Biomedical subjects

Douglas M Mackay

Publications and source records attributed to Douglas M Mackay.

4 recordsLinked to original sources

PubMed2006

Impact of ethanol on the natural attenuation of benzene, toluene, and o-xylene in a normally sulfate-reducing aquifer.

Side-by-side experiments were conducted in a sulfate-reducing aquifer at a former fuel station to evaluate the effect of ethanol on biodegradation of other gasoline constituents. On one side, for approximately 9 months we injected groundwater amended with 1-3 mg/L benzene, toluene, and o-xylene (BToX). On the other side, we injected the same, adding approximately 500 mg/L ethanol. Initially the BToX plumes on both sides ("lanes") extended approximately the same distance. Thereafter, the plumes in the "No Ethanol Lane" retracted significantly, which we hypothesize to be due to an initial acclimation period followed by improvement in efficiency of biodegradation under sulfate-reducing conditions. In the "With Ethanol Lane", the BToX plumes also retracted, but more slowly and not as far. The preferential biodegradation of ethanol depleted dissolved sulfate, leading to methanogenic/acetogenic conditions. We hypothesize that BToX in the ethanol-impacted lane were biodegraded in part within the methanogenic/acetogenic zone and, in part, within sulfate-reducing zones developing along the plume fringes due to mixing with sulfate-containing groundwater surrounding the plumes due to dispersion and/or shifts in flow direction. Overall, this research confirms that ethanol may reduce rates of biodegradation of aromatic fuel components in the subsurface, in both transient and near steady-state conditions.

Benzene↗

PubMed2004

Challenges in monitoring the natural attenuation of spatially variable plumes.

Monitored natural attenuation may be applied as a risk-based remediation strategy if it can be established that contaminants are or will be reduced to some acceptable level at or before a compliance point. Contaminant attenuation is often attributed to intrinsic biodegradation, which in some circumstances may occur only at the plume fringes where electron acceptors from the surrounding uncontaminated zones mix by dispersion and diffusion with the plume. However, due to the common spatial and temporal variability exhibited by many plumes, the centreline monitoring approaches advocated in many natural attenuation protocols may be unable to detect natural attenuation occurring primarily by fringe processes. Snapshot data from a multilevel sampling well transect across an MTBE plume at Vandenberg Air Force Base, CA, USA, illustrate the difficulty of centreline monitoring and the challenge of providing sufficient detail to detect attenuation processes that may be occurring primarily at plume fringes. In a study of a phenols plume in Wolverhampton, UK, high-resolution multilevel wells demonstrated that the key biodegradation processes were restricted spatially to the upper fringe of the plume and were rate-limited by transverse dispersion and diffusion of electron acceptors into the plume. Thus the overall extent of biodegradation was considerably less than suggested by a plume-scale analysis of total electron acceptor and contaminant budgets. These examples indicate that more robust and cost-effective MNA assessments can be obtained using monitoring strategies that focus on the location of key biodegradation processes.

Aerobiosis↗

PubMed2002

Carbon and hydrogen isotopic fractionation during biodegradation of methyl tert-butyl ether.

Carbon and hydrogen isotopic fractionation during aerobic biodegradation of MTBE by a bacterial pure culture (PM1) and a mixed consortia from Vandenberg Air Force Base (VAFB) were studied in order to assess the relative merits of stable carbon versus hydrogen isotopic analysis as an indicator of biodegradation. Carbon isotopic enrichment in residual MTBE of up to 8.1/1000 was observed at 99.7% biodegradation. Carbon fractionation was reproducible in the PM1 and VAFB experiments, yielding similar enrichment factors (epsilon) of -2.0/1000 +/- 0.1/1000 to -2.4/1000 +/- 0.3/1000 for replicates in the PM1 experiment and -1.5/1000 +/- 0.1/1000 to -1.8/1000 +/- 0.1/1000 for replicates in the VAFB experiment. Hydrogen isotopic fractionation was highly reproducible for the PM1 pure cultures, with epsilon values of -33/1000 +/- 5/1000 to -37/1000 +/- 4/1000 for replicate samples. In the VAFB microcosms, there was considerably more variability in epsilon values, with values of -29/1000 +/- 4/1000 and -66/1000 +/- 3/1000 measured for duplicate sample bottles. Despite this variability, hydrogen isotopic fractionation always resulted in 2H enrichment of the residual MTBE of >80/1000 at 90% biodegradation. The reproducible carbon fractionation suggests that compound-specific carbon isotope analysis may be used to estimate the extent of biodegradation at contaminated sites. Conversely, the large hydrogen isotopic fractionation documented during biodegradation of MTBE suggests that compound-specific hydrogen isotope analysis offers the most conclusive means of identifying in-situ biodegradation at contaminated sites.

Bacteria↗

PubMed2002

In situ MTBE biodegradation supported by diffusive oxygen release.

Microcosm studies with sediments from Vandenberg Air Force Base, CA, suggest that native aerobic methyl tert-butyl ether (MTBE)-degrading microorganisms can be stimulated to degrade MTBE. In a series of field experiments, dissolved oxygen has been released into the anaerobic MTBE plume by diffusion through the walls of oxygen-pressurized polymeric tubing placed in contact with the flowing groundwater. MTBE concentrations were decreased from several hundred to less than 10 microg/L during passage through the induced aerobic zone, due apparently to in situ biodegradation: abiotic MTBE loss mechanisms were insignificant. Lag time for initiation of degradation was less than 2 months, and the apparent pseudo-first-order degradation rate was 5.3 day(-1). Additional MTBE was added in steps to raise the influent concentration to a maximum of 2.1 mg/L. With each step, MTBE was degraded within the preestablished aerobic treatment zone at rates ranging from 4.4 to 8.6 day(-1). Excess dissolved oxygen suggested that even higher MTBE concentrations could have been treated. Continued flow through the treatment zone was repeatedly confirmed through tracer and other tests. These and others' results suggest that it is possible to create permeable in situ treatment zones solely by releasing oxygen to support native microbial degradation of MTBE.

Bacteria, Anaerobic↗