Biomedical subjects

D Chaffin

Publications and source records attributed to D Chaffin.

7 recordsLinked to original sources

PubMed2000

Computer-aided ergonomics: a case study of incorporating ergonomics analyses into workplace design.

One of the primary goals of computer-aided ergonomics is to develop software tools that allow ergonomics information to be accessed at the earliest stages of design. This case study discusses a PC-based software program that allows a designer to quantify a worker's biomechanical risk for injury based on a proposed workplace design. The program couples an established software tool for biomechanical analysis, the Three-Dimensional Static Strength Prediction Program (3DSSPP), with a widely used computer-aided design software package, AutoCAD. The use of this "3DSSPP/AutoCAD interface" in the proactive analysis of an automotive assembly task is described and the results compared with an independent assessment using observations of workers performing the same task. Both studies yield similar conclusions, suggesting that proactive use of software such as the 3DSSPP/AutoCAD interface may be a valid tool in evaluating proposed workplace designs. In this context, issues in the analysis of workplace designs regarding the use of supporting ergonomic tools, assumptions, and posture selection are discussed.

Accidents, Occupational↗

PubMed2000

A three-dimensional dynamic posture prediction model for simulating in-vehicle seated reaching movements: development and validation.

A three-dimensional dynamic posture prediction model for simulating in-vehicle seated reaching movements is presented. The model employs a four-segment 7-degrees-of-freedom linkage structure to represent the torso, clavicle and right upper extremity. It relies on an optimization-based differential inverse kinematics approach to estimate a set of four weighting parameters that quantify a time-constant, inter-segment motion apportionment strategy. In the development phase, 100 seated reaching movements performed by 10 subjects towards five typical in-vehicle targets were modelled, resulting in 100 sets of weighting parameters. Statistical analysis was then conducted to relate these parameters to target and individual attributes. In the validation phase, the generalized model, with parameter values statistically synthesized, was applied to novel data sets containing 700 different reaching movements (towards different targets and/or by different subjects). The results demonstrated the model's ability to generate close representations in prediction: the overall mean time-averaged error in joint angle was 5.2 degrees, and the median was 4.7 degrees, excluding reaches towards two extreme targets (for which modelling errors were excessive). The model's general success in prediction and its unique characteristics led to implications with regard to the performance and underlying control strategies of human reaching movements.

Automobile Driving↗

PubMed1997

Perception and visualization of human posture information for computer-aided ergonomic analysis.

This article reports three experiments that examined the effects of photographic method, computerized visualization scheme, and posture complexity on posture perception and specification for computer-aided ergonomic analysis. The subjects were presented with photographs of working postures, and were required to manipulate human forms generated by an ergonomics software program to match the postures in the photographs. The first experiment showed a clear advantage of using a three-dimensional (3-D) human form graphic with two photographs when complex, asymmetric postures were analysed. However, the use of a 3-D human graphic display and two photographs jeopardized the subjects' posture specification performance when simple, symmetric postures were analysed. The results of the second and the third experiment demonstrated the importance of achieving congruency between photographic and computer display perspectives in improving posture specification performance. Implications for ergonomic job analysis and ergonomics software design are discussed.

Adult↗

PubMed1995

Fetal response to carbon dioxide pneumoperitoneum in the pregnant ewe.

