PubMed Health⌕ Search

Biomedical subjects

E D Sloan

Publications and source records attributed to E D Sloan.

2 recordsLinked to original sources
PubMed2006

Molecular hydrogen storage in binary THF-H2 clathrate hydrates.

The hydrogen storage capacity of binary THF-H(2) clathrate hydrate has been determined as a function of formation pressure, THF composition, and time. The amount of hydrogen stored in the stoichiometric hydrate increases with pressure and exhibits asymptotic (Langmuir) behavior to approximately 1.0 wt % H(2). This hydrogen concentration corresponds to one hydrogen molecule occupying each of the small 5(12) cavities and one THF molecule in each large 5(12)6(4) cavity in the hydrate framework. Contrary to previous reports, hydrogen storage was not increased upon decreasing the THF concentration below the stoichiometric 5.6 mol % solution to 0.5 mol %, at constant pressure, even after one week. This provides strong evidence that THF preferentially occupies the large 5(12)6(4) cavity over hydrogen, for the range of experimental conditions tested. The maximum amount of hydrogen stored in this binary hydrate was about 1.0 wt % at moderate pressure (<60 MPa) and is independent of the initial THF concentration over the range of conditions tested.

Journal Article↗
PubMed2006

Composite thermal conductivity in a large heterogeneous porous methane hydrate sample.

By employing inverse modeling to analyze the laboratory data, we determined the composite thermal conductivity (k(theta), W/m/K) of a porous methane hydrate sample ranged between 0.25 and 0.58 W/m/K as a function of density. The calculated composite thermal diffusivities of porous hydrate sample ranged between 2.59 x 10(-7) m(2)/s and 3.71 x 10(-7) m(2)/s. The laboratory study involved a large heterogeneous sample (composed of hydrate, water, and methane gas). The measurements were conducted isobarically at 4.98 MPa over a temperature range of 277.3-279.1 K. Pressure and temperature were monitored at multiple locations in the sample. X-ray computed tomography (CT) was used to visualize and quantify the density changes that occurred during hydrate formation from granular ice. CT images showed that methane hydrate formed from granular ice was heterogeneous and provided an estimate of the sample density variation in the radial direction. This facilitated quantifying the density effect on composite thermal conductivity. This study showed that the sample heterogeneity should be considered in thermal conductivity measurements of hydrate systems. Mixing models (i.e., arithmetic, harmonic, geometric mean, and square root models) were compared to the estimated composite thermal conductivity determined by inverse modeling. The results of the arithmetic mean model showed the best agreement with the estimated composite thermal conductivity.

Journal Article↗