Cynthia J Sprecher | PubMed Health

PubMed2002

Detection of a primer-binding site polymorphism for the STR locus D16S539 using the Powerplex 1.1 system and validation of a degenerate primer to correct for the polymorphism.

Quality assurance samples submitted from the NCSBI as part of a contract with TBTG to outsource DNA Database samples showed unexpected discrepancies for the locus D16S539 when all other loci yielded identical results. Discrepancies observed included allele drop out and an imbalance in sister alleles with samples returned from TBTG. This led to a comprehensive review of the technical procedures used between the two laboratories to determine the cause of the discrepancies noted for the locus D16S539, since both laboratories were using the PowerPlex 1.1 typing kit from the Promega Corporation. The NCSBI and the TBTG utilize different extraction methods (organic extraction vs. FTA) and amplification conditions (AmpliTaq vs AmpliTaq Gold), respectively, so the exact cause of discrepancy observed was not immediately apparent. Experiments at the NCSBI associated the observed allele drop out and the imbalance of the sister alleles with the use of AmpliTaq Gold and a hot start procedure. Sequencing data revealed that a point mutation resides on the D16S539 primer-binding site that reaches polymorphic levels in African-American populations. This led to the development of a degenerate primer by the Promega Corporation to detect "missing" alleles when AmpliTaq Gold is used. The degenerate primer was then thoroughly tested to show its efficacy in detecting the "true" D16S539 profile when used.

Allelic Imbalance↗

PubMed2002

Validation of a 16-locus fluorescent multiplex system.

STR multiplexes have been indispensable for the efficient genotyping of forensic samples. The PowerPlex 16 System contains the coreCODIS loci, D3S1358, D5S818, D7S820, D8S1179, D13S317, D16S539, D18S51, D21S11, CSF1PO, FGA, THOI, TPOX, vWA, the sex determinant locus, amelogenin, and two pentanucleotide STR loci, Penta D and Penta E. This multiplex satisfies the locus requirements for most national databases and is the most efficient currently available system due to its single PCR amplification. To provide the groundwork for judicial acceptance, including the publication of primer sequences, and to evaluate laboratory-to-laboratory variation, a developmental validation for casework on this commercially available system was performed in 24 laboratories and produced the following conclusions. Amplification was reliable on a variety of thermal cyclers and product could be analyzed on either an ABI PRISM 310 Genetic Analyzer or an ABI PRISM 377 DNA Sequencer. Genotyping using single source samples was consistent between 0.25 and 2 ng of input DNA template with a few laboratories obtaining complete genotypes at 0.0625 ng. However, heterozygote allele imbalance (<60% peak height balance) caused by stochastic effects was observed at a rate of 13% with 0.125 ng DNA and 22% at 0.0625 ng DNA. Mixture analyses were done using a total of 1 ng of DNA template. Most alleles were detected in mixtures of 4 to 1 and some minor alleles were detected in mixtures of 19 to 1. Optimum amplification cycle number was dependent on the sensitivity of the detection instrument used and could also be adjusted to accommodate larger amounts of DNA on solid supports such as FTA paper. Reaction conditions including volume, annealing temperature, and concentrations of primer, AmpliTaq Gold, and magnesium were shown to be optimal yet robust enough to withstand moderate variations without affecting genotype analysis. Environmental, matrix and standard source analyses revealed an ability to obtain complete genotypes in all sample types except those exposed to 80 degrees C for 12-48 days. Finally, comparison of genotype results from the PowerPlex 16 System with other commercially available systems on non-probative reference and forensic samples showed consistent results.

Alleles↗