PubMed Health⌕ Search

Biomedical subjects

E J Morton

Publications and source records attributed to E J Morton.

14 recordsLinked to original sources
PubMed2003

An X-ray micro-tomography system optimised for the low-dose study of living organisms.

An X-ray micro-tomography system has been designed that is dedicated to the low-dose imaging of radiation sensitive living organisms and has been used to image the early development of the first few days of plant development immediately after germination. The system is based on third-generation X-ray micro-tomography system and consists of an X-ray tube, two-dimensional X-ray detector and a mechanical sample manipulation stage. The X-ray source is a 50kVp X-ray tube with a silver target with a filter to centre the X-ray spectrum on 22keV.A 100mm diameter X-ray image intensifier (XRII) is used to collect the two-dimensional projection images. The rotation tomography table incorporates a linear translation mechanism to eliminate ring artefact that is commonly associated with third-generation tomography systems. Developing maize seeds (Triticum aestivum) have been imaged using the system with a cubic voxel linear dimension of 100 microm, over a diameter of 25mm and the root lengths and volumes measured. The X-ray dose to the plants was also assessed and found to have no effect on the plant root development.

Equipment Design↗
PubMed2001

Enhancing the ratio of fluorescence to bremsstrahlung radiation in X-ray tube spectra.

This paper describes techniques that can be used to improve the ratio of fluorescence to bremsstrahlung radiation (F/B) in X-ray tube spectra. Firstly, an extension of the EGS4 code system is used to evaluate the impact of the substrate in thin target applications, in terms of the yield of bremsstrahlung photons produced. The choice of materials to filter X-ray tube spectra, and its effect in the F/B and the tube efficiency is discussed. The characteristics of spectra produced in transmission tubes with different target thicknesses, substrates and tube voltages are also presented.

Journal Article↗
PubMed2001

Radiation protection in interventional radiology.

There is growing concern regarding the radiation dose delivered during interventional procedures, particularly in view of the increasing frequency and complexity of these techniques. This paper reviews the radiation dose levels currently encountered in interventional procedures, the consequent risks to operators and patients and the dose reduction that may be achieved by employing a rigorous approach to radiation protection.

Fluoroscopy↗
PubMed2001

A CCD-based optical CT scanner for high-resolution 3D imaging of radiation dose distributions: equipment specifications, optical simulations and preliminary results.

Methods based on magnetic resonance imaging for the measurement of three-dimensional distributions of radiation dose are highly developed. However, relatively little work has been done on optical computed tomography (OCT). This paper describes a new OCT scanner based on a broad beam light source and a two-dimensional charge-coupled device (CCD) detector. A number of key design features are discussed including the light source; the scanning tank, turntable and stepper motor control; the diffuser screen onto which images are projected and the detector. It is shown that the non-uniform pixel sensitivity of the low-cost CCD detector used and the granularity of the diffuser screen lead to a serious ring artefact in the reconstructed images. Methods are described for eliminating this. The problems arising from reflection and refraction at the walls of the gel container are explained. Optical ray-tracing simulations are presented for cylindrical containers with a variety of radii and verified experimentally. Small changes in the model parameters lead to large variations in the signal intensity observed in the projection data. The effect of imperfect containers on data quality is discussed and a method based on a 'correction scan' is shown to be successful in correcting many of the related image artefacts. The results of two tomography experiments are presented. In the first experiment, a radiochromic Fricke gel sample was exposed four times in different positions to a 100 kVp x-ray beam perpendicular to the plane of imaging. Images of absorbed dose with slice thickness of 140 microm were acquired. with 'true' in-plane resolution of 560 x 560 microm2 at the edge of the 72 mm field of view and correspondingly higher resolution at the centre. The nominal doses measured correlated well with the known exposure times. The second experiment demonstrated the well known phenomenon of diffusion in the dosemeter gels and yielded a value of (0.12 +/- 0.02) mm2 s(-1) for the diffusion coefficient of the xylenol orange/iron complex. Finally, the overall implications of the above findings for dosimetry using OCT are discussed.

Dose-Response Relationship, Radiation↗
PubMed1992

A megavoltage CT scanner for radiotherapy verification.

We have further developed a system for generating megavoltage CT images immediately prior to the administration of external beam radiotherapy. The detector is based on the scanner of Simpson (Simpson et al 1982)--the major differences being a significant reduction in dose required for image formation, faster image formation and greater convenience of use in the clinical setting. Attention has been paid to the problem of ring artefacts in the images. Specifically, a Fourier-space filter has been applied to the sinogram data. After suitable detector calibration, it has been shown that the device operates close to its theoretical specification of 3 mm spatial resolution and a few percent contrast resolution. Ring artefacts continue to be a major source of image degradation. A number of clinical images have been presented. The next stage of this work is to use the system to make clinical measurements of patient set-up inaccuracies building on our work making such measurements from digital portal images (Evans et al 1992).

Evaluation Studies as Topic↗
PubMed1992

Image comparison techniques for use with megavoltage imaging systems.

