PubMed Health⌕ Search

Biomedical subjects

D Hernando

Publications and source records attributed to D Hernando.

6 recordsLinked to original sources

Toxicity assays: a way for evaluating AOPs efficiency.

The technical feasibility and performance of photocatalytic degradation of aqueous methomyl (50 mg/L) have been studied at pilot scale in two well-defined systems of special interest because natural-solar UV light can be used: heterogeneous photocatalysis with titanium dioxide and homogeneous photocatalysis by photo-Fenton. The pilot plant is made up of compound parabolic collectors specially designed for solar photocatalytic applications. Experimental conditions allowed pesticide disappearance, degree of mineralisation and toxicity achieved in the two photocatalytic systems to be compared. Total disappearance of methomyl is attained by photo-Fenton in 60 min and by TiO2 in 100 min. Hundred percent of nitrogen and sulphur are recovered as ammonium and sulphate. By contrast, complete mineralisation of total organic carbon (TOC) is not achieved even after quite a long time (more than 300 min). Three different bioassays (Vibrio fischeri, Daphnia magna and a Microalga) have been used for testing the progress of toxicity during treatment. All remained toxic down to very low-pesticide concentrations and in some bioassays were still toxic after total disappearance of the pesticide. Only if treatment is maintained throughout enough mineralisation (i.e. TOC disappearance), the toxicity is reduced to below the threshold (EC50%).

Animals↗

Degradation of imidacloprid in water by photo-Fenton and TiO2 photocatalysis at a solar pilot plant: a comparative study.

The technical feasibility, mechanisms, and performance of degradation of aqueous imidacloprid have been studied at pilot scale in two well-defined photocatalytic systems of special interest because natural UV light can be used: heterogeneous photocatalysis with titanium dioxide and homogeneous photocatalysis by photo-Fenton. Equivalent pilot-scale and field conditions used for both allowed adequate comparison of the degree of mineralization and toxicity achieved as well as the transformation products generated in route to mineralization by both systems. Ninety-five percent of mineralization (<2.0 mg/L) was reached after 250 min of photocatalytic treatment with Fenton and 450 min with TiO2, meaning that TOC disappears 2.4 times faster with photo-Fenton photocatalytic treatment than with TiO2. The Daphnia Magna test for final residual TOC does not reveal anytoxic behavior. Transformation products evaluated by GC-MS/AED after two SPE procedures and LC-IC were the same in both cases. The main differences between the two processes are in the amount of transformation products (TPs) generated, not in the TPs detected which were always the same. At the end of both processes low concentration (<0.1 mg/L) of 2 pyrrolidinone (transformation product) remains in the dissolution and around 1 mg/L of formate in the case of photo-Fenton.

Ferric Compounds↗

Liquid chromatographic determination of aniline in table-top sweeteners based on pre-column derivatization with 1,2-naphthoquinone-4-sulfonate.

A liquid chromatographic method for the determination of aniline in cyclamate sweeteners based on a pre-column derivatization with 1,2-naphthoquinone-4-sulfonate (NQS) is proposed. Aniline traces were extracted from the cyclamate samples using dichloromethane. After solvent evaporation, the dry residue was derivatized with NQS at pH 9.5 and 85 degrees C for 1 min. The aniline derivative, which was extracted from the reacting mixture, was redissolved in the eluent solution and injected into the chromatographic system. The separation of aniline derivative from other amine impurities was carried out in a C18 column using a 2% acetic acid-methanol (40:60, v/v) mobile phase. Results from the analysis of aniline in the sweetener samples with the proposed method were compared with those from the standard method. A good concordance between the two methods was observed.

Aniline Compounds↗