PubMed Health⌕ Search

Biomedical subjects

D Vaknin

Publications and source records attributed to D Vaknin.

At least 19 recordsLinked to original sources

Charge inversion at minute electrolyte concentrations.

Anionic dimyristoylphosphatidic acid monolayers spread on LaCl3 solutions reveal strong cation adsorption and a sharp transition to surface overcharging at unexpectedly low bulk salt concentrations. We determine the surface accumulation of La3+ with anomalous x-ray reflectivity and find that La3+ compensates the lipid surface charge by forming a Stern layer with approximately 1 La3+ ion per 3 lipids below a critical bulk concentration, ct approximately 500 nM. Above ct, the surface concentration of La3+ increases to a saturation level with approximately 1 La3+ per lipid, thus implying that the total electric charge of the La3+ exceeds the surface charge. This overcharge is observed at approximately 4 orders of magnitude lower concentration than predicted in ion-ion correlation theories. We suggest that transverse electrostatic correlations between mobile ions and surface charges (interfacial Bjerrum pairing) may contribute to the charge inversion.

Journal Article↗

Induced crystallization of polyelectrolyte-surfactant complexes at the gas-water interface.

Synchrotron x-ray and surface-tension studies of a strong polyelectrolyte (PE) in the semidilute regime (approximately 0.1 M monomer charges) with varying surfactant concentrations show that minute surfactant concentrations induce the formation of a PE-surfactant complex at the gas-solution interface. X-ray reflectivity and grazing angle x-ray diffraction show the complex PE-surfactant resides at the interface and the alkyl chains of the surfactant form a two-dimensional liquidlike monolayer. With the addition of salt (NaCl), columnar crystals with distorted-hexagonal symmetry are formed.

Crystallization↗

Commensurate-incommensurate magnetic phase transition in magnetoelectric single crystal LiNiPO(4).

Neutron scattering studies of single crystal LiNiPO4 reveal a spontaneous first-order commensurate-incommensurate magnetic phase transition. Short- and long-range incommensurate phases are intermediate between the high temperature paramagnetic and the low temperature antiferromagnetic phases. The modulated structure has a predominant antiferromagnetic component, giving rise to satellite peaks in the vicinity of the fundamental antiferromagnetic Bragg reflection, and a ferromagnetic component, giving rise to peaks at small momentum transfers around the origin at (0,+/-Q,0). The wavelength of the modulated magnetic structure varies continuously with temperature. It is argued that the incommensurate short- and long-range phases are due to spin-dimensionality crossover from a continuous to the discrete Ising state.

Journal Article↗

The structure of D-erythro-C18 ceramide at the air-water interface.

X-ray reflectivity (XR) and diffraction at grazing angles of incidence (GID) were conducted to determine the structure of synthetic D-erythro C18-ceramide films at the air-water interface at various surface pressures (pi). Analysis of the GID reveals that the monomolecular film, at the crystalline phase (pi > 0 mN/m), is predominantly hexagonal. In this crystalline phase, the analysis of the reflectivity yields an electron density profile that consists of three distinct homogeneous slabs, one associated with the headgroup region and the other two with the hydrocarbon chains. At large molecular areas (pi approximately 0), isolated crystalline domains coexist with two-dimensional gas phase. Within the crystalline domains, we find an orthorhombic arrangement of the chains that coexists with the hexagonal symmetry. It is argued that the two-dimensional orthorhombic crystals are induced by hydrogen bonding between headgroups even at very low surface pressures. Although their structure is incommensurate with the simple hexagonal arrangement, they act as nucleation centers for the conventional hexagonal phase which dominates at high pi.

Air↗

Polarization-modulated infrared spectroscopy and x-ray reflectivity of photosystem II core complex at the gas-water interface.

The state of photosystem II core complex (PS II CC) in monolayer at the gas-water interface was investigated using in situ polarization-modulated infrared reflection absorption spectroscopy and x-ray reflectivity techniques. Two approaches for preparing and manipulating the monolayers were examined and compared. In the first, PS II CC was compressed immediately after spreading at an initial surface pressure of 5.7 mN/m, whereas in the second, the monolayer was incubated for 30 min at an initial surface pressure of 0.6 mN/m before compression. In the first approach, the protein complex maintained its native alpha-helical conformation upon compression, and the secondary structure of PS II CC was found to be stable for 2 h. The second approach resulted in films showing stable surface pressure below 30 mN/m and the presence of large amounts of beta-sheets, which indicated denaturation of PS II CC. Above 30 mN/m, those films suffered surface pressure instability, which had to be compensated by continuous compression. This instability was correlated with the formation of new alpha-helices in the film. Measurements at 4 degreesC strongly reduced denaturation of PS II CC. The x-ray reflectivity studies indicated that the spread film consists of a single protein layer at the gas-water interface. Altogether, this study provides direct structural and molecular information on membrane proteins when spread in monolayers at the gas-water interface.

Biophysical Phenomena↗

Influence of surface chemistry on the structural organization of monomolecular protein layers adsorbed to functionalized aqueous interfaces.

The molecular organization of streptavidin (SA) bound to aqueous surface monolayers of biotin-functionalized lipids and binary lipid mixtures has been investigated with neutron reflectivity and electron and fluorescence microscopy. The substitution of deuterons (2H) for protons (1H), both in subphase water molecules and in the alkyl chains of the lipid surface monolayer, was utilized to determine the interface structure on the molecular length scale. In all cases studied, the protein forms monomolecular layers underneath the interface with thickness values of approximately 40 A. A systematic dependence of the structural properties of such self-assembled SA monolayers on the surface chemistry was observed: the lateral protein density depends on the length of the spacer connecting the biotin moiety and its hydrophobic anchor. The hydration of the lipid head groups in the protein-bound state depends on the dipole moment density at the interface.

Adsorption↗

Recognition processes at a functionalized lipid surface observed with molecular resolution.

The specific binding of proteins to functionalized lipid monolayers on aqueous subphases was characterized by neutron reflectivity and fluorescence microscopy measurements. Due to the high affinity and high specificity of their noncovalent interaction, streptavidin (SA) and biotin (vitamin H) were chosen as a model system to investigate the structural characteristics of a recognition process on a molecular length scale. Changes in the neutron reflection from the surfaces of NaCl aqueous (H2O or D2O) protein solutions (10(-8) M SA) were used to monitor the interaction of the protein with a monolayer of a biotinylated lipid in situ. Refinement of the reflectivity data and independent fluorescence microscopic observation of the interface using FITC-labeled SA showed that the protein forms macroscopically homogeneous (and presumably crystalline) domains covering a large portion of the surface. Moreover, the neutron reflection experiments clearly showed the formation of a monomolecular protein layer with an effective thickness, dp = 43.7 +/- 2 A. The area per protein molecule occupied in the film was A0 = 2860 +/- 200 A2 and nw = 260 +/- 100 water molecules were associated with each protein molecule. Quantitative binding was found to occur at biotin surface concentrations as low as 1 molecule/1,250 A2 (compared with approximately 1 molecule/40 A2 for dense packing). This study demonstrates the application of a promising new tool for the systematic investigation of molecular recognition processes in protein/lipid model systems.

Bacterial Proteins↗