PubMed Health⌕ Search

Biomedical subjects

D Kwak

Publications and source records attributed to D Kwak.

5 recordsLinked to original sources
PubMed2004

Enhancement of in situ hybridization to detect bovine herpesvirus 4 in paraffin sections.

In situ hybridization (ISH) protocols including different pre-treatment regimes were developed and compared for their effects on detecting bovine herpesvirus 4 (BoHV-4) in formalin fixed, paraffin embedded tissue. Results were compared for the hybridization and background signal intensities, and cellular morphology. We found that optimum results were obtained using enzyme treatment-thermal cycling as a pre-treatment of ISH. The results showed that the combination of protease and thermal cycling would be recommended as a means of supplementing in situ hybridization methods, especially when using long-term formalin fixed, paraffin-embedded tissue.

Animals↗
PubMed2003

The use of rice hulls for sustainable control of NOx emissions in deep space missions.

The use of the activated carbon produced from rice hulls to control NOx emissions for future deep space missions has been demonstrated. The optimal carbonization temperature range was found to be between 600 and 750 degrees C. A burnoff of 61.8% was found at 700 degrees C in pyrolysis and 750 degrees C in activation. The BET surface area of the activated carbon from rice hulls was determined to be 172 m2/g when prepared at 700 degrees C. The presence of oxygen in flue gas is essential for effective adsorption of NO by activated carbon. On the contrary, water vapor inhibits the adsorption efficiency of NO. Consequently, water vapor in flue gas should be removed by drying agents before adsorption to ensure high NO adsorption efficiency. All of the NO in the flue gas was removed for more than 1.5 h when 10% oxygen was present and the ratio of the carbon weight to the flue gas flow rate (W/F) was 15.4 g min/L. Reduction of the adsorbed NO to form N2 could be effectively accomplished under anaerobic conditions at 550 degrees C. The adsorption capacity of NO on the activated carbon was found to be 5.02 mg of NO/g of carbon. The loss of carbon mass was determined to be about 0.16% of the activated carbon per cycle of regeneration if the regeneration occurred when the NO in the flue gas after the carbon bed reached 4.8 ppm, the space maximum allowable concentration. The reduction of the adsorbed NO also regenerated the activated carbon, and the regenerated activated carbon exhibited an improved NO adsorption efficiency.

Adsorption↗
PubMed1999

Developmental arrest and pregnancy-induced transmammary transmission of Ancylostoma caninum larvae in the murine model.

Pregnancy is associated with reactivation of latent infections of many protozoal and helminthic parasites. To facilitate in vivo studies on the process of transmammary transmission of hookworm infection to nursing newborns, we established an experimental model of infection of BALB/c mice with infective larvae of the canine nematode Ancylostoma caninum. To establish latency with a significant reservoir of tissue larvae and achieve acceptable pregnancy success rates, mice were subcutaneously infected at day 5 postimpregnation; similar larval distribution profiles were observed at the end of the gestational period for bred compared to correspondingly infected unbred animals. No larvae were detected in fetuses or neonatal pups. Significant numbers of larvae were not detected in mammary tissue during the periparturient or postpartum lactational periods although about 8% of a dam's reservoir of tissue larvae was transferred to her nursing pups; this suggests that larvae reaching the mammary glands are rapidly transmitted through the milk sinuses, as was documented by histopathological analyses. Comparison of BALB/c with C57BL/6 mice that typically display divergent immune responses to infection showed no difference in tissue larval burden or in numbers transferred to pups. A hypothesis for the molecular mechanism of larval reactivation and transmission is discussed.

Ancylostoma↗
PubMed1997

Computational approach for probing the flow through artificial heart devices.

Computational fluid dynamics (CFD) has become an indispensable part of aerospace research and design. The solution procedure for incompressible Navier-Stokes equations can be used for biofluid mechanics research. The computational approach provides detailed knowledge of the flowfield complementary to that obtained by experimental measurements. This paper illustrates the extension of CFD techniques to artificial heart flow simulation. Unsteady incompressible Navier-Stokes equations written in three-dimensional generalized curvilinear coordinates are solved iteratively at each physical time step until the incompressibility condition is satisfied. The solution method is based on the pseudocompressibility approach. It uses an implicit upwind-differencing scheme together with the Gauss-Seidel line-relaxation method. The efficiency and robustness of the time-accurate formulation of the numerical algorithm are tested by computing the flow through model geometries. A channel flow with a moving indentation is computed and validated by experimental measurements and other numerical solutions. In order to handle the geometric complexity and the moving boundary problems, a zonal method and an overlapped grid embedding scheme are employed, respectively. Steady-state solutions for the flow through a tilting-disk heart valve are compared with experimental measurements. Good agreement is obtained. Aided by experimental data, the flow through an entire Penn State artificial heart model is computed.

Algorithms↗