PubMed Health⌕ Search

Biomedical subjects

Demetri Psaltis

Publications and source records attributed to Demetri Psaltis.

At least 19 recordsLinked to original sources

Reflectionless evanescent-wave amplification by two dielectric planar waveguides: erratum.

In a previous Letter [Tsang and Psaltis, Opt. Lett.31, 2741 (2006)], we assert that the total reflection coefficient of two dielectric slabs goes to zero in the limit of single-waveguide resonance. A more careful derivation shows that this is not the case. The correct condition in which reflectionless evanescent-wave amplification can be achieved by two dielectric planar waveguides is derived in this Erratum.

Journal Article↗

Slanted hole array beam profiler (SHArP)-a high-resolution portable beam profiler based on a linear aperture array.

We demonstrate a novel high-resolution portable beam profiler based on a slanted linear array of small apertures, termed a slanted hole array beam profiler (SHArP). The apertures are directly fabricated on a metal-coated CMOS imaging sensor. With a single linear scan, the aperture array can establish a virtual grid of sampling points for beam profiling. With our prototype, we demonstrate beam profiling of Gaussian beams over an area of 66.5 microm x 66.5 microm with a resolution of 0.8 microm (compare with the CMOS pixel size of 10 microm). The resolution can be improved into the range of submicrometers by fabricating smaller apertures. The good correspondence between the measured and calculated beam profiles proves the fidelity of our new beam profiling scheme.

Journal Article↗

Reflectionless evanescent-wave amplification by two dielectric planar waveguides.

Utilizing the underlying physics of evanescent-wave amplification by a negative-refractive-index slab, it is shown that evanescent waves with specific spatial frequencies can also be amplified without any reflection simply by two dielectric planar waveguides. The simple configuration allows one to take advantage of the high resolution limit of a high-refractive-index material without contact with the object.

Journal Article↗

Developing optofluidic technology through the fusion of microfluidics and optics.

We describe devices in which optics and fluidics are used synergistically to synthesize novel functionalities. Fluidic replacement or modification leads to reconfigurable optical systems, whereas the implementation of optics through the microfluidic toolkit gives highly compact and integrated devices. We categorize optofluidics according to three broad categories of interactions: fluid-solid interfaces, purely fluidic interfaces and colloidal suspensions. We describe examples of optofluidic devices in each category.

Animals↗

Nonlinearity management in optics: experiment, theory, and simulation.

We conduct an experimental investigation of nonlinearity management in optics using femtosecond pulses and layered Kerr media consisting of glass and air. By examining the propagation properties over several diffraction lengths, we show that wave collapse can be prevented. We corroborate these experimental results with numerical simulations of the (2+1)-dimensional focusing cubic nonlinear Schrödinger equation with piecewise constant coefficients and a theoretical analysis of this setting using a moment method.

Journal Article↗

Beam-width-dependent filtering properties of strong volume holographic gratings.

The finite dimension of the incident beam used to read out volume holographic gratings has interesting effects on their filtering properties. As the readout beam gets narrower, there is more deviation from the ideal response predicted for monochromatic plane waves. In this paper we experimentally explore beam-width-dependent phenomena such as wavelength selectivities, angular selectivities, and diffracted beam profiles. Volume gratings in both reflection and transmission geometries are investigated near 1550 nm. Numerical simulations utilizing the technique of Fourier decomposition provide a satisfactory explanation and confirm that the spread of spatial harmonics is the main contributing factor.

Journal Article↗

Holographic grating formation in a colloidal suspension of silver nanoparticles.

Holographic gratings are recorded in colloidal suspensions of silver nanoparticles by utilizing interfering nanosecond pulses. The diffraction efficiency is measured with continuous-wave light. An instantaneous response together with a transient grating are observed: the nanoparticles absorb the pump light and heat up. Heat is transferred to the solvent, and a delayed thermal grating appears. The final decay time constant of this grating depends quadratically on the period length and has a typical value of 1 micros for grating spacings of several micrometers.

Journal Article↗

Nanofluidic tuning of photonic crystal circuits.

By integrating soft-lithography-based nanofluidics with silicon nanophotonics, we demonstrate dynamic, liquid-based addressing and high deltan/n (approximately 0.1) refractive index modulation of individual features within photonic structures at subwavelength length scales. We show ultracompact tunable spectral filtering through nanofluidic targeting of a single row of holes within a planar photonic crystal. We accomplished this with an optofluidic integration architecture comprising a nanophotonic layer, a nanofluidic delivery structure, and a microfluidic control engine. Variants of this technique could enable dynamic reconfiguration of photonic circuits, selective introduction of optical nonlinearities, or delivery of single molecules into resonant cavities for biodetection.

Journal Article↗

Femtosecond holography in lithium niobate crystals.

