Biomedical subjects
Publications and source records attributed to Daniel L Feldheim.
Under appropriate electronic modulation, simple diazofluorene analogs recapitulate the DNA cleavage activity of kinamycin D under thiol-based reducing conditions. Achieving DNA cleavage under these reducing conditions is key to anticancer activity, as the most active compound, 1-methoxydiazofluorene, inhibits the proliferation of HeLa cells.
RNA catalysts for the shape-controlled synthesis of Pd particles from the precursor complex trisdibenzylideneacetone dipalladium ([Pd2(DBA)3] were recently discovered in our laboratory (J. Am. Chem. Soc. 2005, 127, 17814-17818). In the work described here, RNA codes for hexagonal Pd platelets and Pd cubes were covalently immobilized on gold surfaces and evaluated for their activity toward particle synthesis. When coupled to gold via oligoethylene glycol linkers, both RNA sequences were able to catalyze the formation of Pd particles with the same shape control previously observed in solution. For low surface coverages, the average distance between RNA molecules on the surface was estimated at ca. 300 nm, yet large (e.g., dimensions of hundreds of nanometers) Pd hexagons and cubes still formed. This surprising result suggests that a single RNA molecule may be sufficient for nucleating and controlling the shapes of these particles. Finally, the use of surface-bound RNA as a tool for directing the orthogonal synthesis of materials on surfaces was demonstrated. Patterning the RNA code for Pd hexagons next to the code for Pd cubes, followed by incubation in a solution containing [Pd2(DBA)3], resulted in the spontaneous formation of spatially distinct spots of hexagonal and cubic particles.
The infrared emissivity of Au and silica-coated Au nanoparticles (Au NPs) deposited on indium tin oxide substrates was investigated. NPs were irradiated with laser light at a frequency close to the Au plasmon resonance band, and the blackbody radiation emitted as a result was monitored with an IR camera equipped with an InAs array detector. The differences in temperature before and after laser irradiation were recorded (T-jumps) and were found to be directly proportional to the number of particles present on the slide and to the laser power used in the experiment. Coating Au NPs with silica increased the measured T-jumps 2-5 times, depending on the thickness of the silica shell. This was in agreement with the observation that silica has a much higher IR emissivity than Au. Both Au and silica-coated Au NPs were then tested as labels for thermographic DNA detection. Target DNA concentrations as low as 100 pM were recorded when Au NPs were used as labels and as low as 10 pM when silica-coated Au NPs were used.
RNA sequences previously isolated by in vitro selection were further characterized for their ability to control palladium particle growth. Five pyridyl-modified RNA sequences (Pdases) representing each of the different evolved families were found to form hexagonal plates with a high degree of shape specificity. However, a sixth nonrelated pyridyl-modified RNA sequence was found to form exclusively cubic particles under identical conditions. Replacing pyridyl-modified RNA with native RNA resulted in a complete loss of RNA function. Removing the 3'-fixed sequence region from the Pdase had little effect on particle growth; however, further truncations into the variable region resulted in a significant loss of activity and particle shape control. These Pdases were selected using the organometallic precursor complex tris(dibenzylideneacetone) dipalladium(0) ([Pd2(DBA)3]). Changing the metal center and ligand of the group VIII organometallic precursor complex revealed a strong dependence of particle growth and shape on the DBA ligands. Changing the metal center from Pd to Pt while retaining the DBA ligands gave predominantly hexagonal Pt, but with a decrease in shape control. Taken together, the results of this study suggest that the full-length Pdases contain active sites capable of highly specific molecular recognition of organometallic complexes as particle formation reagents.
This communication describes the preparation and characterization of a valence tautomer complex covalently attached to gold nanoparticles. Variable-temperature IR spectroscopy is used to determine the equilibrium thermodynamic parameters for the valence tautomerization. These results are compared with a nonsurface combined valence tautomer complex. The results show that surface confinement attenuates both DeltaH degrees and DeltaS degrees . We attribute these changes to a reduced accessible molecular surface area.
