PubMed Health⌕ Search

Biomedical subjects

Cynthia R Lee

Publications and source records attributed to Cynthia R Lee.

9 recordsLinked to original sources
PubMed2006

An in vitro organ culturing system for intervertebral disc explants with vertebral endplates: a feasibility study with ovine caudal discs.

STUDY DESIGN: Whole ovine caudal intervertebral discs with vertebral endplates were cultured under uniaxial diurnal loading for 7 days. OBJECTIVES: To establish and characterize an organ culture system for intervertebral discs, in which disc cells may be "maintained" in their native three-dimensional environment under load. SUMMARY OF BACKGROUND DATA: In vitro culturing of entire discs with preserved biologic and structural integrity would be a useful model to study the effects of nutrition and mechanical loading. METHODS: To maintain endplate permeability, sheep were systemically anticoagulated before death and their caudal vasculature was evacuated with saline postmortem. The first 4 caudal discs were explanted with their adjacent endplates and cultured in bioreactors under uniaxial diurnal loading (0.2 MPa for 8 hours and 0.8 MPa for 16 hours) for 4 or 7 days. Solute transport into the center of the disc was measured after 4 days of culture using a low molecular weight fluorescent marker. Cell viability, glycosaminoglycan synthesis rate, and gene expression profile were measured after 7 days of culture and compared with fresh tissue. RESULTS: Fluorescent images showed that solutes could diffuse into the disc under both static and diurnal loading, but penetration through the endplate increased with diurnal loading. Cell viability and glycosaminoglycan synthesis rates remained unchanged after 7 days of culture. Expression of catabolic genes was significantly up-regulated, whereas anabolic genes tended to be down-regulated after 7 days. CONCLUSIONS: With this novel preparation and culturing technique, endplate permeability could be maintained, which allowed culturing of intact disc explants with endplates for up to 7 days.

Animals↗
PubMed2006

In vitro organ culture of the bovine intervertebral disc: effects of vertebral endplate and potential for mechanobiology studies.

STUDY DESIGN: Whole bovine coccygeal discs were cultured under static load, with or without vertebral endplates (VEPs), and assessed for cell viability, biochemical stability, biosynthetic activity, and biosynthetic responsiveness to changes in mechanical load. OBJECTIVES: To assess the effects of VEPs on biochemical and cellular stability of disc cells during in vitro culture of large disc explants. To determine whether cultured discs could respond to mechanical perturbation. SUMMARY OF BACKGROUND DATA: Previous methods for culturing the intervertebral disc have focused on rabbit and rat discs, but the small size of these discs limits the relevance of these culture systems to the human condition. Bovine coccygeal discs have similar dimensions to the human lumbar disc (i.e., similar size and nominal stresses), but long-term culture of these discs has not been reported. METHODS: Bovine coccygeal discs were harvested with or without VEPs, cultured under static load (5 kg, approximately 0.25 MPa, in situ swelling pressure) for up to 1 week, and evaluated for changes in hydration, glycosaminoglycan content, cell viability, and biosynthetic activity. Additionally, the biochemical and biosynthetic response of discs cultured without VEP to increasing the load to a 20-kg (approximately 1 MPa, the estimated stress in human lumbar disc during heavy lifting) static load for 6 hours was assessed. RESULTS: During the first 24 hours, culturing discs with endplates was moderately better with regards to maintaining in situ anulus hydration and nucleus glycosaminoglycan levels. The endplates, however, obstructed media flow to the disc, resulting in a marked decrease in cell viability after 1 week of culture. Nucleus pulposus cell viability was maintained in discs cultured without endplates, but there was a significant drop in biosynthetic activity within 2 days of culture. Despite this drop, the disc cells in the discs without VEP remained biosynthetically responsive to changes in mechanical loading. CONCLUSIONS: It is possible to maintain cell viability and the biosynthetic responsiveness of large discs for up to 1 week in vitro when the discs are cultured under static load and without VEP.

Animals↗
PubMed2005

The effects of short-term load duration on anabolic and catabolic gene expression in the rat tail intervertebral disc.