In this paper we describe software facilities for enabling patient positioning studies using the megavoltage imaging system developed at the Royal Marsden Hospital and Institute of Cancer Research. The study focuses on the use of the system for three purposes: patient position verification (by comparing images taken at treatment simulation with megavoltage images taken at treatment time); reproducibility studies (by analysing a set of megavoltage images); and set-up correction (by adjusting the set-up until the megavoltage image obtained at treatment registers with the simulation image). The need is discussed for suitably presented simulator images, a method of determining field boundaries and the possibility of delineating soft-tissue interfaces. Several algorithms of different types, developed specifically for the purpose of intercomparison of planar projection images, are presented. The techniques employed and their usefulness, in both the qualitative and the quantitative sense, are discussed. The results are presented of a phantom and clinical study, to evaluate the rigour and reproducibility of the algorithms. These results indicate that measurements can be made to an accuracy of about 1-2 mm, with a similar value for interobserver reproducibility for the best image comparison techniques available.

Algorithms↗
PubMed1990

Three-dimensional x-ray microtomography for medical and biological applications.

Three-dimensional (3D) x-ray microtomography is a technique for obtaining the 3D distribution of x-ray attenuation coefficients within small objects. To obtain microtomographic images apparatus has been developed which consists of a microfocal x-ray source, a computer-controlled stage for rotating the object, a 2D multi-wire gas proportional x-ray counter and a microcomputer to control image acquisition. Projection data were generated by rotating the object to discrete orientations around a single axis until of the order of 100 2D projection images of the object were collected. The projection images were transferred to a VAX 11/750 computer for subsequent 3D reconstruction using a convolution and back-projection algorithm in cone-beam geometry. The reconstructed data, comprising cubic voxels, may be displayed as sets of sequential transaxial, sagittal and coronal planes through the object. Alternatively, perspective displays of individual orthogonal sections may be formed with either intersecting planes or with these planes projected onto the surfaces of a box-like structure. The technique provides for the investigation of small-scale structures in biological specimens and we show some illustrative images of dead insects.

Animals↗
PubMedDate not supplied

A linear array, scintillation crystal-photodiode detector for megavoltage imaging.

An imaging device has been developed to acquire images during external photon-beam radiotherapy treatments. It consists of a linear array of 128 zinc tungstate (ZnWO4) scintillation crystals each of which is individually optically coupled to a photodiode and associated electronics. The image is formed by scanning the linear array across the radiation field using a stepping motor under the control of a microcomputer. Image archive, display, and analysis are performed using a microVAX II computer. Results from a general theoretical analysis are presented before a detailed description of the particular detector construction. The mechanical design of the detector is such that the detector is automatically positioned to within a millimeter relative to the treatment source. This simplifies procedures for analyzing setup variations when comparing a treatment image to any other treatment, or planning, images. Image acquisition takes under 4 s with a contrast resolution of better than 1% at a spatial resolution of 2.5 mm in the object plane. The primary dose used to form these images is 0.55 cGy although the dose received by the patient will be closer to 25 cGy due to the linear scanning geometry and 3.8-s scan time that is used.

Humans↗
PubMedDate not supplied

The design of megavoltage projection imaging systems: some theoretical aspects.

This study investigates factors associated with the imaging of a patient using a high-energy radiotherapy treatment beam. Both single-stage (e.g., solid-state detector) and two-stage (e.g., scintillation screen plus TV) systems are considered. First an expression is derived that relates dose at the buildup depth in the object to the structure of the object, the scatter-to-primary signal-variance ratio and the differential-signal-to-noise ratio in the image. Second the number of bits required to digitize the image is derived. Third the effect of scattered radiation is investigated for photon counting, photopeak, and Compton detector types. Fourth the effect of noise in the detection process is considered. Finally, the relationship between x-ray source size, detector aperture, and image magnification is derived. The optimum magnification for given source size and detector aperture is discussed in terms of the system transfer function. The study indicates that at a primary beam energy of 2 MeV, a dose of 10(-3) cGy is required to detect reliably the presence of a bone section of area 10 x 10 mm and thickness 4 mm in 250 mm of soft tissue. For this example, it is also estimated that a digitization accuracy of 10 bits is required. The calculations indicate that for a Compton detector, the scatter-to-primary signal-variance ratio drops from a value of around 30% at the exit surface of the object to 5% at a distance of 80 cm from the object with a consequent small reduction in the dose required to form the image.

Equipment Design↗
PubMedDate not supplied

Demonstration of megavoltage and diagnostic x-ray imaging with hydrogenated amorphous silicon arrays.

Flat-panel imagers consisting of the first large area, self-scanning, pixelated, solid-state arrays made with hydrogenated amorphous silicon (a-Si:H) are under development by the authors for applications in diagnostic x-ray and megavoltage radiotherapy imaging. The arrays, designated by the acronym MASDA for multi-element amorphous silicon detector array, consist of a two-dimensional array of a-Si:H photodiodes and thin-film transistors and are used in conjunction with scintillating materials. Imagers utilizing MASDA arrays offer a variety of advantages over existing technologies. This article presents initial megavoltage and diagnostic-quality x-ray images taken with several such arrays including the first examples of anatomical-phantom images. The external readout electronics and imaging techniques required to obtain such images are outlined, the construction, operation, and advantages of the arrays briefly reviewed, and the future potential of this new technology discussed.

Diagnostic Imaging↗
PubMedDate not supplied

A dose distribution evaluation utilizing megavoltage CT imaging system.

An isodose distribution (collision kinetic energy distribution) was acquired using a megavoltage CT imaging system. Direct comparison of dose distributions has become important for verification in innovative treatment techniques. Three-dimensional implementation of this system is considered highly feasible.

Humans↗