PubMed Health⌕ Search

Biomedical subjects

Dominique Vautier

Publications and source records attributed to Dominique Vautier.

12 recordsLinked to original sources

Immunogold detection of types I and II chondrocyte collagen fibrils: an in situ atomic force microscopic investigation.

Chondrocyte tissue engineering is a major challenge in the field of cartilage repair. The phenotype of chondrocytes consists of cartilage specific proteoglycan and type II collagen. During serial passages, chondrocytes dedifferentiate into cells, presenting a fibroblast-like phenotype consisting predominately of type I collagen synthesis. Observation of native collagen fibers could be visualized by atomic force microscope. Here, we developed an original and useful atomic force microscopy-based immunogold technique allowing biochemical distinction between types I and II collagen fibers. Imaging of 40-nm gold particles staining collagen fibers was performed in tapping mode. Rat 1 fibroblasts and human chondrosarcoma cells were used as positive models for types I and II collagen, respectively. As demonstrated by our data, primary rat chondrocytes adhering for 48 h on a glass substrate synthesize type II collagen native fibers. This technique allows analyses of local areas of the extracellular matrix of fixed cells, providing complementary data about cartilage phenotype. This simple approach could be of major interest for the biologist community in routine laboratory investigations, to localize in situ, macromolecules of the extracellular matrix.

Animals↗

Imaging cell interactions with native and crosslinked polyelectrolyte multilayers.

The adhesion of primary chondrocytes to polyelectrolyte multilayer films, made of poly(l-lysine) (PLL) and hyaluronan (HA), was investigated for native and crosslinked films, either ending by PLL or HA. Crosslinking the film was achieved by means of a water-soluble carbodiimide in combination with N-hydroxysulfosuccinimide. The adhesion of macrophages and primary chondrocytes was investigated by microscopical techniques (optical, confocal, and atomic), providing useful information on the cell/film interface. Native films were found to be nonadhesive for the primary chondrocytes, but could be degraded by macrophages, as could be visualized by confocal laser scanning microscopy after film labeling. Confocal microscopy images show that these films can be deformed by the chondrocytes and that PLL diffuses at the chondrocyte membrane. In contrast, the cells adhered and proliferated well on the crosslinked films, which were not degraded by the macrophages. These results were confirmed by a MTT test over a 6-d period and by atomic force microscopy observations. We thus prove that chemical crosslinking can dramatically change cell adhesion properties, the cells being more stably anchored on the crosslinked films.

Animals↗

Endothelial cell--interactions with polyelectrolyte multilayer films.

The seeding of endothelial cells (ECs) on biomaterial surfaces became a major challenge, allowing to improve the non-thrombogenic properties of these surfaces. Recently, the use of polyelectrolyte films has been suggested as a new versatile technique of surface modification aimed at tissue engineering. In this study, we evaluate the adhesion properties of ECs on two types of polyelectrolyte films ending either by poly(D-lysine) (PDL), or poly(allylamine hydrochloride) (PAH), and compared them to data obtained on PDL or PAH monolayers, glass and fibronectin (Fn)-coated glass. ECs seeded on polyelectrolyte films showed a good morphology, allowing ECs to resist physiological shear stress better compared to ECs seeded on glass or Fn. The expression of beta1 integrins was slightly lower on polyelectrolyte films than on control surfaces. However, the phosphorylation of focal adhesion kinase, involved in the transduction of adhesion signal, was not modified on PAH ending films compared to control surfaces; whereas it became lower on PDL ending films. Finally, PAH ending films improve strongly ECs adhesion without disturbing the adhesion mechanism, necessary for the development of a new endothelium. These types of films or similar build-ups could thus be used in the future as a way to modify surfaces for vascular tissue engineering.

Actins↗

Effect of functionalization of multilayered polyelectrolyte films on motoneuron growth.

We studied in vitro cell-substrate interaction of motoneurons with functionalized polylectrolyte films. Thin polylectrolyte films were built on glass by alternating polycations, poly(ethylene-imine) PEI, poly(L-lysine) PLL, or poly(allylamine hydrochloride) PAH, and polyanions, poly(sodium-4-styrenesulfonate) PSS or poly(L-glutamic acid) (PGA). These architectures were functionalized with Brain Derived Neurotrophic Factor (BDNF) or Semaphorin 3A (Sema3A). We used Optical Waveguide Lightmode Spectroscopy (OWLS) and Atomic Force Microscopy (AFM) to characterize the architectures. The viability of motoneurons was estimated by the acid phosphatase method, and morphometrical measures were performed to analyse the influence of different architectures on cell morphology. Motoneurons appeared to adhere and spread on all the architectures tested and preferentially on PSS ending films. The viability of motoneurons on polyelectrolyte multilayers was higher compared to polyelectrolyte monolayers. BDNF and Sema3A embedded in the films remained active and thereby create functionalized nanofilms.

