D A Ksienski | PubMed Health

PubMed1992

A minimum profile uniform current density electrode.

Present methods of determining the safe injected charge levels for disk-type electrodes are given in terms of an average charge density, although the charge density is higher near the periphery of the electrode. This paper describes an electrode that produces an injected charge density that is uniform over the surface of the electrode and thus permits maximum utilization of the surface. Charge density is the time integral of current density, and the alteration of the current density is obtained by adding curvature to the electrode and recessing it within a cylindrical insulating well. A novel numerical method is used to determine the recession and curvature, and this numerical method is also presented. The benefit of this technique is that it permits a reduction in the electrode size while maintaining the maximum safe injected charge level of a disk-type electrode. A minimum profile uniform current density electrode and the algorithms used in its design are presented in this paper. Finally, a flat electrode that is recessed by as little as 1/10 of its diameter is shown to have an injected current density on the electrode surface that is superior to that of a flat surface mounted electrode.

Algorithms↗

PubMed1990

A nerve cuff technique for selective excitation of peripheral nerve trunk regions.

Numerical modeling and experimental testing of a nerve cuff technique for selective stimulation of superficial peripheral nerve trunk regions is presented. Two basic electrode configurations ("snug" cuff monopolar and tripolar longitudinally aligned dots) have been considered. In addition, the feasibility of "steering" excitation into superficial nerve trunk regions using subthreshold levels of current flow from an electrode dot located on the opposite side of the nerve has been tested. Modeling objectives were to solve for the electric field that would be generated within a representative nerve trunk by each electrode configuration; and to use a simple nerve cable model to predict the effectiveness of each configuration in producing localized excitation. In three acute experiments on cat sciatic nerve the objective was to characterize the effectiveness of each electrode configuration in selectively activating only the medial gastrocnemius muscle. Modeling and experimentation both suggest that longitudinally aligned tripolar dot electrodes on the surface of a nerve trunk, and bounded by a layer of insulation (such as a nerve cuff), will restrict excitation to superficial nerve trunk regions more successfully than will monopolar dot electrodes. Excitation "steering" will improve the spatial selectivity of both monopolar and tripolar electrode configurations.

Animals↗