Spatial gratings are recorded holographically by two femtosecond pump pulses at 388 nm in lithium niobate (LiNbO3) crystals and read out by a Bragg-matched, temporally delayed probe pulse at 776 nm. We claim, to our knowledge, the first holographic pump-probe experiments with subpicosecond temporal resolution for LiNbO3. An instantaneous grating that is due mostly to the Kerr effect as well as a long-lasting grating that results mainly from the absorption caused by photoexcited carriers was observed. The Kerr coefficient of LiNbO3 for our experimental conditions, i.e., pumped and probed at different wavelengths, was approximately 1.0 x 10(-5) cm2/GW.

Journal Article↗

Holography in commercially available photoetchable glasses.

Volume holographic gratings are recorded and retrieved in two commercially available glasses: Schott Foturan and Hoya PEG3. These materials are photoetchable, which describes their major application, but they also allow storage of volume holograms without any chemical etching. The samples are illuminated with ultraviolet light at a wavelength of 325 nm and thermally processed to achieve a maximum diffraction efficiency of approximately 9% for a 1-mm-thick sample. The two glasses show similar behavior; the diffraction efficiencies in Foturan tend to be slightly larger, whereas PEG3 tends to have weaker light scattering.

Journal Article↗

Diffraction from deformed volume holograms: perturbation theory approach.

We derive the response of a volume grating to arbitrary small deformations, using a perturbative approach. This result is of interest for two applications: (a) when a deformation is undesirable and one seeks to minimize the diffracted field's sensitivity to it and (b) when the deformation itself is the quantity of interest and the diffracted field is used as a probe into the deformed volume where the hologram was originally recorded. We show that our result is consistent with previous derivations motivated by the phenomenon of shrinkage in photopolymer holographic materials. We also present the analysis of the grating's response to deformation due to a point indenter and present experimental results consistent with theory.

Journal Article↗

Volume holographic hyperspectral imaging.

A volume hologram has two degenerate Bragg-phase-matching dimensions and provides the capability of volume holographic imaging. We demonstrate two volume holographic imaging architectures and investigate their imaging resolution, aberration, and sensitivity. The first architecture uses the hologram directly as an objective imaging element where strong aberration is observed and confirmed by simulation. The second architecture uses an imaging lens and a transmission geometry hologram to achieve linear two-dimensional optical sectioning and imaging of a four-dimensional (spatial plus spectral dimensions) object hyperspace. Multiplexed holograms can achieve simultaneously three-dimensional imaging of an object without a scanning mechanism.

Journal Article↗

Holographic recording of laser-induced plasma.

We report on a holographic probing technique that allows for measurement of free-electron distribution with fine spatial detail. Plasma is generated by focusing a femtosecond pulse in air. We also demonstrate the capability of the holographic technique of capturing the time evolution of the plasma-generation process.

Journal Article↗

Reverse propagation of femtosecond pulses in optical fibers.

We present a numerical technique for reversing femtosecond pulse propagation in an optical fiber, such that given any output pulse it is possible to obtain the input pulse shape by numerically undoing all dispersion and nonlinear effects. The technique is tested against experimental results, and it is shown that it can be used for fiber output pulse optimization in both the anomalous and normal dispersion regimes.

Journal Article↗

Dispersion and nonlinearity compensation by spectral phase conjugation.

We propose the use of spectral phase conjugation to compensate for dispersion of all orders, self-phase modulation, and self-steepening of an optical pulse in a fiber. Although this method cannot compensate for loss and intrapulse Raman scattering, it is superior to the previously suggested midway temporal phase conjugation method if high-order dispersion is a main source of distortion. The reshaping performance of our proposed scheme and a combined temporal and spectral phase conjugation scheme in the presence of uncompensated effects is studied numerically.

Journal Article↗

Comparison of transmission and the 90-degree holographic recording geometry.

We compare the system performances of two holographic recording geometries using iron-doped lithium niobate: the 90-degree and transmission geometry. We find that transmission geometry is better because the attainable dynamic range (M/#) is much higher. The only drawback of transmission geometry is the buildup of fanning, particularly during readout. Material solutions that reduce fanning such as doubly-doped photerefractive crystals make transmission geometry the clear winner.

Journal Article↗

Folded shift multiplexing.

Shift multiplexing is a holographic recording method that uses a spherical reference wave. We extend the principle to a thin slab of holographic material that acts as a waveguide. Total internal reflection folds the reference spherical beam in one dimension. We demonstrate that the shift selectivity with the folded spherical beam is independent of the slab thickness but depends instead on the numerical aperture of the coupled spherical wave. A shift selectivity of 0.5 microm has been achieved with a 1-mm-thick LiNbO3 crystal and 50 high-definition data pages are recorded with this method.

Journal Article↗