PubMed Health⌕ Search

Biomedical subjects

Claudio De Rosa

Publications and source records attributed to Claudio De Rosa.

9 recordsLinked to original sources

A study of the microstructural and diffusion properties of poly(vinyl alcohol) cryogels containing surfactant supramolecular aggregates.

Surfactant-containing poly(vinyl alcohol) (PVA) cryogels have been prepared by drying and reswelling hydrogel patches, previously obtained by the freeze/thaw procedure, in decyltrimethylammonium bromide (C10TAB) aqueous solutions. The microstructural and diffusive properties of the resulting material have been characterized by a combined experimental strategy. Gravimetric measurements show that the cryogel maximum swelling is not affected by the surfactant. The surfactant concentration within the cryogel, measured by ion chromatography, is the same as that in the rehydrating surfactant solution. Electron paramagnetic resonance (EPR) spin-probe and small-angle neutron scattering (SANS) measurements show that surfactant self-aggregation in the gel is similar to that in water, occurring at the same critical concentration and resulting in the formation of micellar aggregates whose structure is not affected by the cryogel polymeric scaffold. However, both the micelle intradiffusion coefficients, measured by PGSE-NMR, and the spin-probe correlation times, measured by EPR, indicate that dynamic processes in the hydrogel are much slower than in bulk water. A quantitative analysis of these results suggests that the cryogel polymer-poor domains, in which surfactant molecules are solubilized, have an average dimension of approximately 0.1 microm. Interestingly the experimental data also show that the polymer-poor phase contains more polymer than expected, suggesting that the spinodal decomposition, which occurs during the freezing step of cryogel preparation, is not complete or prevented by ice formation.

Journal Article↗

Structural-mechanical phase diagram of isotactic polypropylene.

The polymorphic transformations associated with the plastic deformation of isotactic polypropylene samples of different stereoregularity, prepared with different metallocene catalysts, have been studied. Crystals of alpha or gamma forms, present in the unstretched samples, transform into the mesomorphic form by stretching. The formation of the mesophase facilitates successive further deformation up to very high strains and produces development of outstanding unusual properties of high flexibility and elasticity. The phase diagram of isotactic polypropylene, where the regions of stability of the different polymorphic forms are defined as a function of stereoregularity and degree of deformation, is reported.

Journal Article↗

A microscopic insight into the deformation behavior of semicrystalline polymers: the role of phase transitions.

The deformation behavior of semicrystalline polymers associated with polymorphic transformations under tensile deformation is discussed in the case of syndiotactic polypropylene. We report a phase diagram of this polymer where the regions of stability of the different polymorphic forms are defined as a function of the degree of stereoregularity and deformation. The values of critical strain corresponding to the structural transformations depend on the stereoregularity that affects the relative stability of the involved polymorphic forms and the state of the entangled amorphous phase.

Crystallization↗

Crystal structure of the trigonal form of isotactic polypropylene as an example of density-driven polymer structure.

Propene-hexene copolymers crystallize in a new polymorphic form of isotactic polypropylene when the concentration of hexene is higher than nearly 10-15 mol %. The hexene units are included in the crystals, inducing an increase of density that allows crystallization of 3-fold helical chains in a trigonal unit cell according to the space group R3c or Rc, where the helical symmetry of the chains is maintained in the crystal lattice. The structure of this new form is similar to those of isotactic polybutene and polystyrene and does not crystallize in polypropylene homopolymer because it would have too low density. The crystal structure of isotactic polypropylene is therefore no longer an exception to the principles of polymer crystallography, but the new structure represents the fulfillment of these principles and indicates that the packing of polymer molecules is mainly driven by density.

Journal Article↗

Crystals and crystallinity in polymeric materials.

A new view of the concepts of crystallinity and crystals in synthetic macromolecules is discussed. In polymeric materials, crystallinity may be present with the concomitant occurrence of large amounts of structural disorder and in the absence of true three-dimensional long-range order. The structures of semicrystalline polymeric materials are discussed in terms of idealized limit models of crystals, where long-range order may be achieved for structural features that are not necessarily coincident with single atoms and are not necessarily point-centered. Typical examples of non-point-centered structural features are the straight lines corresponding to the chain axes of polymer molecules. This view explains the unusual ability of polymers to crystallize even in the presence of a high degree of structural disorder.

