Biomedical subjects

Corrado Muzzarelli

Publications and source records attributed to Corrado Muzzarelli.

5 recordsLinked to original sources

PubMed2006

5-methyl-pyrrolidinone chitosan films as carriers for buccal administration of proteins.

The purpose of this research was to investigate 5-methyl-pyrrolidinone chitosan (MPC) films as carriers for buccal delivery of protein drugs. Placebo and protein-loaded MPC films were prepared by casting and were then cross-linked with tripolyphosphate at different pH conditions. Myoglobin (MHb) was chosen as the model protein because its molecular weight is under the permeability limit of the buccal mucosa. The observed characteristics like bioadhesiveness, swelling behavior, and in vitro release of MHb from loaded films furnish information on the functional behavior of these films. The results obtained show that the modulation of MHb release was achieved only through chitosan cross-linking; the best results in release rate control were obtained by cross-linking performed at pH 6.5. Good bioadhesion properties were maintained even with high cross-linking degrees; the swelling index of MHb-loaded films at different cross-linking degrees evaluated at pH 7.4 and pH 6.4 were comparable to those of placebo films. By setting suitable tripolyphosphate cross-linking conditions for MPC films, one can control protein release without affecting bioadhesion.

Administration, Buccal↗

PubMed2005

The biocompatibility of dibutyryl chitin in the context of wound dressings.

Dibutyryl chitin (DBC) is a modified chitin carrying butyryl groups at 3 and 6 positions; its peculiarity is that it dissolves promptly in common solvents, while being insoluble in aqueous systems. The high biocompatibility of dibutyryl chitin in the form of films and non-wovens has been demonstrated for human, chick and mouse fibroblasts by the Viability/Cytotoxicity assay, In situ Cell Proliferation assay, Neutral Red Retention assay, Lactate Dehydrogenase Release assay, MTS cytotoxicity assay, and scanning electron microscopy. DBC was hardly degradable by lysozyme, amylase, collagenase, pectinase and cellulase over the observation period of 48 days at room temperature, during which no more than 1.33% by weight of the DBC filaments (0.3 mm diameter) was released to the aqueous medium. DBC non-wovens were incorporated into 5-methylpyrrolidinone chitosan solution and submitted to freeze-drying to produce a reinforced wound dressing material. The latter was tested in vivo in full thickness wounds in rats. The insertion of 4x4 mm pieces did not promote any adverse effect on the healing process, as shown histologically. DBC is therefore suitable for contacting intact and wounded human tissues.

Amylases↗

PubMed2004

Assessment of chitosan derivatives as buccal and vaginal penetration enhancers.

The aim of the present work was to evaluate the mucoadhesive and penetration enhancement properties via the buccal and vaginal mucosae of four different chitosan derivatives: 5-methyl-pyrrolidinone chitosan (MPC), two low molecular weight chitosans (DC1 and DC2) and a partially reacetylated chitosan (RC). Chitosan HCl was used as a reference. Polymer solutions (4% w/w) were prepared in media simulating the buccal (pH 6.4 buffer or water) and the vaginal (pH 5.0 buffer) environments and subjected to rheological characterization. Acyclovir was added to the polymer solutions at 5% (w/w) concentration. The mucoadhesive properties of the polymer solutions were measured using excised porcine cheek or vaginal mucosa and mucin dispersions to simulate the buccal or vaginal environments, respectively. Drug permeation and penetration tests were carried out using porcine cheek and vaginal mucosae as model membranes. Acyclovir aqueous suspensions prepared in pH 6.4 and 5.0 buffers were used as blanks. Drug release measurements were also carried out in the same conditions employed for the permeation and penetration tests. Methyl-pyrrolidinone chitosan shows the best mucoadhesive and penetration enhancement properties in both buccal and vaginal environments. The capability to enhance the permeation/penetration of acyclovir was decreased by partial depolymerization of chitosan and disappeared after partial reacetylation.

Acyclovir↗

PubMed2003

Alkaline chitosan solutions.

Rigid and transparent hydrogels were obtained upon pouring chitosan salt solutions into saturated ammonium hydrogen carbonate. Incubation at 20 degrees C for 5 days yielded chitosan carbamate ammonium salt, Chit-NHCO(2)(-)NH(4)(+) a chemical species that either by hydrolysis or by thermal treatment decomposed to restore chitosan in free amine form. Chitosans of different degrees of acetylation, molecular sizes and origins (squid and crustaceans) were used as hydrochloride, acetate, glycolate, citrate and lactate salts. Their hydrogels obtained in ammonium hydrogen carbonate yielded chitosan solutions at pH values as high as 9.6, from which microspheres of regenerated chitosans were obtained upon spray-drying. These materials had a modest degree of crystallinity depending on the partial acylation that took place at the sprayer temperature (168 degrees C). Citrate could cross-link chitosan and impart insolubility to the microspheres. Chloride on the contrary permitted to prepare microspheres of chitosan in free amine form. By the NH(4)HCO(3) treatment, the cationicity of chitosan could be reversibly masked in view of mixing chitosan with alginate in equimolar ratio without coacervation. The clear and poorly viscous solutions of mixed chitosan carbamate and alginate were spray-dried at 115 degrees C to manufacture chitosan-alginate microspheres having prevailing diameter approx 2 micron.

Alginates↗

PubMed2002

Natural and artificial chitosan-inorganic composites.

Taking inspiration from many chitin-inorganic composites in nature, a number of recent articles throw light on the manufacture of such composites based on calcium carbonate, calcium phosphate and silica. These novel materials are important in the field of blood-compatible materials, bone substitutes, and cements for bone repair and reconstruction. This approach provides an attractive alternative to the processing of inorganic thin films, especially in applications where substrates cannot be exposed to high temperatures.

Animals↗