Biomedical subjects

Claude Cohen

Publications and source records attributed to Claude Cohen.

5 recordsLinked to original sources

PubMed2005

Effect of chain stiffness and entanglements on the elastic behavior of end-linked elastomers.

The effect of chain stiffness and entanglements on the elastic behavior and microscopic structure of cross-linked polymer networks was studied using Monte Carlo simulations. We investigated the behavior of entangled and entanglement-free networks at various degrees of chain stiffness and densities. Based on previous results that indicated that trapped entanglements prevent strain-induced order-disorder transitions in semiflexible chain networks, we prepared the entangled networks by end-linking the chains in very dilute conditions so as to minimize the extent of trapped entanglements. We also considered the entanglement-free case by using a "diamond" structure. We found that the presence of even a very small amount of trapped entanglements is enough to prevent a discontinuous strain-induced transition to an ordered phase. In these mildly entangled networks, a nematiclike order is eventually attained at high extensions but the elastic response remains continuous and the cross-links remain uniformly distributed through the simulation box. The entanglement-free diamond networks on the other hand show discontinuities in their stress-strain data. Networks at higher densities exhibit a more stable ordered phase and show an unusual staircaselike stress-strain curve. This is the result of a stepwise extension mechanism in which the chains form ordered domains that exclude the cross-links. Extension is achieved by increasing the number of these ordered domains in the strain direction. Cross-links aggregate in the spaces between these ordered domains and form periodic bands. Each vertical upturn in the stress-strain data corresponds to the existence of an integer number of ordered domains. This stepwise elastic behavior is found to be similar to that exhibited by some tough natural materials.

Anisotropy↗

PubMed2005

Engineered polymeric nanoparticles for bioremediation of hydrophobic contaminants.

Sorption of hydrophobic organic contaminants, such as polycyclic aromatic hydrocarbons (PAHs), to soil has been shown to limit their solubilization rate and mobility. In addition, sequestration of contaminants by sorption to soil and by partitioning in nonaqueous phase liquids (NAPLs) reduces their bioavailability. Polymeric nano-network particles have been demonstrated to increase the "effective" solubility of a representative hydrophobic organic contaminant, phenanthrene (PHEN) and to enhance the release of PHEN from contaminated aquifer material. In this study, we investigate the usefulness of nanoparticles made from a poly(ethylene) glycol modified urethane acrylate (PMUA) precursor chain, in enhancing the bioavailability of PHEN. PMUA nanoparticles are shown to increase the mineralization rate of PHEN crystal in water, PHEN sorbed on aquifer material, and PHEN dissolved in a model NAPL (hexadecane) in the presence of aquifer media. These results show that PMUA particles not only enhance the release of sorbed and NAPL-sequestered PHEN but also increase its mineralization rate. The accessibility of contaminants in PMUA particles to bacteria also suggests that particle application may be an effective means to enhance the in-situ biodegradation rate in remediation through natural attenuation of contaminants. In pump-and-treat or soil washing remediation schemes, bioreactors could be used to recycle extracted nanoparticles. The properties of PMUA nanoparticles are shown to be stable in the presence of a heterogeneous active bacterial population, enabling them to be reused after PHEN bound to the particles has been degraded by bacteria.

Adsorption↗

PubMed2004

Stepwise elastic behavior in a model elastomer.

Monte Carlo simulations of an entanglement-free cross-linked polymer network of semiflexible chains reveal a peculiar stepwise elastic response. For increasing stress, step jumps in strain are observed that do not correlate with changes in the number of aligned chains. We show that this unusual behavior stems from the ability of the system to form multiple ordered chain domains that exclude the cross-linking species. This novel elastomer shows a toughening behavior similar to that observed in biological structural materials, such as muscle proteins and abalone shell adhesive.

Biomimetic Materials↗

PubMed2004

Engineered polymeric nanoparticles for soil remediation.

Hydrophobic organic groundwater contaminants, such as polynuclear aromatic hydrocarbons (PAHs), sorb strongly to soils and are difficult to remove. We report here on the synthesis of amphiphilic polyurethane (APU) nanoparticles for use in remediation of soil contaminated with PAHs. The particles are made of polyurethane acrylate anionomer (UAA) or poly(ethylene glycol)-modified urethane acrylate (PMUA) precursor chains that can be emulsified and cross-linked in water. The resulting particles are of colloidal size (17-97 nm as measured by dynamic light scattering). APU particles have the ability to enhance PAH desorption and transport in a manner comparable to that of surfactant micelles, but unlike the surface-active components of micelles, the individual cross-linked precursor chains in APU particles are not free to sorb to the soil surface. Thus, the APU particles are stable independent of their concentration in the aqueous phase. In this paper we show that APU particles can be engineered to achieve desired properties. Our experimental results show that the APU particles can be designed to have hydrophobic interior regions that confer a high affinity for phenanthrene (PHEN) and hydrophilic surfaces that promote particle mobility in soil. The affinity of APU particles for contaminants such as PHEN can be controlled by changing the size of the hydrophobic segment used in the chain synthesis. The mobility of colloidal APU suspensions in soil is controlled by the charge density or the size of the pendent water-soluble chains that reside on the particle surface. Exemplary results are provided illustrating the influence of alternative APU particle formulations with respect to their efficacy for contaminant removal. The ability to control particle properties offers the potential to produce different nanoparticles optimized for varying contaminant types and soil conditions.

Engineering↗

PubMed2001

Electrical Double-Layer Effects on the Brownian Diffusivity and Aggregation Rate of Laponite Clay Particles.

Dynamic light scattering was used to study the Brownian translational diffusion and rate of Brownian aggregation of Laponite (RD) clay particles at low (millimolar) electrolyte concentrations. Laponite is a manufactured clay consisting of monodisperse disk-shaped particles with a 30-nm diameter and a 1-nm thickness. The stability ratio, defined as the ratio of the coagulation rate for Brownian spheres with no particle interactions to the observed coagulation rate, was quite large O(10(5)), suggesting that there was a large potential energy barrier to Brownian aggregation. The apparent potential energy barrier for face-edge aggregation was rationalized on the basis of a calculation of the electrostatic interactions between two disks with negative face charges and positive rim charges. The aggregation rate increased with increasing electrolyte concentration owing to the screening of the electrostatic repulsion associated with the net charge on the particle. The rate decreased with increasing pH because of the decreasing positive charge on the rim. The translational diffusivity of the individual particles before the onset of aggregation exhibited a strong dependence on the electrolyte concentration and was as much as 50% smaller than the diffusivity for an uncharged disk. This effect is attributed to the added drag resulting from the electroviscous effects in the deformed double layer. The electroviscous effect on the diffusion of the disk-like particles is much stronger than that on rods and spheres. Copyright 2001 Academic Press.

Journal Article↗