Journal Article↗

Structure-property correlations in polypropylene from metallocene catalysts: stereodefective, regioregular isotactic polypropylene.

A series of MAO-activated C(1)-symmetric indenyl-ansa-dithienocyclopentadienyl-based zirconocenes have been used to produce isotactic polypropylenes of medium to high molecular weights, of different degrees of stereoregularity, and free from regioerrors. The effect of the presence of rr defects on the polymorphic behavior and mechanical properties of polypropylene is analyzed. The presence of rr defects induces crystallization of gamma form and of disordered modifications intermediate between alpha and gamma forms. A linear relationship between the amount of gamma form and the average length of isotactic sequences has been found. Samples with low concentration of rr defects, up to 3-4%, present high melting temperatures, in the range 160-130 degrees C, and behave as stiff-plastic materials; sample with higher rr content, in the range 4-6% and melting temperatures around 115-120 degrees C are highly flexible thermoplastic materials, and, finally, samples with concentration of rr defects in the range 7-11% and melting temperatures in the range 80-110 degrees C are thermoplastic elastomers with high strength. The fine-tuning of the chain microstructure, achieved by a tailored design of new metallocene catalysts, has allowed production of new polypropylenes having desired properties, intermediate between those of stiff plastic and elastomeric materials.

Journal Article↗

New concepts in thermoplastic elastomers: the case of syndiotactic polypropylene, an unconventional elastomer with high crystallinity and large modulus.

Syndiotactic polypropylene (sPP), despite high crystallinity, shows unusual elastic properties, associated with a reversible crystal-crystal phase transition. The mechanism behind the crystal-crystal phase transition involved during cyclic elongation and recovery and the time scale of this process is here investigated, to unravel the origin of the elasticity of such an unconventional elastomer. The structural transformation of fibers of sPP during deformation has been studied by wide-angle X-ray diffraction measurements, using the high flux available on the beamline ID11 at the European Syncrotron Radiation Facility (ESRF), Grenoble, France, performing a time-resolved analysis of structural changes occurring while cyclically stretching and relaxing sPP fibers. This analysis indicates that the stress-induced phase transition is a martensitic transformation. As in martensitic phase transitions it occurs readily and directly, supporting the idea that elasticity in sPP is partially of enthalpic nature.

Journal Article↗

Synthesis and characterization of high-molecular-weight syndiotactic amorphous polypropylene.

Heterocycle-fused titanium indenyl silylamido dimethyl complexes produce very high molecular weight polypropylene having a prevailingly syndiotactic microstructure with syndiotactic pentad contents rrrr up to 40-55% (sam-PP). The samples are basically amorphous and may slowly develop a low level of crystallinity (16-20%) at room temperature. A structural characterization has shown that sam-PP samples crystallize in disordered modifications of the helical form I of syndiotactic polypropylene (s-PP). The stretching of compression-molded films of sam-PP samples produce oriented crystalline fibers in the trans-planar mesomorphic form of s-PP. The low stereoregularity prevents the formation of the ordered trans-planar form III of s-PP, which instead is obtained in stretched fibers of the highly stereoregular and crystalline s-PP. The trans-planar mesomorphic form, obtained in stretched fibers, in turn transforms into the helical form I upon releasing the tension. The analysis of the mechanical properties has shown that sam-PP samples show good elastic behavior in a large range of deformation with remarkable strength, due to the presence of crystallinity. A comparison with the mechanical properties of less syndiotactic and fully amorphous samples is reported. These fully amorphous samples present lower strength and experience rapid viscous flow of the chains at high deformations and/or by application of stresses for long times. The higher strength in the semicrystalline sam-PP samples makes these materials interesting thermoplastic elastomers showing high toughness and ductility.

Journal Article↗