In this chapter, we outline protocols for assembling and characterizing peptide-gold nanoparticle conjugates. We describe two strategies for attaching peptides to gold nanoparticles. One involves the covalent coupling of cysteine-terminated peptides directly to a particle surface via a sulfur-gold bond. Alternatively, peptides are coupled to bovine serum albumin (BSA) via a bifunctional molecular crosslinker. We also describe a number of characterization methods for determining the number of crosslinkers per BSA, peptides per BSA, and peptides adsorbed per particle. Finally, we show that the enormous visible light extinction properties of gold nano particles make them excellent imaging agents for tracking the trajectories of peptides inside living cells.
Single- and double-stranded deoxy ribonucleic acid (DNA) molecules attached to self-assembled monolayers (SAMs) on gold surfaces were characterized by a number of optical and electronic spectroscopic techniques. The DNA-modified gold surfaces were prepared through the self-assembly of 6-mercapto-1-hexanol and 5'-C(6)H(12)SH -modified single-stranded DNA (ssDNA). Upon hybridization of the surface-bound probe ssDNA with its complimentary target, formation of double-stranded DNA (dsDNA) on the gold surface is observed and in a competing process, probe ssDNA is desorbed from the gold surface. The competition between hybridization of ssDNA with its complimentary target and ssDNA probe desorption from the gold surface has been investigated in this paper using X-ray photoelectron spectroscopy, chronocoulometry, fluorescence, and polarization modulation-infrared reflection absorption spectroscopy (PM-IRRAS). The formation of dsDNA on the surface was identified by PM-IRRAS by a dsDNA IR signature at approximately 1678 cm(-)(1) that was confirmed by density functional theory calculations of the nucleotides and the nucleotides' base pairs. The presence of dsDNA through the specific DNA hybridization was additionally confirmed by atomic force microscopy through colloidal gold nanoparticle labeling of the target ssDNA. Using these methods, strand loss was observed even for DNA hybridization performed at 25 degrees C for the DNA monolayers studied here consisting of attachment to the gold surfaces by single Au-S bonds. This finding has significant consequence for the application of SAM technology in the detection of oligonucleotide hybridization on gold surfaces.
This paper describes a simple method for the preparation and characterization of protein density gradients on solid supports. The method employs colloidal metal nanoparticles as protein carriers and optical tags and is capable of forming linear, exponential, 1D, 2D, and multiprotein gradients of varying slope without expensive or sophisticated surface patterning techniques. Surfaces patterned with proteins using the procedures described within are shown to support cell growth and are thus suitable for studies of protein-cell interactions.
RNA sequences have been discovered that mediate the growth of hexagonal palladium nanoparticles. In vitro selection techniques were used to evolve an initial library of approximately 10(14) unique RNA sequences through eight cycles of selection to yield several active sequence families. Of the five families, all representative members could form crystalline hexagonal palladium platelets. The palladium particle growth occurred in aqueous solution at ambient temperature, without any endogenous reducing agent, and at low concentrations of metal precursor (100 micromolar). Relative to metal precursor, the RNA concentration was significantly lower (1 micromolar), yet micrometer-size crystalline hexagonal palladium particles were formed rapidly (7.5 to 1 minutes).
The negative differential resistance (NDR) peak current observed in redox active self-assembled monolayer-based molecular junctions has been attenuated by controlling the composition of the molecular junction. Two approaches studied here include capping the electroactive ferrocenyl groups with beta-cyclodextrin and functionalizing the scanning tunneling microscope tip used to probe the self-assembled monolayer (SAM) with n-alkanethiols of different lengths. These are the first examples of systematic modification of the magnitude of the NDR response in a molecule-based system.
Laser-induced temperature jumps (LITJs) at gold nanoparticle-coated indium tin oxide (ITO) electrodes in contact with electrolyte solutions have been measured using temperature-sensitive redox probes and an infrared charge-coupled device. Upon irradiation with 532 nm light, interfacial temperature changes of ca. 20 degrees C were recorded for particle coverages of ca. 1 x 1010 cm-2. In the presence of a redox molecule, LITJ yields open-circuit photovoltages and photocurrents that are proportional to the number of particles on the surface. When ssDNA was used to chemisorb nanoparticles to the ITO surface, solution concentrations as low as 100 fM of target ssDNA-modified nanoparticles could be detected at the electrode surface.
