Znm-2 yr-1 with zinc primarily released as the free ion for all materials investigated. The average effect concentration, causing a 50% growth reduction after 72 h to the green algae Raphidocelis subcapitata, was at the immediate release situation 69 microg ZnL-1. Upon interaction of runoff water with soil, which simulated 18 to 34 years of exposure, the total zinc concentration was significantly reduced, from milligram per litre to microgram per litre levels. Simultaneously, the most bioavailable fraction of zinc in runoff, the hydrated zinc(II)-ion, decreased from more than 95% to about 30%. The major fraction, 98-99%, of the introduced total zinc concentration in the runoff water was retained within the soil. As long as the soil retention capacity was not reached, this resulted in zinc concentrations in the percolate water transported through the soil layer, close to background values and below growth inhibition concentrations for the green algae investigated. Zinc retained in soil was to a large extent (85-99.9%) extractable with EDTA, and available for plant uptake after 5 to 7 months of ageing.

Chlorophyta↗

PubMed2006

Long-term corrosion-induced copper runoff from natural and artificial patina and its environmental impact.

The overall objective of this paper is to present an extensive set of data for corrosion-induced copper dispersion and its environmental interaction with solid surfaces in the near vicinity of buildings. Copper dispersion is discussed in terms of total copper flows, copper speciation and bioavailability at the immediate release situation, and its changes during transport from source to recipient. Presented results are based on extensive field exposures (eight years) at an urban site, laboratory investigations of the runoff process, published field data, generated predictive site-specific runoff rate models, and reactivity investigations toward various natural and manmade surfaces, such as those in soil, limestone, and concrete. Emphasis is placed on the interaction of copper-containing runoff water with different soil systems through long-term laboratory column investigations. The fate of copper is discussed in terms of copper retention, copper chemical speciation, breakthrough capacities, and future mobilization based on changes in copper concentrations in the percolate water, computer modeling using the Windermere Humic Aqueous Model, and sequential extractions. The results illustrate that, for scenarios where copper comes in extensive contact with solid surfaces, such as soil and limestone, a large fraction of released copper is retained already in the immediate vicinity of the building. In all, both the total copper concentration in runoff water and its bioavailable part undergo a significant and rapid reduction.

Copper↗

PubMed2005

A vibrational sum frequency spectroscopy study of the liquid-gas interface of acetic acid-water mixtures: 2. Orientation analysis.

Vibrational sum frequency spectroscopy has been used to investigate the surface of aqueous acetic acid solutions. By studying the methyl and carbonyl vibrations with different polarization combinations, an orientation analysis of the acetic acid molecules has been performed in the concentration range 0-100%. The surface tension of acetic acid solutions was also measured in order to obtain the surface concentration. The orientation of the interfacial acetic acid molecules was found to remain essentially constant in an upright position with the methyl group directed toward the gas phase in the whole concentration range. The tilt angle (theta(CH)3) of the symmetry axis of the methyl group with respect to the surface normal was found to be lower than 15 degrees when considering a delta distribution of angles or as narrow as 0 +/- 11 degrees when assuming a Gaussian distribution. Further investigations showed that the C=O bond tilt (theta(C)(=)(O)) of the acetic acid hydrated monomer was constant and close to 55 degrees in the concentration range where it was detected. Finally, the orientation information is discussed in terms of different species of acetic acid, where the formation of a surface layer of acetic acid cyclic dimers is proposed at high acid concentrations.

Journal Article↗

PubMed2005

A vibrational sum frequency spectroscopy study of the liquid-gas interface of acetic acid-water mixtures: 1. Surface speciation.

Aqueous acetic acid solutions have been studied by vibrational sum frequency spectroscopy (VSFS) in order to acquire molecular information about the liquid-gas interface. The concentration range 0-100% acetic acid has been studied in the CH/OH and the C-O/C=O regions, and in order to clarify peak assignments, experiments with deuterated acetic acid and water have also been performed. Throughout the whole concentration range, the acetic acid is proven to be protonated. It is explicitly shown that the structure of a water surface becomes disrupted even at small additions of acetic acid. Furthermore, the spectral evolution upon increasing the concentration of acetic acid is explained in terms of the different complexes of acetic acid molecules, such as the hydrated monomer, linear dimer, and cyclic dimer. In the C=O region, the hydrated monomer is concluded to give rise to the sum frequency (SF) signal, and in the CH region, the cyclic dimer contributes to the signal as well. The combination of results from the CH/OH and the C-O/C=O regions allows a thorough characterization of the behavior of the acetic acid molecules at the interface to be obtained.

Journal Article↗

PubMed2004

Predictive models of copper runoff from external structures.

A general model for annual runoff rate predictions of total copper from naturally patinated copper on buildings at specific urban or rural sites of low chloride influence has been deduced from laboratory and field data. All parameters within the model have a physical meaning and include the average annual rain acidity (pH), the annual rain quantity and the geometry of a building in terms of surface inclination. In 70% of all reported annual runoff rates, the predicted values are within 30% from the observed values. The individual and interactive effect of rain composition in terms of pH, sulfate, chloride and nitrate concentration was investigated in immersion experiments in artificial rain water representative of urban and rural sites of Europe. The results show pH to have a dominating effect on patina dissolution, nitrate to have a small inhibiting effect, whereas no significant effect was seen for chloride and sulfate. In case pH data are not available, a model has been statistically deduced from field data by considering SO2 as influencing parameter, rather than pH. The predictability with the SO2 model is not as good as with the pH model i.e. the pH model should preferentially be used since it is a better predictor and all parameters within the model can be physically explained.

Chlorides↗

PubMed2002

Electrochemical impedance spectroscopy and X-ray photoelectron spectroscopy analysis of titanium surfaces cultured with osteoblast-like cells derived from human mandibular bone.

Variations in the oxide films on titanium surfaces blasted with TiO(2) particles of various sizes were analyzed after cultures with cells derived from human mandibular bone. Turned titanium surfaces and surfaces blasted with 63-90-, 106-180-, and 180-300-microm TiO(2) particles were cultured with osteoblast-like cells. The surfaces were characterized before and after the cell culture with electrochemical impedance spectroscopy (EIS). The surface chemical composition of selected samples was analyzed with X-ray photoelectron spectroscopy (XPS). EIS revealed that with respect to the turned surfaces, the effective surface area was about 5, 6, and 4 times larger on the surfaces blasted with 63-90-, 106-180-, and 180-300-microm particles, respectively. After 28 days of the cell culture, the corrosion resistance on all sample types was unaffected. The impedance characteristics suggest a considerable effect of ion incorporation and precipitation during culturing. XPS revealed that before the cell culture, a typical surface layer consisted of TiO(2). After the culture, the surface oxide film contained both phosphorus and calcium, along with large amounts of oxidized carbon (carbonate) and nitrogen. There were lower concentrations of carbon and nitrogen on the blasted surfaces. We concluded that the effective surface area was several times higher on blasted surfaces than on turned surfaces. Cells derived from human mandibular bone affected ion incorporation into the implant surface.

Cells, Cultured↗