The goal of this study was to determine the time-dependent response of the intervertebral disc cells to in vivo dynamic compression. Forty-seven skeletally mature Wistar rats (>12 months old) were instrumented with an Ilizarov-type device spanning caudal disc 8-9. Using a load magnitude (1 MPa) and frequency (1.0 Hz) that were previously shown to significantly alter mRNA levels in the disc, the effects of 0.5 and 4 h of loading were investigated and compared to a sham group and our previous 2 h results. Annulus and nucleus tissue of loaded (c8-9) and internal control discs (c6-7 and c10-11) were separately analyzed by real-time RT-PCR for levels of mRNA coding for various anabolic (collagen-1A1, collagen-2A1, aggrecan) and catabolic (MMP-3, MMP-13, ADAMTs-4) proteins. In the annulus, mRNA levels increased for Collagen types I & II, and MMP 3 & 13 with increasing load duration. In contrast, the nucleus had the largest increases in aggrecan, ADAMTs-4, MMP-3 and MMP-13 after 2 h of loading, with aggrecan and MMP-13 mRNA levels returning to control values after 4 h of loading. Taken in context with our previous studies, we conclude that intervertebral disc cells from the nucleus and annulus have distinct responses to dynamic mechanical compression in vivo with sensitivity to compression magnitude, frequency and duration.

ADAM Proteins↗
PubMed2004

Anabolic and catabolic mRNA levels of the intervertebral disc vary with the magnitude and frequency of in vivo dynamic compression.

The goal of this study was to characterize the anabolic and catabolic mRNA response of the disc to dynamic loading to determine if variations in the magnitude and/or frequency of loading could elicit different cellular responses. Sixty-eight Wistar rats were instrumented with an Ilizarov-type device spanning caudal disc 8-9. Seventy-two hours after surgery, animals were anesthetized and loaded at either 1 or 0.2 MPa at a frequency of 1, 0.2 or 0.01 Hz for 2 h (6 groups). The surgical control (Sham) animals underwent anesthesia with no loading. Loaded (c8-9) and internal-control discs (c6-7 and c10-11) were dissected and annulus and nucleus tissue were separately analyzed by real-time RT-PCR for levels of anabolic (collagen-1A1, collagen-2A1, aggrecan) and catabolic (MMP-3, MMP-13, ADAMTs-4) mRNA. In the nucleus, a frequency-dependent response was seen at 1 MPa with anabolic genes stimulated at 0.01 Hz and catabolic genes at 1 Hz. In the annulus all frequencies resulted in significant up-regulation of catabolic mRNA at 1 MPa loading. In general loading at 0.2 MPa or 0.2 Hz had little effect on gene expression. The results suggest that gene expression of the annulus appears to be more dependent on the magnitude of applied stress, while the nucleus is both magnitude- and frequency-dependent.

ADAM Proteins↗
PubMed2003

Effects of immobilization and dynamic compression on intervertebral disc cell gene expression in vivo.

STUDY DESIGN: An in vivo analysis of the intervertebral disc's cellular response to dynamic compression and immobilization was performed using a rat-tail model. OBJECTIVE: To assess the effects of immobilization and short-term dynamic compression on intervertebral disc cell expression of anabolic and catabolic genes. SUMMARY OF BACKGROUND DATA: Static compressive loads applied in vivo alter the composition of the disc matrix and cell viability in a dose-dependent manner. The effects of in vivo dynamic compression, which is a more physiologic load, and reported risk factor for low back pain have not been investigated. METHODS: An Ilizarov-type device was implanted on the rat tail and used to determine the effects from 72 hours of immobilization (n = 6), 2 hours of dynamic compression (1 MPa/0.2 Hz) (n = 8), and the coupled effect of immobilization followed by compression (n = 8). Real-time reverse transcription-polymerase chain reaction was used to measure changes in anabolic and catabolic gene levels relative to both internal control subjects and a sham-operated group (n = 7). RESULTS: Immobilization and dynamic compression affect anabolic and catabolic genes, with an overall downregulation of types 1 and 2 collagen and upregulation of aggrecanase, collagenase, and stromelysin in the anulus. The effects of immobilization and compression appear to be additive for collagen types 1 and 2 in the anulus, but not in the nucleus, and not for catabolic genes. CONCLUSIONS: Short-duration dynamic compression and immobilization alter gene expression in the rat disc. In studying the response of the disc to loading, it is necessary to look at both anabolic and catabolic pathways, and to consider strain history.

