Biomedical subjects

Daniel Guyomar

Publications and source records attributed to Daniel Guyomar.

5 recordsLinked to original sources

PubMed2006

Nonlinear processing of the output voltage of a piezoelectric transformer.

Reducing the size of power supplies raises the problem of new components that could be better candidates for integration. In this field, electromagnetic transformers may be replaced with significant benefit by piezoelectric transformers (PT). In a PT, the input electrical energy is transferred to the output by an acoustical means, using the direct and converse effects of piezoelectric materials. Its main advantages over an electromagnetic transformer are no magnetic noise generation, small size, high power density, and high efficiency. This paper deals with an innovative technique that produces a significant improvement of the power capability of piezoelectric transformers. This technique is based on a particular output voltage processing of the PT. Its effect is a vibration level reduction of the PT structure while keeping the output power practically constant. Vibration level is a critical parameter that determines the maximum power capability of a given PT. Thus, the new processing reduces significantly the losses of the PT. Both theoretical predictions and experimental results show that the increase of the power capability may reach 200%.

Journal Article↗

PubMed2006

Single crystals and nonlinear process for outstanding vibration-powered electrical generators.

This paper compares the performances of vibration-powered electrical generators using a piezoelectric ceramic and a piezoelectric single crystal associated to several power conditioning circuits. A new approach of the piezoelectric power conversion based on a nonlinear voltage processing is presented, leading to three novel high performance power conditioning interfaces. Theoretical predictions and experimental results show that the nonlinear processing technique may increase the power harvested by a factor of 8 compared to standard techniques. Moreover, it is shown that, for a given energy harvesting technique, generators using single crystals deliver 20 times more power than generators using piezoelectric ceramics.

Journal Article↗

PubMed2005

Toward energy harvesting using active materials and conversion improvement by nonlinear processing.

This paper presents a new technique of electrical energy generation using mechanically excited piezoelectric materials and a nonlinear process. This technique, called synchronized switch harvesting (SSH), is derived from the synchronized switch damping (SSD), which is a nonlinear technique previously developed to address the problem of vibration damping on mechanical structures. This technique results in a significant increase of the electromechanical conversion capability of piezoelectric materials. Comparatively with standard technique, the electrical harvested power may be increased above 900%. The performance of the nonlinear processing is demonstrated on structures excited at their resonance frequency as well as out of resonance.

Journal Article↗

PubMed2005

Modeling of elastic nonlinearities in ferroelectric materials including nonlinear losses: application to nonlinear resonance mode of relaxors single crystals.

(1-x)Pb(Mg1/3Nb2/3)O3-xPbTiO3 (PMN-PT) and (1-x)Pb(Zn1/3Nb2/3)O3-xPbTiO3 (PZN-PT) single crystals are considered to behave like soft Pb(Zr,Ti)O3 (PZT) ceramics because of their small mechanical quality factor Qm and poor stability under external disturbances (Qm > 500-1000 for hard PZT ceramic, and Qm < 100 for soft PZT and PMN-PT and PZN-PT single crystals). At weak signal excitation of the first resonance mode, the displacement at the end of a lateral bar is proportional to the Q31d31 figure of merit that is very close to that found for hard PZT. Indeed the very large piezoelectric coefficient compensates the low Qm. But increasing alternating current (AC) field results in the appearance of strong non-linearities through a shift of the resonance frequency and jumps phenomenon observed on increasing and decreasing frequency sweep. It is shown in this paper that these nonlinearities are due to the nonlinear elastic compliance that can be modeled by a third order development of the constitutive piezoelectric equations. Experiments on PMN-PT and PZN-PT single crystals are used for comparison with the model to show the viability of the approach. Both the frequency shift and jumps phenomenon are simulated with a very good agreement with experimental results. The importance is also shown of losses associated with the third order term responsible for the large decrease of the mechanical quality factor for high strain levels. Thus, the nonlinear losses are related to the hysteresis of domain wall motion when subjected to large displacements.

Journal Article↗

PubMed2004

Stability of morphotropic (110) oriented 0.65PMN-0.35PT single crystals.

Electromechanical properties of (1-x)Pb (Mg1/3Nb2/3)O3-xPbTiO3 (PMN-PT) single crystals with x = 0.35 were investigated as a function of different external disturbances. The polarization dependence on the electromechanical properties was first studied in order to determine the best polarization path. The correlation with X-ray measured phase ratio is presented and shows that the maximum of electromechanical properties may be correlated with a minimum rhombohedral/tetragonal phase ratio. Temperature, stress, electric field, and time (aging) stability was studied in order to determine performance-limiting factors of these materials. The rhombohedral/tetragonal phase transition is observed on temperature (80 degrees C), inducing a decrease of the electromechanical coupling factor (from 85% to 50%); but the whole properties are recovered while returning to room temperature. Stress measurement shows a large depoling of sample for stresses above 30 MPa. The PMN-PT single crystals were found to be surprisingly stable during aging, except for mechanical and dielectric losses. The same tendency was found on alternating current (AC) electric field dependence.

Journal Article↗