Biomedical subjects

E Dendy Sloan

Publications and source records attributed to E Dendy Sloan.

7 recordsLinked to original sources

PubMed2006

Micromechanical adhesion force measurements between tetrahydrofuran hydrate particles.

Adhesion forces between tetrahydrofuran (THF) hydrate particles in n-decane were measured using an improved micromechanical technique. The experiments were performed at atmospheric pressure over the temperature range 261-275 K. The observed forces and trends were explained by a capillary bridge between the particles. The adhesion force of hydrates was directly proportional to the contact force and contact time. A scoping study examined the effects of temperature, anti-agglomerants, and interfacial energy on the particle adhesion forces. The adhesion force of hydrates was found to be directly proportional to interfacial energy of the surrounding liquid, and to increase with temperature. Both sorbitan monolaurate (Span20) and poly-N-vinyl caprolactam (PVCap) decreased the adhesion force between the hydrate particles.

Journal Article↗

PubMed2006

Molecular hydrogen occupancy in binary THF-H2 clathrate hydrates by high resolution neutron diffraction.

We have determined the time-space average filling of hydrogen molecules in a binary tetrahydrofuran (THF)-d(8) + D(2) sII clathrate hydrate using high resolution neutron diffraction. The filling of hydrogen in the lattice of a THF-d(8) clathrate hydrate occurred upon pressurization. The hydrogen molecules were localized in the small dodecahedral cavities at 20 K, with nuclear density from the hydrogen approximately spherically distributed and centered in the small cavity. With a formation pressure of 70 MPa, molecular hydrogen was found to only singly occupy the sII small cavity. This result helps explain discrepancies about the hydrogen occupancy in the THF binary hydrate system.

Furans↗

PubMed2006

Phase transitions in mixed gas hydrates: experimental observations versus calculated data.

This paper presents the phase behavior of multicomponent gas hydrate systems formed from primarily methane with small amounts of ethane and propane. Experimental conditions were typically in a pressure range between 1 and 6 MPa, and the temperature range was between 260 and 290 K. These multicomponent systems have been investigated using a variety of techniques including microscopic observations, Raman spectroscopy, and X-ray diffraction. These techniques, used in combination, allowed for measurement of the hydrate structure and composition, while observing the morphology of the hydrate crystals measured. The hydrate formed immediately below the three-phase line (V-L --> V-L-H) and contained crystals that were both light and dark in appearance. The light crystals, which visually were a single solid phase, showed a spectroscopic indication for the presence of occluded free gas in the hydrate. In contrast, the dark crystals were measured to be structure II (sII) without the presence of these occluded phases. Along with hydrate measurements near the decomposition line, an unexpected transformation process was visually observed at P-T-conditions in the stability field of the hydrates. Larger crystallites transformed into a foamy solid upon cooling over this transition line (between 5 and 10 K below the decomposition temperature). Below the transition line, a mixture of sI and sII was detected. This is the first time that these multicomponent systems have been investigated at these pressure and temperature conditions using both visual and spectroscopic techniques. These techniques enabled us to observe and measure the unexpected transformation process showing coexistence of different gas hydrate phases.

Gases↗

PubMed2006

Direct measure of the hydration number of aqueous methane.

A hydration number of 20 has been measured for aqueous CH4 in the temperature range 273-298 K on the basis of the simultaneous observation of the 13C isotropic resonance lines of CH4 in both aqueous solution and the dodecahedral cage of CH4 structure I hydrate. Additional experimental evidence and analysis reported in this paper suggest that the dominant aqueous hydration number of methane is 20.

Journal Article↗

PubMed2004

Stable low-pressure hydrogen clusters stored in a binary clathrate hydrate.

Thermodynamic, x-ray diffraction, and Raman and nuclear magnetic resonance spectroscopy measurements show that clusters of H2 can be stabilized and stored at low pressures in a sII binary clathrate hydrate. Clusters of H2 molecules occupy small water cages, whereas large water cages are singly occupied by tetrahydrofuran. The presence of this second guest component stabilizes the clathrate at pressures of 5 megapascals at 279.6 kelvin, versus 300 megapascals at 280 kelvin for pure H2 hydrate.

Journal Article↗

PubMed2004

Temperature dependence of particle-particle adherence forces in ice and clathrate hydrates.

Particle-particle pulloff adherence forces were measured as a function of temperature in the ice/n-decane/ice and tetrahydrofuran (THF) hydrate/n-decane/THF hydrate systems using a newly developed micromechanical testing technique. Experiments using approximately 200 microm radius particles were performed at atmospheric pressure over the temperature range 263-275 K. The ice and hydrate particles displayed very similar behavior. While the measured adherence forces had significant variation, the shapes of the cumulative force distribution curves were similar among the different sets of experiments. The measured adherence forces distributions shifted to lower force values as the temperature was decreased from the solid melting temperature. The observed forces and trends were explained by the capillary cohesion of rough surfaces, with the capillary bridging liquid being stabilized below its freezing point by the negative curvature of the bridging liquid/n-decane interface.

Alkanes↗

PubMed2003

Fundamental principles and applications of natural gas hydrates.

Natural gas hydrates are solid, non-stoichiometric compounds of small gas molecules and water. They form when the constituents come into contact at low temperature and high pressure. The physical properties of these compounds, most notably that they are non-flowing crystalline solids that are denser than typical fluid hydrocarbons and that the gas molecules they contain are effectively compressed, give rise to numerous applications in the broad areas of energy and climate effects. In particular, they have an important bearing on flow assurance and safety issues in oil and gas pipelines, they offer a largely unexploited means of energy recovery and transportation, and they could play a significant role in past and future climate change.

Evolution, Chemical↗