Aggrecans↗
PubMedDate not supplied

Fibrin-polyurethane composites for articular cartilage tissue engineering: a preliminary analysis.

In this study we investigated the use of a fibrin hydrogel to improve the potential of a polyurethane (PU) scaffold-based system for articular cartilage tissue engineering. PU-only ("no-fibrin") and PU-fibrin ("fibrin") composites were cultured for up to 28 days and analyzed for DNA content, glycosaminoglycan (GAG) content, type II collagen content, GAG release, and gene expression of aggrecan, collagen I, and collagen II. The use of fibrin allowed for higher viable cell-seeding efficiency (10% higher DNA content on day 2 in fibrin versus no-fibrin composites) and more even cell distribution on seeding, a more than 3-fold increase in the percentage of newly synthesized GAG retained in the constructs, and 2- to 6-fold higher levels of type II collagen and aggrecan gene expression through day 14. Addition of aprotinin to the medium inhibited fibrin degradation, most noticeably in the center of the constructs, but had little effect on biochemical composition or gene expression. Short-term mechanical compression (0-10% sinusoidal strain at 0.1 Hz for 1 h, applied twice daily for 3 days) doubled the rate of GAG release from the constructs, but had little effect on gene expression, regardless of the presence of fibrin. Although further work is needed to optimize this system, the addition of fibrin hydrogel to encapsulate cells in the stiff, macroporous PU scaffold is a step forward in our approach to articular cartilage tissue engineering.

Aggrecans↗
PubMedDate not supplied

Surface motion upregulates superficial zone protein and hyaluronan production in chondrocyte-seeded three-dimensional scaffolds.

A cartilage engineering bioreactor has been developed that provides joint-specific kinematics. This study investigated the effect of articular motion on the gene expression of superficial zone protein (SZP) and hyaluronan synthases (HASs) and on the release of SZP and hyaluronan of chondrocytes seeded onto biodegradable scaffolds. Cylindrical (8 x 4 mm) porous polyurethane scaffolds were seeded with bovine articular chondrocytes and subjected to static or dynamic compression, with and without articulation against a ceramic hip ball. After loading, the mRNA expression of SZP and HASs was analyzed, and SZP immunoreactivity and hyaluronan concentration of conditioned media were determined. Surface motion significantly upregulated the mRNA expression of SZP and HASs. Axial compression alone had no effect on SZP and increased HAS mRNA only at high strain amplitude. SZP was immunodetected only in the media of constructs exposed to surface motion. The release of hyaluronan into the culture medium was significantly enhanced by surface motion. These results indicate that specific stimuli that mimic the kinematics of natural joints, such as articular motion, may promote the development of a functional articular surface-synovial interface.

Animals↗
PubMedDate not supplied

Chondrocyte gene expression under applied surface motion.

A cartilage bioreactor has been designed that is intended to approximate the kinematics of natural joints and allows for functional cartilage tissue engineering studies. In particular, interface motion can be generated by oscillation of a ball over the surface of a construct. The present study investigated the specific effect of applied articular motion on the gene expression of chondrocytes cultured in 3D scaffolds, with a particular emphasis on different superficial zone protein (SZP)/lubricin transcripts. Cylindrical porous polyurethane scaffolds were seeded with bovine articular chondrocytes and subjected to dynamic compression, with or without articulation against a ceramic hip ball. Articular motion markedly up-regulated the mRNA expression of the four previously described and two newly identified SZP/lubricin isoforms and of cartilage oligomeric matrix protein (COMP), and, to a lesser extent, aggrecan, type II collagen and TIMPs, while axial compression alone had no effect on the chondrocytes' gene expression levels. These results demonstrate the beneficial effect of articular motion not only for stimulation of important lubricating molecules, but also for the preservation of the chondrocytic phenotype.

Animals↗