OBJECTIVE: To determine the effects of maternal abdominal carbon dioxide (CO2) insufflation on placental blood flow and fetal blood gas measurements in the pregnant ewe. METHOD: Five time-bred ewes at 110 days' gestation were surgically prepared with maternal and fetal catheters placed for subsequent measurement of vascular pressures, blood gas tensions, and placental blood flows. On surgical recovery day 3, the ewe was anesthetized, placed on her right side, intubated, and manually ventilated to maintain a constant maternal carbon dioxide pressure (PCO2) range (37.1 +/- 3.3 mmHg) for the duration of the experiment. The maternal abdomen was inflated with CO2 to maintain an intraabdominal pressure of 20.7 +/- 0.6 mmHg. Maternal and fetal blood flows and blood gases were determined at 30 minutes of ventilation, 60 minutes of insufflation, and 40 minutes of desufflation. Simultaneous maternal and fetal organ blood flows were determined using the radioactive microsphere technique. RESULTS: Maternal perfusion pressure fell 22% (P = .01) in response to insufflation, whereas pressure in the inferior vena cava rose 53% (P = .003). Maternal placental blood flow fell to 61% (P = .002) of control. Seventy-seven percent of this blood-flow change was in response to the decreased perfusion pressure, with 23% resulting from an increased placental vascular resistance of 32% (P = .02). Maternal blood gas values did not change with insufflation or desufflation. Despite the marked decrease in maternal placental blood flow, the fetal placental perfusion pressure and blood flow, pH, and blood gas tensions were unaffected by insufflation or desufflation. CONCLUSION: The sheep fetus has sufficient placental flow reserves or compensatory responses to maintain adequate gas exchange during a 1-hour, 20 mmHg maternal pneumoperitoneum. Laparoscopic surgical procedures may prove to be a safe alternative to laparotomy during pregnancy.

Animals↗

PubMed1990

Pharmacokinetics of ticarcillin in patients with cystic fibrosis: a controlled prospective study.

We compared the pharmacokinetics of ticarcillin at a dose of 120 mg/kg in 11 patients with cystic fibrosis to 11 control subjects matched for age and sex. The mean elimination half-life of ticarcillin in serum was 70.8 minutes in the control subjects and 53.1 minutes in the patients with cystic fibrosis. The total body clearance of ticarcillin was significantly higher in cystic fibrosis patients (65.6 +/- 22.0 versus 46.2 +/- 10.9 ml/min/m2 in control subjects; p = 0.017). The nonrenal clearance of ticarcillin was also significantly higher in patients with cystic fibrosis (24.8 +/- 11.1 versus 13.3 +/- 6.0 ml/min/m2 for the control group; p = 0.006). There was no significant difference in volume of distribution between the two groups. We concluded that the shorter elimination half-life and the higher total body clearance of ticarcillin in patients with cystic fibrosis are a result of an increase in both renal and nonrenal elimination.

Adolescent↗

PubMed1989

Perinatal outcome in very preterm births with twin-twin transfusion syndrome.

We retrospectively studied 48 pairs of twin gestations delivered between 24 and 28 weeks' gestation from 1975 to 1986 at Vanderbilt University Medical Center. The incidence of fetofetal transfusion syndrome was 20%, more than double the incidence previously reported in large series of twin deliveries that encompassed a wider gestational age range. The overall mortality was 55%, and mortality for the fetofetal transfusion group was 70%, whereas a subset of the fetofetal transfusion group, those without weight discordancy, had a mortality rate of 75%. Our findings suggest that traditional reliance on ultrasonographic criteria for diagnosis of fetofetal transfusion will not detect 40% of such cases. The poor outcome data suggest a need for innovative approaches to diagnosis and treatment.

Birth Weight↗

PubMed1985

Quantitation of ciprofloxacin in body fluids by high-pressure liquid chromatography.

We describe a reverse-phase high-pressure liquid chromatography method for the quantitation of a new quinoline carboxylic acid antimicrobial agent, ciprofloxacin (Bay o 9867). This assay utilizes the intrinsic fluorescence of ciprofloxacin for primary detection but employs UV absorption as a secondary detection system. Mobile phases contained methanol and phosphate buffer and used a common C18 mu Bondapak column. A single precipitation step of a 50-microliter specimen was the only sample preparation necessary. The assay is linear from 2,000 to 10 ng/ml and sensitive to 5 ng/ml. The mean recovery of ciprofloxacin from serum was 105.7%. The coefficient of variation was less than or equal to 3.1% for same-day precision and less than or equal to 6.3% for assay-to-assay precision. Because the assay requires only small specimen volumes and minimal sample preparation and because of its defined characteristics, this assay would be ideal for clinical trials and pharmacokinetics studies of ciprofloxacin.

Anti-Infective Agents↗