Animals↗

Polyelectrolyte multilayers functionalized by a synthetic analogue of an anti-inflammatory peptide, alpha-MSH, for coating a tracheal prosthesis.

Polyelectrolyte multilayer films made of poly (L-lysine) (PLL) and poly (L-glutamic acid) (PGA) have been functionalized by covalent binding of a synthetic analogue of the anti-inflammatory peptide, alpha-melanocyte-stimulating hormone (alpha-MSH) to PGA to create biologically active coatings for tracheal prostheses. The morphology and in vivo stability of the films were investigated by atomic force microscopy and confocal laser scanning microscopy, respectively. For the in vivo evaluation, 87 rats were implanted and examined for a period superior to 3 months. Histological analysis, performed 1 month after implantation, showed a fibroblast colonization of the periprosthetic side and a respiratory epithelium type on the endoluminal side of the implant for all the polyelectrolyte coatings tested. However, for prostheses modified by PGA ending multilayer films, a more regular and less obstructive cell layer was observed on the endoluminal side compared to those modified by PLL ending films. Systemic anti-inflammatory IL-10 production was only detected in rats implanted with prostheses functionalized by alpha-MSH, demonstrating, in vivo, the anti-inflammatory activity of the embedded peptide into multilayer architectures.

Animals↗

Natural polyelectrolyte films based on layer-by layer deposition of collagen and hyaluronic acid.

The aim of the present work was to assemble extracellular matrix components into polyelectrolyte multilayers using the layer-by-layer deposition method. The films are constructed with type-I collagen and hyaluronic acid. The construction exhibits the general features observed during polyelectrolyte multilayer buildup: alternate positive and negative values of the zeta potential of the film during its construction and regular increase of the film thickness with the number, n, of deposition step. This increase is shown to be linear with n. As expected for a linearly growing film, the confocal microscopy shows that when the film is brought in contact with a collagen solution, collagen does not diffuse into the film but interacts only with its outer layer. However, the films are not constituted of homogeneously distributed polyanion/polycation complexes as it is usually observed, but they are formed of fibers as imaged by AFM. The typical width of these fibers increases with the number of deposition steps. Finally, it is found that chondrosarcoma cells spread well and synthesize extracellular matrix components only on the collagen ending films, whereas no cellular matrix was found for HA ending ones. Such architectures may be further functionalized by inclusion of active drugs, peptides, proteins..., and could be used as tunable biomaterial interfaces.

Biocompatible Materials↗

Layer by layer self-assembled polyelectrolyte multilayers with embedded phospholipid vesicles.

We describe a method to embed phospholipid vesicles into polyelectrolyte multilayers built up by the alternate deposition of polyanions and polycations. Before deposition, the vesicles are rigidified by polycation adsorption onto their surface avoiding their fusion once deposited on the multilayer surface. The vesicles adsorb to form a compact and "hard" monolayer as imaged by atomic force microscopy. The thickness of the adsorbed vesicle layer, of the order of 250 nm, is very close to the diameter of the vesicles in solution. This work should open the route to the buildup of multilayer films containing phospholipid vesicles that could act as "reservoirs" for drugs or enzymatic nanoreactors.

Adsorption↗

3-D surface charges modulate protrusive and contractile contacts of chondrosarcoma cells.

Up to now, most of the studies addressing the critical roles played by protrusive and contractile cell-matrix contacts in cell adhesion, guidance, migration, matrix assembly, and activation of signaling molecules have been performed on two-dimensional surfaces. Here, we analysed the organization of chondrosarcoma cell contacts in a new three-dimensional environment made of titanium beads. Surface charges were modified by deposition of polyelectrolyte multilayer films built up by alternated polycations poly-(L-lysine) or poly(allylamine hydrochloride) and polyanions poly-(L-glutamic acid) or poly(sodium 4-styrenesulfonate). Negatively charged 3-D titanium surfaces amplified the occurrence and length of cell protrusions. These protrusions had pseudopod characteristics extended to 200 microm in length, growing off the substratum to distant beads. Pseudopod formation is inhibited by the exocytosis inhibitor concanamycin A and is triggered by a secreted factor. Chondrosarcoma cells adhering on uncoated or on negatively charged surfaces contained discrete focal spots of vinculin and actin cables. In cells plated onto these surfaces, phosphorylation of p44/42 MAPK/ERK was twofold increased. In contrast, no cytoskeletal vinculin and actin organization was observed when the surface was positively charged. These data suggest that chondrosarcoma cells adapt a more stable adhesion on uncoated or negatively charged surfaces. This point may be critical in tissue engineering strategies designed for cartilage repair.