Protocols for modifying gold nanoparticles with peptide-bovine serum albumin (BSA) conjugates are described within. The resulting constructs were characterized using a number of techniques including static fluorescence spectroscopy and time-correlated single photon counting spectroscopy (TCSPC) in order to quantify peptide-BSA binding isotherms, exchange rates, critical flocculation concentrations, and the composition of mixed peptide-BSA monolayers on gold nanoparticles. TCSPC has proven to be a powerful technique for observing the microenvironment of protein-gold nanoparticle conjugates because it can distinguish between surface-bound and solution-phase species without the need for separation steps. Full characterization of the composition and stability of peptide-modified metal nanoparticles is an important step in their use as intracellular delivery vectors and imaging agents.
The ability of peptide-modified gold nanoparticles to target the nucleus of HepG2 cells was explored. Five peptide/nanoparticle complexes were investigated, particles modified with (1) the nuclear localization signal (NLS) from the SV 40 virus; (2) the adenovirus NLS; (3) the adenovirus receptor-mediated endocytosis (RME) peptide; (4) one long peptide containing the adenovirus RME and NLS; and (5) the adenovirus RME and NLS peptides attached to the nanoparticle as separate pieces. Gold nanoparticles were used because they are easy to identify using video-enhanced color differential interference contrast microscopy, and they are excellent scaffolds from which to build multifunctional nuclear targeting vectors. For example, particles modified solely with NLS peptides were not able to target the nucleus of HepG2 cells from outside the plasma membrane, because they either could not enter the cell or were trapped in endosomes. The combination of NLS/RME particles (4) and (5) did reach the nucleus; however, nuclear targeting was more efficient when the two signals were attached to nanoparticles as separate short pieces versus one long peptide. These studies highlight the challenges associated with nuclear targeting and the potential advantages of designing multifunctional nanostructured materials as tools for intracellular diagnostics and therapeutic delivery.
Molecules capable of complementary hydrogen bonding were used to control the noncovalent self-assembly and electronic properties of a chemically well-defined surface mesostructure. In this work, we patterned a footprint region for molecular assembly on a surface and used moieties featuring complementary recognition to tune the current-voltage properties of the patterned region. With the appropriate functionalities on the complementary moieties, we were able to increase and decrease the observed conductance in surface-bound mesoscale structures imaged by scanning tunneling microscopy (STM).
Gold nanoparticles modified with nuclear localization peptides were synthesized and evaluated for their subcellular distribution in HeLa human cervical epithelium cells, 3T3/NIH murine fibroblastoma cells, and HepG2 human hepatocarcinoma cells. Video-enhanced color differential interference contrast microscopy and transmission electron microscopy indicated that transport of nanoparticles into the cytoplasm and nucleus depends on peptide sequence and cell line. Recently, the ability of certain peptides, called protein transduction domains (PTDs), to transclocate cell and nuclear membranes in a receptor- and temperature-independent manner has been questioned (see for example, Lundberg, M.; Wikstrom, S.; Johansson, M. (2003) Mol. Ther. 8, 143-150). We have evaluated the cellular trajectory of gold nanoparticles carrying the PTD from HIV Tat protein. Our observations were that (1) the conjugates did not enter the nucleus of 3T3/NIH or HepG2 cells, and (2) cellular uptake of Tat PTD peptide-gold nanoparticle conjugates was temperature dependent, suggesting an endosomal pathway of uptake. Gold nanoparticles modified with the adenovirus nuclear localization signal and the integrin binding domain also entered cells via an energy-dependent mechanism, but in contrast to the Tat PTD, these signals triggered nuclear uptake of nanoparticles in HeLa and HepG2 cell lines.