Actins↗

Biomaterials in laryngotracheal surgery: a solvable problem in the near future?

Clinical success of laryngotracheal protheses are constrained by a combination of biocompatible response in the host and a suitable functional rehabilitation. This review considers clinical limits of different materials commonly used in ear, nose and throat surgery and will more particularly focus on titanium, one material recognized to be well tolerated in implantology.

Bacterial Adhesion↗

Viability, adhesion, and bone phenotype of osteoblast-like cells on polyelectrolyte multilayer films.

The aim of this study was to develop new biocompatible coatings for bone implants by the alternating deposition of oppositely charged polyelectrolytes. Polyelectrolyte films were built up with different terminating layers on which SaOS-2 osteoblast-like cells and human periodontal ligament (PDL) cells were grown. The terminating layer was made of one of the following polyelectrolytes: poly(ethylene imine) (PEI), poly(sodium 4-styrenesulfonate) (PSS), poly(allylamine hydrochloride) (PAH), poly(L-glutamic acid) (PGA), or poly(L-lysine) (PLL). Cell adherence, viability, stability of osteoblast phenotype, and inflammatory response were studied. Adherence and viability were good on all terminating layers except the PEI-terminating layer, which was cytotoxic. Maintenance of osteoblast phenotype marker expression was observed on PSS- and PGA-terminating films for both cell types, whereas downregulation, associated with the induction of Interleukin-8 (IL-8) secretion, was detected on PEI and PAH for both cell types and on PLL for PDL cells. These results suggested a good biocompatibility of PSS- and PGA-ending films for PDL cells and of PSS-, PGA-, and PLL-terminating films for SaOS-2 cells. As a result, polyelectrolyte multilayer films could emerge as new alternatives for implant coatings.

Alkaline Phosphatase↗

Survival analysis of rats implanted with porous titanium tracheal prosthesis.

BACKGROUND: Surgical treatment of a malignancy in the trachea may lead to a long resection that has to be reconstructed with an artificial prosthesis. However, most of the available prostheses encounter inflammatory rejection and mechanical constraint problems. To improve tracheal rehabilitation a porous titanium prosthesis was developed. The aim of this study was to test the biocompatibility of this novel material. METHODS: Seventeen rats had a partial tracheal prosthesis made of porous titanium inserted in the cervical trachea. The histologic analysis of the tissue surrounding the prosthesis was performed in 11 surviving animals after a period of 15 to 41 days. RESULTS: Fibroblast colonization of titanium pores and a ciliary cylindrical epithelial layer developed on the endoluminal side of the prosthesis and the inflammatory reaction was minimal. CONCLUSIONS: The results of this short-term study validate, from surgical and histologic standpoints, the usefulness of a porous titanium tracheal prosthesis.

Animals↗

Polyelectrolyte multilayer films modulate cytoskeletal organization in chondrosarcoma cells.

The aim of this study was to evaluate polyelectrolyte multilayer films as interfaces for implants. Polyelectrolyte multilayers were built up with different terminating layers by alternate deposition of oppositely charged polyelectrolytes on which chondrosarcoma (HCS-2/8) cells were grown in the presence of serum. Films formed by an increasing number of layers were investigated. The terminating layer was made of one of the following polyelectrolytes: poly-sodium-4-styrenesulfonate (PSS), poly-L-glutamic acid (PGA), poly-allylamine hydrochloride (PAH), or poly(L-lysine) (PLL). Cell viability, inflammatory response, adherence, and cytoskeletal organization were studied. Induction of interleukin-8 (IL-8) secretion was detected on PAH and PLL ending polyelectrolyte films. Early cellular adherence was enhanced with PGA, PAH, PLL, and, to a lower extent, PSS terminating layers. Adherence was independent of the number of layers constituting the films. The presence of actin filaments and vinculin focal adhesion spots was observed on PSS or PAH ending films. They were respectively partially and totally absent on PGA and PLL terminating multilayer architectures. For PLL ending films, vinculin and actin organization was clearly dependent on the number of deposited layers. The results of this study suggest that PSS ending multilayered films constitute a good interfacial micro-environment at the material surface for HCS-2/8 cells.

Actins↗